Scribd
Upload
401 views7 pages

Proteus Design Guide

To design a PCB in Proteus, first create a new file and draw the schematic. Place components one by one in the ARES workspace and rearrange them. Click auto route to automatically route the connections, setting the layer assignment and trace width as needed. The autorouter will generate the PCB layout which can then be printed.

Uploaded by

Hamed Raza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
401 views7 pages

Proteus Design Guide

To design a PCB in Proteus, first create a new file and draw the schematic. Place components one by one in the ARES workspace and rearrange them. Click auto route to automatically route the connections, setting the layer assignment and trace width as needed. The autorouter will generate the PCB layout which can then be printed.

Uploaded by

Hamed Raza
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 7

PCB design using Proteus

Prepared by : Hamed Raza(Application developer)


1. Open Proteus professional and create a new file
2. Start drawing your schematic. Make sure all components have PCB footprint or you
might need to consider replacement component with similar footprint.

Confirm
Footprint

3. Once completed your schematic, click on ARES tab at the upper right of ISIS workspace

Click on ARES tab

4. A new ARES workspace window shall appear. Right click>Component>chose the


component number and place one by one

5. Rearrange your component

6. Click Tools>Auto Router. A shape based auto router window will appear and click
Begin Routing

7. Result:

By default, the autoroute is set


to route at double sided PCB

Red Trace -> top copper


Blue Trae -> bottom coper

8. If you are using a single layer PCB:


-

Before routing, you need to set the layer assignment for bottom copper only.

Click Tools>Design Rule Manager>Net Classes

9. If you want to adjust the trace width:


-

Click Tools>Design Rule Manager. Click on Net Classes tab. Select your desired trace style
on Trace Style Drop down menu. You need to specify the trace style for both Net Class.

10. Next, begin autoroute

Result if you choose single layer

11. Printing the layout :


- Click Output > Print

Result if you choose double layer

Select the layer that you want to print and reflection type

Copper top:

Copper bottom:

You might also like