Scribd
Upload
48 views2 pages

Q:1 A) (11.drilling) : Write The Advantage of Turning Center Over The Conventional Machine.

The document provides information about drilling two holes simultaneously using a two-spindle drill. It asks the reader to determine the maximum feed rate that can be used without exceeding the total metal removal rate, the individual feed rates for each hole given their diameters, and the time required to drill the holes. It also provides definitions for various machining terms and asks the reader to explain up-milling and down-milling operations and the advantages of a turning center.

Uploaded by

Misbah Niamat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
48 views2 pages

Q:1 A) (11.drilling) : Write The Advantage of Turning Center Over The Conventional Machine.

The document provides information about drilling two holes simultaneously using a two-spindle drill. It asks the reader to determine the maximum feed rate that can be used without exceeding the total metal removal rate, the individual feed rates for each hole given their diameters, and the time required to drill the holes. It also provides definitions for various machining terms and asks the reader to explain up-milling and down-milling operations and the advantages of a turning center.

Uploaded by

Misbah Niamat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Q:1

A) (11.Drilling) A two-spindle drill simultaneously drills a 1/2 in hole and a 3/4 in hole
through a workpiece that is 1.0 in thick. Both drills are twist drills with point angles of
138. Cutting speed for the material is 330 ft/min. The rotational speed of each spindle
can be set individually. The feed rate for both holes must be set to the same value because
the two spindles lower at the same rate. The feed rate is set so the total metal removal rate
does not exceed 1.30 in3/min. Determine (a) the maximum feed rate (in/min) that can be
used, (b) the individual feeds (in/rev) that result for each hole, and (c) the time required to
drill the holes.
(7)
B) Label the diagram
(3)

Draw cutting model of face milling when cutter is centered over the workpiece. (2)
Explain up-milling and down-milling operation. (4)

Write the advantage of turning center over the conventional


machine. (4)

Define (10)
Circular saw
Tracer Mill
Taper Turning
Countersinking
Disadvantage of machining (write name of two main)

You might also like