Tutorial 5

PHY 3104 PHYSICS II
Semester 1, 16/17
TUTORIAL 5: SOURCES OF MAGNETIC FIELD & ELECTROMAGNETIC

INDUCTION & INDUCTANCE
1.
An electron and a proton are each moving at 845 km/s in perpendicular paths as shown in
Figure 1. At the instant when they are at the positions shown in the figure, find the
magnitude and the direction of (a) the total magnetic field they produce at the origin, (b) the
magnetic field the electron produces at the location of the proton, (c) the total electrical force
and the total magnetic force that the electron exerts on the proton. ANS : (a) 1.39 x 10-3 T,
(b) 2.58 x 10-4 T , (c)5.62 x 10-12 N and 3.48 x 10-17 N
Figure 1
2.
A wire carrying a 28.0 A current bends through a right angle. Consider two 2.0 mm
segments of wire, each 3.0 cm from the bend (Figure 2). Find the magnitude and direction of
the magnetic field these two segments produce at point P, which is midway between them.
ANS : 2.88 x 10-6 T
Figure 2
3.
Two long, straight, parallel wires, 10.0 cm apart, carry equal 4.00 A currents in the same
direction, as shown in Figure 3. Find the magnitude and direction of the magnetic field at
(a) point P1, midway between the wires, (b) point P2, 25.0 cm to the right of P1, (c) point
P3, 20.0 cm directly above P1. ANS : (a) zero, (b) 6.67 x 10-6 T, (c) 7.54 T
Figure 3
PHY 3104 PHYSICS II

Semester 1, 16/17
4. Two long, parallel wires are separated by a distance of 2.50 cm. The force per unit length
that each wire exerts on the other is 4.0 x 10-5 N/m, and the wires repel each other. The
current in one wire is 0.60 A. (a) What is the current in the second wire? (b) Are the two
currents in the same direction or in opposite directions? ANS : (a) 8.33 A
5. In a physics laboratory experiment, a coil with 200 turns enclosing an area of 12 cm2 is
rotated in 0.040 s from a position where its plane perpendicular to the earths magnetic
field to a position where its plane is parallel to the field. The earths magnetic field at the
lab location is 6.0 x 10 -5 T. (a) What is the total magnetic flux through the coil before it is
rotated? After it is rotated? (b) What is the average emf induced in the coil? ANS : (a) 0,
(b) 0.36 mV
6. A circular loop of wire is in a region of spatially uniform magnetic field, as shown in
Figure 4. The magnetic field is directed into the plane of the figure. Determine the
direction (clockwise or counterclockwise) of the induced current in the loop when (a) B is
increasing; (b) B is decreasing; (c) B is constant with value Bo. Explain your reasoning.
Figure 4
7. The conducting rod ab shown in Figure 5 makes contact with metal rails ca and db. The
apparatus is in a uniform magnetic field of 0.80 T, perpendicular to the plane of the figure
(a) Find the magnitude of the emf induced in the rod when it is moving toward the right
with a speed 7.50 m/s. (b) In what direction does the current flow in the rod? (c) If the
resistance of the circuit abcd is 1.50 (assumed to be constant), find the force (magnitude
and direction) required to keep the rod moving to the right with a constant speed of 7.50
m/s. You can ignore friction. (d) Compare the rate at which mechanical work is done by
the force (Fv) with the rate at which thermal energy is developed in the circuit (I2R). ANS
: (a) 3.00 V
Figure 5
2
PHY 3104 PHYSICS II

Semester 1, 16/17
8. A metal ring 4.50 cm in diameter is placed between the north and south poles of large
magnets with the plane of its area perpendicular to the magnetic field. These magnets
produce an initial uniform field of 1.12 T between them but are gradually pulled apart,
causing this field to remain uniform but decrease steadily at 0.250 T/s. (a) What is the
magnitude of the electric field induced in the ring? (b) In which direction (clockwise or
counterclockwise) does the current flow as viewed by someone on the south pole of the
magnet? ANS : (a) 2.81 x 10-3 V/m
9. The inductor shown in Figure 6 has inductance 0.260 H and carries a current in the
direction shown. The current is changing at a constant rate. (a) The potential between
points a and b is Vab = 1.04 V, with point a at higher potential. Is the current increasing or
decreasing? (b) If the current at t = 0 is 12.0 A, what is the current at t = 2.00 s? ANS : (b)
4.0 A
Figure 6
10. A 35.0 V battery with negligible internal resistance, a 50.0 resistor, and a 1.25 mH
inductor with negligible resistance are all connected in series with an open switch. The
switch is suddenly closed. (a) How long after closing the switch will the current through
the inductor reach one-half of its maximum value? (b) How long after closing the switch
will the energy stored in the inductor reach one-half of its maximum value? ANS : (a)
17.3 s, (b) 30.7 s
11. A 18.0 F capacitor is placed across a 22.5 V battery for several seconds and is then
connected across a 12.0 mH inductor that has no appreciable resistance. (a) After the
capacitor and inductor are connected together, find the maximum current in the circuit.
When the current is a maximum, what is the charge on the capacitor? (b) How long after
the capacitor and inductor are connected together does it take for the capacitor to be
completely discharged for the first time? For the second time? (c) Sketch graphs of the
charge on the capacitor plates and the current through the inductors as functions of time.
ANS : (a) 0.871 A, (b) 0.730 ms and 2.19 ms
12. An L-R-C circuit has L = 0.450 H, C =2.50 x 10-5 F, and resistance R. (a) What is the
angular frequency of the circuit when R = 0? (b) What value must R have to give a 5.0%
decrease in angular frequency compared to the value calculated in part (a)? ANS : (a) 298
rad/s, (b) 83.8
PHY 3104 PHYSICS II

Semester 1, 16/17
PROBLEMS
1. In the circuit shown in Figure 7 the capacitor has capacitance C = 20 F and is initially
charged to 100 V with the polarity shown. The resistor Ro has resistance 10 . At time t =
0 the switch is closed. The small circuit is not connected in any way to the large one. The
wire of the small circuit has a resistance of 1.0 /m and contains 25 loops. The large
circuit is a rectangle 2.0 m by 4.0 m, while the small one has dimensions a = 10.0 cm and
b = 20.0 cm. The distance c is 5.0 cm. (The figure is not drawn to scale) Both circuits are
held stationary. Assume that only the wire nearest the small circuit produces an
appreciable magnetic field through it. (a) Find the current in the large circuit 200 S after
S is closed. (b) Find the current in the small circuit 200 S after S is closed. (C) Find the
direction of the current in the small circuit. (d) Justify why we can ignore the magnetic
field from all the wires of the large circuit except for the wire closest to the small circuit.
Figure 7
2. An inductor is connected to the terminals of a battery that has an emf of 12.0 V and
negligible internal resistance. The current is 4.86 mA at 0.725 ms after the connection is
completed. After a long time the current is 6.45 mA. What are (a) the resistance R of the
inductor and (b) the inductance L of the inductor?

Tutorial 5

Uploaded by

Copyright:

Available Formats

Tutorial 5

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Tutorial 5

Uploaded by

Copyright:

Available Formats

PHY 3104 PHYSICS II

TUTORIAL 5: SOURCES OF MAGNETIC FIELD & ELECTROMAGNETIC

PHY 3104 PHYSICS II

PHY 3104 PHYSICS II

PHY 3104 PHYSICS II

You might also like