Charging Electric Static

Lesson 8: Charging by Friction, Induction, & Conduction
Charging by Friction
Up to this point we have really only discussed the oldest way to give an object a charge.
Rubbing two different materials together, a process known as charging by friction (AKA
charging by rubbing), is the simplest way to give something a charge.
This is what you do every time you drag your feet along a carpet so you can reach out and
zap someone's ear.
Your feet in socks and the carpet are doing charging by friction.
Since the two objects are made of different materials, their atoms will hold onto their electrons
with different strengths.
As they pass over each other the electrons with weaker bonds are ripped off one material and
collect on the other material.
Example 1: Rub a piece of ebonite (very hard, black rubber) across a piece of animal fur. Explain
what happens.
The fur does not hold on to its electrons as strongly as the ebonite. At least some of the
electrons will be ripped off of the fur and stay on the ebonite. Now the fur has a slightly
positive charge (it lost some electrons) and the ebonite is slightly negative (it gained some
electrons).The net charge is still zero between the two remember the conservation of charge.
No charges have been created or destroyed, just moved around.
Example 2: Rub a glass rod with a piece of silk. Explain what
happens.
This is the same sort of situation as the one above. In this case
the silk holds onto the electrons more strongly than the glass.
Electrons are ripped off of the glass and go on to the silk. The
glass is now positive and the silk is negative.
You are expected to remember

the combinations of ebonite-fur
and glass-silk. They are often
used as examples in questions.
You may be wondering how you could

sulphur
ever keep track of this, since the
brass
combinations of different materials
copper
being rubbed on each other is infinite.
Increasing
Increasing
ebonite
Rather than try to keep track of
tendency to hold
all the combinations, we arrange tendency to
paraffin wax
on to electrons
lose
electrons
common materials in a chart
silk
called an Electrostatic Series.
lead
To use the electrostatic series,
fur
you first need to find the two
wool
different materials that are being
glass
rubbed.
Whichever material is closer Illustration 1: Electrostatic Series
to the top is holding
electrons tightly so it will have a negative charge.
The material closer to the bottom has a greater chance of losing electrons, so it will be
positively charged.
7/4/2013
studyphysics.ca
Page 1 of 4 / Section 10.1
Example 3: Determine the charge on a piece of copper if you rub it with a piece of silk.
Looking at the electrostatic series, copper is closer to the top with silk beneath it. This means
that the copper is negative and the silk is positive.
Charging by Conduction
If the two objects are brought

close enough that an arc of
electricity jumps between them, it
counts as conduction.
Conduction just means that the two objects will come into actual
physical contact with each other (this is why it is sometimes called
charging by contact).
Let's assume we have a negatively charged metal object and an uncharged metal object
(Illustration 2a). They are similar objects, and each is on an insulating stand so that we can
move them around without them interacting with anything else.
We bring the two objects close together. We will see a separation of charge happen in the
neutral object as negative electrons are repelled to the right hand side (Illustration 2b).
At this time, they are not touching and no charges have been transferred.
We allow the two objects to touch (Illustration 2c).
Some of the negative charge will transfer over to the uncharged metal object. This happens
since the negative charges on the first object are repelling each other... by moving onto the
second object they spread away from each other.
When the negative object is removed, it will not be as negative as it was (Illustration 2d).
Both of the objects have some of the negative charge this depends on the size of the
objects and the materials they are made of. Since they are similar in this example they have
the same magnitude charge.
Illustration 2a:
Charged and Neutral Objects
Illustration 2c:
Conduction!
_
_
_
+
+
+
Illustration 2b:
Separation of Charge
e-
Illustration 2d:
Afterwards
Overall the total negative charge remains constant.

We started with six negative charges, and we ended up with a total of six negative.
Notice that this also means a negative object causes a negative charge on the other object.
What would happen if you used a positive rod at the start to touch the metal sphere?
The same sort of thing, except that the neutral object will transfer electrons to the positively
charged object.
7/4/2013
studyphysics.ca
In any of these cases, the results depend on the materials being conductors or insulators.
In the examples I've given so far, all the materials have been conductors, so the charges move
easily from one to the other and spread out.
If the materials used were insulators, only the specific areas that actually touched would show
any change in charge. That's because the charges can't move through the insulators easily.
Charging by Induction
It is possible to charge a conductor without touching it. You do have to follow some special procedures.
Most important is the use of a grounding wire.

A grounding wire is simply a conductor that connects the object to the ground.
Think of the earth as a huge reservoir of charge it can both gain or donate electrons as
needed. Depending on what the situation is, either electrons will travel up the grounding
wire to the object being charged, or travel down to the ground.
Charging by induction is a more complex process than conduction, as the example below shows
+
+
+
e-
+
+
+
+
+
cut
Illustration 3c:
Snip the Wire!
Illustration 3b:
Electrons escape down wire
Illustration 3a:
Neutral Object Grounded
Illustration 3d:
Afterwards
Figure 3a: The neutral object is on an insulating stand. It also has a ground wire attached to it.
Figure 3b: We bring a negative object nearby. This will cause the electrons to be pushed as far
away as possible, and since they are free to move, they do just that. They will travel down the
ground wire.
Figure 3c: This step is VERY important. Keeping the negative object nearby we snip the
ground wire. Now there is no way for the electrons to travel back up they wire to the originally
neutral object. If we had skipped this step and just moved the negative object away without
snipping the ground wire, the negative charges would have just gone back up the wire and it
would be neutral again.
Figure 3d: We remove the negative object now the the original object has a net positive
charge.
7/4/2013
studyphysics.ca
The same sort of thing happens if you bring a positively charged object near to a grounded object.
In that case, electrons would come up the grounding wire to be closer to the object. This would
leave the other object with a negative charge.
Notice that when you charge by induction you get the opposite charge on the metal object.
Electroscopes
How can you tell if an object has a charge, especially if youre doing research in
the 1700s?
Very early on physicists started using electroscopes to measure very small charges
on objects.
An electroscope is made up of a couple of very thin metal leaves that hang
down near to each other. They are connected to a metal rod that extends
upwards, and ends in a knob on the end.
The whole apparatus is usually insulated from outside effects by being in a
metal container with a mica window to look in at the leaves. A rubber
stopper insulates the rod from touching the metal container.
You can only do things to the metal ball at the top, since everything else is insulated inside the metal
can.
If you bring a charged object near the top ball, electrons will either move out of it or in to it.
This will result in changes in the charges on the metal leaves inside the
Illustration 4: An
electroscope.
electroscope
Imagine what happens to the metal leaves if a charged object is brought nearby
+
+
+
+
Illustration 5a: In this situation a negative

object is brought nearby the electroscope.
This causes free moving electrons in the
electroscope to move down into the leaves,
leaving the top positive. Since the leaves
both have negative charge they repel each
other and move apart.
Illustration 5b: Bring a positive

object nearby and the free
electrons in the electroscope all
start moving up towards the
top. This means the bottom has
a net positive charge. The
leaves will spread apart again.
Illustration 5c: Touch the

electroscope with any charged
object and youll give it an overall
charge by conduction. The leaves
will stay spread apart even if you
remove the object.
Homework
p.523 #5-10
7/4/2013
studyphysics.ca

Charging Electric Static

Uploaded by

Copyright:

Available Formats

Charging Electric Static

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Charging Electric Static

Uploaded by

Copyright:

Available Formats

Lesson 8: Charging by Friction, Induction, & Conduction

You are expected to remember

You may be wondering how you could

Page 1 of 4 / Section 10.1

If the two objects are brought

Overall the total negative charge remains constant.

Page 2 of 4 / Section 10.1

Most important is the use of a grounding wire.

Page 3 of 4 / Section 10.1

Illustration 5a: In this situation a negative

Illustration 5b: Bring a positive

Illustration 5c: Touch the

Page 4 of 4 / Section 10.1

You might also like