Scribd
Upload
40 views2 pages

Machine Drawing

This document contains instructions for a Machine Drawing examination. It provides 6 questions for students to answer. Questions 1-5 are worth 5 marks each, for a total of 25 marks. Question 6 is worth 50 marks, with 35 marks for part (a) asking students to draw a half sectional front view of a cross head assembly, and 15 marks for part (b) asking for a left side view of the cross head. Students are to draw the requested views of various mechanical components, assemblies, and fasteners.

Uploaded by

nveman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
40 views2 pages

Machine Drawing

This document contains instructions for a Machine Drawing examination. It provides 6 questions for students to answer. Questions 1-5 are worth 5 marks each, for a total of 25 marks. Question 6 is worth 50 marks, with 35 marks for part (a) asking students to draw a half sectional front view of a cross head assembly, and 15 marks for part (b) asking for a left side view of the cross head. Students are to draw the requested views of various mechanical components, assemblies, and fasteners.

Uploaded by

nveman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Code No.

3283
FACULTY OF ENGINEERING
B.E. 2/4 (M/P/AE) I-Semester (Supplementary) Examination, June/J~ly 2011
MACHINE

DRAWING

Time: Three Hours]


Note :-(1)
(2)
(3)
(4)
PART~A

(Marks:

5x 5

= 25)

1.

Draw the half sectional front view and side view of a split muff coupling.

2.

Draw the front view, side view from right and top view as shown in Fig. I below:
/,,>-~(

~
~. .-;,"

,5

tg

Fig. 1 : Bracket

3.

Draw an eye foundation bolt of diameter 30 mrn, suitably positioned in the foundation base. 5

HVS-810

(Contd.)

4.

Draw the two views of a square headed bolt of dia 30 nun, with a square nut and washer, suitable
to fasten two plates of thickness 25 mm each.
5

5.

Draw half sectional front view and top view of a cotter joint with socket and spigot ends to
connect two rods of 50 mm diameter.
5
PART-B

6.

(Marks: 50)

Assemble all the parts of cross head given in Fig. 2.


Draw:
(a) Half sectional front view with upper half in section.

35

(b) Left side view.

15

You might also like