Use of Water Quality Index Result of Robertson Lake Jabalpur in Remote Sensing Application

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

GRD Journals- Global Research and Development Journal for Engineering | Volume 1 | Issue 10 | September 2016

ISSN: 2455-5703

Use of Water Quality Index Result of Robertson


Lake Jabalpur in Remote Sensing Application
Pragati Khare
PG Student
Department of Civil Engineering
Jabalpur Engineering College, Jabalpur
Dr. A. K Dubey
Associate Professor
Department of Civil Engineering
Jabalpur Engineering College, Jabalpur

R. K Bhatia
Associate Professor
Department of Civil Engineering
Jabalpur Engineering College, Jabalpur

Abstract
The water of Robertson Lake is suffering from severe contamination which is due to heavy discharge of pollutants without
adequate treatment to remove harmful compounds. This is leading to the damaging effects not only to the individual species and
population but also to natural biological community. The present work highlights the water quality index of Robertson Lake of
Jabalpur. Water Quality Index (WQI) using remote sensing was applied in Robertson Lake India using water quality parameters
like Temperature, Chloride, Hardness, Alkalinity, pH, Conductivity, Total Dissolved Solids (TDS), Fluoride, Iron, Turbidity,
Dissolved Oxygen (DO) and Biochemical Oxygen Demand (BOD). The analysis reveals that Robertson Lake needs some
treatment before consumption.
Keywords- Physico-chemical parameters, Water Quality Index, Remote sensing and remedies

I. INTRODUCTION
Globally, there is increasing awareness that the water will be one of the most critical natural resources in future. Water scarcity is
increasing worldwide and pressure on the existing water resources is increasing due to growing demand of different sectors such
as domestic, agriculture and industrial, hydropower etc. Therefore evaluation of water quality is important research topic in the
recent years. Water is one of the most important factors for every living organism on this planet. Water is generally used for
drinking, fisheries and other domestic purposes in this area. The available fresh water to man is hardly 0.3 to 0.5% of the total
water available on the earth and therefore its judicious use in imperative. Lakes are one of the important water resources used for
irrigation, drinking, fisheries and flood control purposes.
The Robertson Lake is situated in Mahakausal region of Jabalpur. It lay behind Jabalpur Engineering College, Jabalpur.
It is surrounded by vehicle factory, pump house, hospital, mountains, temples and most importantly the population living around
the lake area. The lake shows the marshy vegetation growing at the bank of the lake along with drains and pools that quantify
pollution cost by municipal and industrial waste. A large part of this contamination is due to the organic material that comes
from neighbouring urban sewage, live stocks, industrial waste and hospital waste . The water is also infested with water hyacinth
which stabilised the water quality and provides substantial support to bacterial density which inturn contributes significantly to
its growth and nutrient dynamics.
Water quality indices are tools to determine conditions of water quality and, like any other tool require knowledge about
principles and basic concepts of water and related issues. It is a well-known method of expressing water quality that offers a
stable and reproducible unit of measure which responds to changes in the principal characteristics of water. WQI is a mechanism
for presenting a cumulatively derived numerical expression defining a certain level of water quality. In other words, WQI
summarizes large amounts of water quality data into simple terms e.g., excellent, good, bad, etc. for reporting to management
and the public in a consistent manner.
Remote sensing techniques can be used to monitor water quality parameters (i.e., suspended sediments (turbidity),
chlorophyll, and temperature). Optical and thermal sensors on boats, aircraft, and satellites provide both spatial and temporal
information needed to monitor changes in water quality parameters for developing management practices to improve water
quality. Recent and planned launches of satellites with improved spectral and spatial resolution sensors should lead to greater use
of remote sensing techniques to assess and monitor water quality parameters. Integration of remotely sensed data, GPS, and GIS
technologies provides a valuable tool for monitoring and assessing waterways. Remotely sensed data can be used to create a
permanent geographically located database to provide a baseline for future comparisons. The integrated use of remotely sensed
data, GPS, and GIS will enable consultants and natural resource managers to develop management plans for a variety of natural
resource management applications.

All rights reserved by www.grdjournals.com

95

Use of Water Quality Index Result of Robertson Lake Jabalpur in Remote Sensing Application
(GRDJE/ Volume 1 / Issue 10 / 014)

II. STUDY AREA AND SAMPLING DETAILS


Robertson Lake is one of the important lake of Jabalpur, Madhya Pradesh. Robertson Lake is situated near the Jabalpur
Engineering Collage which is also known as Government Engineering Collage. The area of the Robertson Lake is about 122.492
Hectare and its coordinates are 2311'52"N and 7959'9"E. Water samples collected from eight sampling stations selected for the
analysis are Sharda Nagar as S1, Ram Nagar as S2, Shanti Nagar as S3, Gokhalpur near Ranjhi Govt. Hospital as S4, Gokhalpur
near JEC as S5, Near Over Head Tank as S6, Near Vehicle Factory Road as S7 and Near Vehicle Factory Road Sector 2 as S8.
Samples are collected in the month of May. Samples for analysis are collected in sterilized bottles using the standard procedure
for grab (or) catch samples in accordance with standard methods of APHA (American Public Health Association). The analysis
of various physico chemical parameters namely Temperature, Chloride, Hardness, Alkalinity, pH, Conductivity, Total
Dissolved Solids (TDS), Fluoride, Iron, Turbidity, Dissolved Oxygen (DO) and Biochemical Oxygen Demand (BOD) are carried
out. All the chemicals and reagents used were of analytical grade.

Fig. 1: Study Area and Sampling Details

III. PARAMETERS CALCULATED


A. Temperature
Water temperature is a physical property expressing how hot or cold water is. Temperature is an important factor to co nsider
when assessing water quality. In addition to its own effects, temperature influences several other parameters and can alter the
physical and chemical properties of water. The average temperature of the present study ranged is 34.1.
B. Chloride
Chloride is present in all natural waters, but mostly the concentrations are low. In most surface streams, chloride concentrations
are lower than those of sulfate or bicarbonate. Chloride ions may be retained in solution through most of the processes which
tend to separate out other ions. Chloride values obtained in the study are found in the range between 65 to 85 mg / lt.
C. Hardness
Calcium and magnesium dissolved in water are the two most common minerals that make water "hard." The hardness of water is
referred to by three types of measurements: grains per gallon, milligrams per liter (mg/L), or parts per million (ppm). The
hardness values of the present study were found to range between 210 to 300 mg/lit.
D. Alkalnity
Alkalinity is a measure of the capacity of water to neutralize acids. The predominant chemical system present in natural waters is
one where carbonates, bicarbonates and hydroxides are present. The bicarbonate ion is usually prevalent. In the present
investigation the total alkalinity of the water samples is found in the Range 300 to 398 mg/lt.
E. pH
pH is a measure of how acidic/basic water is. The range goes from 0 - 14, with 7 being neutral. pHs of less than 7 indicate
acidity, whereas a pH of greater than 7 indicates a base. pH is really a measure of the relative amount of free hydrogen and
hydroxyl ions in the water. The pH values of the present investigation were between 5.9 to 8.5

All rights reserved by www.grdjournals.com

96

Use of Water Quality Index Result of Robertson Lake Jabalpur in Remote Sensing Application
(GRDJE/ Volume 1 / Issue 10 / 014)

F. Conductivity
Conductivity is used to measure the concentration of dissolved solids which have been ionized in a polar solution such as water.
The unit of measurement commonly used is one millionth of a Siemens per centimeter (micro-Siemens per centimeter or S/cm).
The values obtained are in the range 1150 to 1250 mhos
G. Total Dissolved Solids
Total dissolved solids (TDS) comprise inorganic salts (principally calcium, magnesium, potassium, sodium, bicarbonates,
chlorides, and sulphates) and some small amounts of organic matter that are dissolved in water. TDS values ranged within 500 to
600 mg/lt.
H. Turbidity
Turbidity is the cloudiness or haziness of a fluid caused by suspended solids that are usually invisible to the naked eye. It is an
aggregate optical property of the water and does not identify individual substances; it just says something is there. It is an
aggregate optical property of the water and does not identify individual substances; it just says something is there.
I. Fluoride
Fluoride is the simplest anion of fluorine. Its salts and minerals are important chemical reagent. In terms of charge and size, the
fluoride ion resembles the hydroxide ion. Fluoride ions occur on earth in several minerals, particularly fluorite, but are only
present in trace quantities in water. Fluoride contributes a distinctive bitter taste. It contributes no color to fluoride salts. In study
it varies in the range of 0.26 to 1.30 mg/l
J. Iron
In present study it is found in the range 0.26 to 1.02 mg/l.
K. Dissolved Oxygen
Dissolved oxygen concentrations are constantly affected by diffusion and aeration, photosynthesis, respiration and
decomposition. While water equilibrates toward 100% air saturation. The DO values obtained in the present study are within 3.0
to 6.2 mg/L.
L. Biochemical Oxygen Demand
Biochemical oxygen demand (BOD) is the amount of dissolved oxygen needed (i. e., demanded) by aerobic biological organisms
to break down organic material present in a given water sample at certain temperature over a specific time period. This parameter
values obtained in the present study are within 100 to 200 mg/l.

IV. CALCULATION OF WQI


In this study for the calculation of water quality index twelve important parameters were chosen. The W.Q.I. has been calculated
by using the standards of drinking water quality recommended by the World Health Organization (WHO), Bureau of Indian
Standards (BIS) and Indian Council for Medical Research (ICMR). The weighted arithmetic index method (Brown et. al.) has
been used for the calculation of WQI of the lake. Further quality rating or sub index (qn) was calculated using the following
expression.
Quality rating, Qi = 100 [(Vn -Vi) / (Vs -Vi)]
Where, Vn: actual amount of nth parameter
Vi: the ideal value of this parameter
Vi = 0,
Except for pH and D.O. Vi = 7.0 for pH;
Vi = 14.6 mg/L for D.O.
Vs: recommended WHO standard of corresponding parameter
Relative weight (Wi) was calculated by a value inversely proportional to the recommended standard (Si) of the corresponding
parameter:
Wi = 1/ Si
Generally, WQI are discussed for a specific and intended use of water. In this study the WQI for human consumption is
considered and permissible WQI for the drinking water is taken as 100. The overall WQI was calculated by using Equation:
Water Quality Index (WQI) = (Qi) Wi / Wi
Parameter
Temperature
Chloride
Hardness
Alkalinity
pH

Table 1: Water Quality Classification Based On WQI Value


Mean test result
Unit
Standard permissible value (Si) Relative Weight (Wi)
o
34.1
C
74.3
(mg/L)
250
0.0040
296
(mg/L)
300
0.0033
380
(mg/L)
200
0.0050
8.4
8.5
0.1176

All rights reserved by www.grdjournals.com

97

Use of Water Quality Index Result of Robertson Lake Jabalpur in Remote Sensing Application
(GRDJE/ Volume 1 / Issue 10 / 014)

Conductivity
TDS
Fluoride
Iron
Turbidity
DO
BOD

1158
582
0.85
0.37
54.18
6.0
198

(mS/cm)
300
(mg/L)
500
(mg/L)
1
(mg/L)
0.3
(mg/L)
5
(mg/L)
5
(mg/L)
6
Table 2: Samples Calculation Result
WQI
Quality of water
0-24
EXCELLENT
25-49
GOOD
50-74
POOR
75-100
VERY POOR
>100
UNFIT FOR DRINKING

0.0033
0.0020
0.0040
1.6666
0.16533
0.2000
0.1667

V. CONCLUSION
On the basis of results of research civil engineering structure which control the pollution in lake. To control the pollution in lake
through major sewers by Intercept and treat all sewage at Intersection of lake by volume. Divert some and Intercept the others.
Treat remaining sewage at intersection of lake. Install sewage treatment network upstream at sources and Intercept for final
Treatment at Lake. And to control pollution in lake through minor drains by Connect to main sewers as per gradient or lift
stations. Cluster drains in pockets and treat before discharge into lake. Connect Drains to points and lift stations for treatment
nearby.

REFERENCES
[1]

Joyanta pal, Dr. Manish Pal, Dr.Pankaj Kr. Roy and Dr. Asis Mazumdar. Water Quality Index for Assessment of Rudrasagar Lake Ecosystem, India.
January 2016, pp.98-101
[2] Bhaven N. Tandel, Dr. JEM Macwan, and Chirag K. Soni. Assessment of Water Quality Index of Small Lake in South Gujarat Region, India
[3] F.J. Thakor, D.K. Bho, H.R. Dabh, S.N. Pandya and Nikitraj B. Chauhan. Water Quality Index (W.Q.I.) of Pariyej Lake Dist. Kheda Gujarat. Current
World Environment Vol. 6(2), 225-231 (2011)
[4] Ground water in Koilwar block of Bhojpur (Bihar). Neerja Kalra et al J. Chem. Pharm. Res., 2012, 4(3):1783
[5] Er. Srikanth Satish Kumar Darapu, Er. B. Sudhakar, Dr. K. Siva Rama Krishna, Dr. P. Vasudeva Rao Dr. M. Chandra Sekhar. Determining Water Quality
Index for the Evaluation of Water Quality of River Godavari. ISSN: 2248-9622 Vol. 1, Issue 2, pp.174-182
[6] APHA Standard methods for examination of water and waste water. 21st Edn. Washington D.C. (2005).
[7] BIS Analysis of water and waste water Bureau of Indian Standards, New Delhi (1993).
[8] BIS Standards of water for drinking and other purposes Bureau of Indian Standards, New Delhi. (1993).
[9] Gupta B. K. and G. Singh. Damodar river water quality status along Dugda Sindri industrial belt of Jharia coalfield, in: Pollution and Biomonitoring of
Indian Rivers, ABD Publication, JMaipur, 58 69 (2000)
[10] WHO. International Standards for Drinking Water. World Health Organization, Geneva, Switzerland (1992)
[11] BIS (Bureau of Indian Standards) 10500, Indian standard drinking water specification First revision, 1991, pp 1-8ssss.

All rights reserved by www.grdjournals.com

98

You might also like