Scribd
Upload
189 views2 pages

Power Saver For Advertisement Hoardings Using RTC

This project creates a power saver for advertisement hoardings using an RTC (real-time clock) chip. It allows users to program different on and off timings to operate lights around sign boards automatically, eliminating manual operation. The timings are stored in EEPROM and will not be erased unless changed by the user. A DS1307 RTC chip with battery backup ensures the programmed timings are not disturbed during power failures. The project is useful for commercial sign boards and advertising boards to only switch lights on at preprogrammed times, saving electrical power.

Uploaded by

VigneshInfotech
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
189 views2 pages

Power Saver For Advertisement Hoardings Using RTC

This project creates a power saver for advertisement hoardings using an RTC (real-time clock) chip. It allows users to program different on and off timings to operate lights around sign boards automatically, eliminating manual operation. The timings are stored in EEPROM and will not be erased unless changed by the user. A DS1307 RTC chip with battery backup ensures the programmed timings are not disturbed during power failures. The project is useful for commercial sign boards and advertising boards to only switch lights on at preprogrammed times, saving electrical power.

Uploaded by

VigneshInfotech
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

POWER SAVER FOR ADVERTISEMENT HOARDINGS USING RTC

In this competitive world human cannot spare his time to perform his daily
activities manually without any fail. The most important thing he forgets is to switch off
the room lights wherever not required. With this, even the power will be wasted up to
some extent. This can be seen more effectively in the case of commercial sign boards.
This project gives the best solution for electrical power wastage. Also the manual
operation is completely eliminated. This project provides different on and off timings to
operate the lights around sign boards.. The user can once program these timings
according to his requirements and these timings will be stored in EEPROM and cannot be
erased unless the user wishes to change it again.
This project is very useful for commercial sign boards, advertising boards. This
system switches on the lights only at preprogrammed timings. As the DS1307 Real Time
Clock chip with battery back-up is used, there will be no disturbances for the
programmed on/off timings even in power failures.
Three switches are provided for entering the required timings. These switches
made this project user friendly. 16X2 LCD display is provided to display the alarm times
and current time. DS1307 is interfaced to the microcontroller for real timing
performance. A 3V battery can be connected to DS1307 to avoid time disturbances
caused by power failures. The user can even change the preprogrammed timings and set
the timings according to his requirements.

SOFTWARE AND HARDWARE TOOLS:


Software Tools:
1. Keil compiler
2. Orcad.

Hardware Tools:
1. Microcontroller AT89S52.
2. RTC
3. TRIAC DRIVERS AND LOADS
4. LCD

BLOCK DIAGRAM

You might also like