Chapter 3

Diode Circuits

3.1 Ideal Diode

3.2 PN Junction as a Diode
3.3 Applications of Diodes

Diode Circuits

After we have studied in detail the physics of a diode, it is

time to study its behavior as a circuit element and its many
applications.
CH3

Diode Circuits

Diodes Application: Cell Phone Charger

An important application of diode is chargers.

Diode acts as the black box (after transformer) that passes
only the positive half of the stepped-down sinusoid.
CH3

Diode Circuits

Diodes Action in The Black Box (Ideal Diode)

The diode behaves as a short circuit during the positive

half cycle (voltage across it tends to exceed zero), and an
open circuit during the negative half cycle (voltage across it
is less than zero).
CH3

Diode Circuits

Ideal Diode

In an ideal diode, if the voltage across it tends to exceed

zero, current flows.
It is analogous to a water pipe that allows water to flow in
only one direction.
CH3

Diode Circuits

Diodes in Series

Diodes cannot be connected in series randomly. For the

circuits above, only a) can conduct current from A to C.

CH3

Diode Circuits

IV Characteristics of an Ideal Diode

V
R 0 I
R

V
RI 0
R

If the voltage across anode and cathode is greater than

zero, the resistance of an ideal diode is zero and current
becomes infinite. However, if the voltage is less than zero,
the resistance becomes infinite and current is zero.
CH3

Diode Circuits

Model Dioda Ideal

Mempunyai resistansi nol pada saat forward bias.

Mempunyai resistansi tak terhingga pada saat
reverse bias.

Anti-Parallel Ideal Diodes

If two diodes are connected in anti-parallel, it acts as a

short for all voltages.
CH3

Diode Circuits

Analysis Garis Beban (Load-Line)

Resistor adalah piranti linear.

Dioda adalah piranti nonlinear.
Metode grafik adalah salah satu cara untuk analisys
piranti nonlinear.

Vss= RiD + v D

Lanjutan

Vss= RiD + v D

Contoh

Untai dioda mempunyai karakteristik seperti gambar. Jika Vss = 2V

dan R = 1k, tentukan tegangan dan arus pada titik kerja.
Ulangi soal pertama jika Vss = 10V dan R = 10k

Contoh
Tentukan titik kerja dioda jika (a) Vss = 2V dan R = 100 , (b) Vss =
15V dan R = 1k, (c) Vss = 1V dan R = 20

Diode-Resistor Combination

The IV characteristic of this diode-resistor combination is

zero for negative voltages and Ohms law for positive
voltages.
CH3

Diode Circuits

14

Input/Output Characteristics

When Vin is less than zero, the diode opens, so Vout = Vin.
When Vin is greater than zero, the diode shorts, so Vout = 0.
CH3

Diode Circuits

15

Diodes Application: Rectifier

A rectifier is a device that passes positive-half cycle of a

sinusoid and blocks the negative half-cycle or vice versa.
When Vin is greater than 0, diode shorts, so Vout = Vin;
however, when Vin is less than 0, diode opens, no current
flows thru R1, Vout = IR1R1 = 0.
CH3

Diode Circuits

16

Signal Strength Indicator

Vout V p sin t 0
Vout , avg

for

1T
1 T /2
Vout (t )dt
V p sin tdt
T0
T 0
Vp
for
1 Vp
T /2
cos t 0

T
t T
2

0t

T
2

The averaged value of a rectifier output can be used as a

signal strength indicator for the input, since Vout,avg is
proportional to Vp, the input signals amplitude.
CH3

Diode Circuits

17

Diodes application: Limiter

The purpose of a limiter is to force the output to remain below

certain value.
In a), the addition of a 1 V battery forces the diode to turn on after
V1 has become greater than 1 V.
CH3

Diode Circuits

18

Limiter: When Battery Varies

An interesting case occurs when VB (battery) varies.

Rectification fails if VB is greater than the input amplitude.
CH3

Diode Circuits

19

Different Models for Diode

So far we have studied the ideal model of diode. However,

there are still the exponential and constant voltage models.
CH3

Diode Circuits

20

Input/Output Characteristics with Ideal and

Constant-Voltage Models

The circuit above shows the difference between the ideal

and constant-voltage model; the two models yield two
different break points of slope.
CH3

Diode Circuits

21

Input/Output Characteristics with a Constant-Voltage

Model

When using a constant-voltage model, the voltage drop

across the diode is no longer zero but Vd,on when it
conducts.
CH3

Diode Circuits

22

Another Constant-Voltage Model Example

In this example, since Vin is connected to the cathode, the

diode conducts when Vin is very negative.
The break point where the slope changes is when the
current across R1 is equal to the current across R2.
CH3

Diode Circuits

23

Cell Phone Adapter

Vout 3VD
Ix

IX
3VT ln
Is

Vout = 3 VD,on is used to charge cell phones.

However, if Ix changes, iterative method is often needed to
obtain a solution, thus motivating a simpler technique.
CH3

Diode Circuits

24

Small-Signal Analysis

I D

V
I D1
VT

Small-signal analysis is performed around a bias point by

perturbing the voltage by a small amount and observing
the resulting linear current perturbation.
CH3

Diode Circuits

25

Small-Signal Analysis in Detail

I D dI D

|VD VD1
VD dVD
Is
I D1
exp
VT
VT
I D1

VT
If two points on the IV curve of a diode are close enough,
the trajectory connecting the first to the second point is like
a line, with the slope being the proportionality factor
between change in voltage and change in current.
CH3

Diode Circuits

26

Small-Signal Incremental Resistance

VT
rd
ID
Since theres a linear relationship between the small signal
current and voltage of a diode, the diode can be viewed as
a linear resistor when only small changes are of interest.
CH3

Diode Circuits

27

Cause and Effect

In (a), voltage is the cause and current is the effect. In (b),

the other way around.
CH3

Diode Circuits

28

Adapter Example Revisited

vout

3rd

vad
R1 3rd
11.5mV

With our understanding of small-signal analysis, we can

revisit our cell phone charger example and easily solve it
with just algebra instead of iterations.
CH3

Diode Circuits

29

Simple is Beautiful

Vout I D (3rd )
0.5mA(3 4.33)
6.5mV

In this example we study the effect of cell phone pulling

some current from the diodes. Using small signal analysis,
this is easily done. However, imagine the nightmare, if we
were to solve it using non-linear equations.
CH3

Diode Circuits

30

Applications of Diode

CH3

Diode Circuits

31

Half-Wave Rectifier

A very common application of diodes is half-wave

rectification, where either the positive or negative half of
the input is blocked.
But, how do we generate a constant output?
CH3

Diode Circuits

32

Diode-Capacitor Circuit: Constant Voltage Model

If the resistor in half-wave rectifier is replaced by a

capacitor, a fixed voltage output is obtained since the
capacitor (assumed ideal) has no path to discharge.
CH3

Diode Circuits

33

Diode-Capacitor Circuit: Ideal Model

Note that (b) is just like Vin, only shifted down.

CH3

Diode Circuits

34

Diode-Capacitor With Load Resistor

A path is available for capacitor to discharge. Therefore,

Vout will not be constant and a ripple exists.
CH3

Diode Circuits

35

Behavior for Different Capacitor Values

For large C1, Vout has small ripple.

CH3

Diode Circuits

36

Peak to Peak amplitude of Ripple

t
Vout (t ) (V p VD ,on ) exp
RL C1

0 t Tin

V p VD ,on t
t
Vout (t ) (V p VD ,on )(1
) (V p VD ,on )
RL C1
RL
C1
V p VD ,on Tin V p VD ,on
VR

RL
C1 RLC1 f in

The ripple amplitude is the decaying part of the exponential.

Ripple voltage becomes a problem if it goes above 5 to 10%
of the output voltage.

CH3

Diode Circuits

37

Maximum Diode Current

I p C1inV p

2VR V p V p
2VR

( RLC1in
1)
V p RL RL
Vp

The diode has its maximum current at t1, since thats when
the slope of Vout is the greatest.
This current has to be carefully controlled so it does not
damage the device.
CH3

Diode Circuits

38

Full-Wave Rectifier

A full-wave rectifier passes both the negative and positive

half cycles of the input, while inverting the negative half of
the input.
As proved later, a full-wave rectifier reduces the ripple by a
factor of two.
CH3

Diode Circuits

39

The Evolution of Full-Wave Rectifier

Figures (e) and (f) show the topology that inverts the negative
half cycle of the input.
CH3

Diode Circuits

40

Full-Wave Rectifier: Bridge Rectifier

The figure above shows a full-wave rectifier, where D1 and

D2 pass/invert the negative half cycle of input and D3 and D4
pass the positive half cycle.
CH3

Diode Circuits

41

Input/Output Characteristics of a Full-Wave Rectifier

(Constant-Voltage Model)

The dead-zone around Vin arises because Vin must exceed 2

VD,ON to turn on the bridge.
CH3

Diode Circuits

42

Complete Full-Wave Rectifier

Since C1 only gets of period to discharge, ripple voltage

is decreased by a factor of 2. Also (b) shows that each
diode is subjected to approximately one Vp reverse bias
drop (versus 2Vp in half-wave rectifier).
CH3

Diode Circuits

43

Current Carried by Each Diode in the Full-Wave Rectifier

CH3

Diode Circuits

44

Summary of Half and Full-Wave Rectifiers

Full-wave rectifier is more suited to adapter and charger

applications.
CH3

Diode Circuits

45