0% found this document useful (0 votes)
311 views1 page

Plate # 3

The document contains 7 problems related to determining reaction forces in pinned and fixed frame structures under various loading conditions. Problem 1 asks to find reactions at pinned supports of a two-member frame. Problem 2 asks to find horizontal and vertical reactions at pinned and fixed joints of a three-member frame. Problem 3 asks to determine horizontal and vertical reactions at a pinned bulkhead supporting soil and water pressures, as well as the required tension in a ground anchor.

Uploaded by

Jovan Bucol
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
311 views1 page

Plate # 3

The document contains 7 problems related to determining reaction forces in pinned and fixed frame structures under various loading conditions. Problem 1 asks to find reactions at pinned supports of a two-member frame. Problem 2 asks to find horizontal and vertical reactions at pinned and fixed joints of a three-member frame. Problem 3 asks to determine horizontal and vertical reactions at a pinned bulkhead supporting soil and water pressures, as well as the required tension in a ground anchor.

Uploaded by

Jovan Bucol
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

CE 151 PLATE NO.

3 (Due: October 6, 2016)

1. Determine the components of reaction at the pinned


supports A and C of the two-member frame. Neglect
the thickness of the members. Assume B is a pin.

2.
Determine the horizontal and vertical components of
reaction at A, C, and D. Assume the frame is pin
connected at A, C, and D, and there is a fixedconnected joint at B.

5. The beam is subjected to the two concentrated loads


as shown. Assuming that the foundation exerts a
linearly varying load distribution on its bottom,
determine the load intensities w1 and w2 for equilibrium
(a) in terms of the parameters shown; (b) set P = 500

lb, L = 12 ft

3. The bulkhead AD is subjected to both water and soilbackfill pressures. Assuming AD is pinned to the
ground at A, determine the horizontal and vertical
reactions there and also the required tension in the
ground anchor BC necessary for equilibrium. The
bulkhead
has
a
mass of
800 kg

6. Determine the horizontal and vertical components of


reaction at the pins A, B, and D of the three-member
frame. The joint at C is fixed connected.

7. The floor system used in a school classroom consists


of a 4-in. reinforced stone concrete slab. Sketch the
loading that acts along the joist BF and side girder
ABCDE. Set a = 10 ft, b = 30 ft

4. Determine the horizontal and vertical force


components that the pins support at A and D exert on
the four-member frame.

You might also like