RS232 modules can be debugged using the TeraTerm software by following several steps:
1) Pair the PC with the RS232 module via Bluetooth and identify the correct COM port number.
2) Open TeraTerm, connect to the correct COM port, and enable local echo to view data sent to the microprocessor.
3) Sending a '1' will make the buzzer beep, while a '2' will make it stop beeping.
RS232 modules can be debugged using the TeraTerm software by following several steps:
1) Pair the PC with the RS232 module via Bluetooth and identify the correct COM port number.
2) Open TeraTerm, connect to the correct COM port, and enable local echo to view data sent to the microprocessor.
3) Sending a '1' will make the buzzer beep, while a '2' will make it stop beeping.
RS232 modules can be debugged using the TeraTerm software by following several steps:
1) Pair the PC with the RS232 module via Bluetooth and identify the correct COM port number.
2) Open TeraTerm, connect to the correct COM port, and enable local echo to view data sent to the microprocessor.
3) Sending a '1' will make the buzzer beep, while a '2' will make it stop beeping.
RS232 modules can be debugged using the TeraTerm software by following several steps:
1) Pair the PC with the RS232 module via Bluetooth and identify the correct COM port number.
2) Open TeraTerm, connect to the correct COM port, and enable local echo to view data sent to the microprocessor.
3) Sending a '1' will make the buzzer beep, while a '2' will make it stop beeping.
Download as DOCX, PDF, TXT or read online from Scribd
Download as docx, pdf, or txt
You are on page 1/ 4
Debugging RS232 using TeraTerm
RS232 module can be debugged using `TeraTerm software. Please refer to the steps below for the RS232 settings using `TeraTerm.
Step 1:
Open the `Bluetooth settings on your PC. Please refer Figure 1.
Figure 1 Open Bluetooth Settings
Desktop > Taskbar > Bluetooth icon > Show Bluetooth Devices.
Step 2:
Pair your PC with RS232 module via Bluetooth as shown in Figure 2 and Figure 3.
Figure 2 Choose to pair with Bee
Figure 3 Insert password
Step 3:
Next, identify the COM port number of the devices.
1) Open the `Devices and Printers.
Control Panel > Hardware and Sound > Devices and Printers. 2) Check the port through the properties of the Bee. Please refer Figure 4. Right click on Bee > Properties > Services
Figure 4 Identify the COM port number
Step 4: Open the `Tera Term software after installed it in your PC and connect it with the right COM port Tera Term > Serial > COM ?? > OK ( Refer Figure 5)
Figure 5 Choose the right serial COM port number
Step 5: Next, you need to enable the local echo so that the data from the computer to the microprocessor is displayed. Refer to Figure 6 and Figure 7.
Figure 6 Setup > Terminal
Figure 7 Tick on the local echo box
Results: Press reset button on RS232 module and connection established will be displayed on the `Tera Term. Send a 1 the buzzer will beep. Send a 2 the buzzer will stop beeping.
