Modeling and Simulation of Solar Photovoltaic Module Using Matlab Simulink
Uploaded by
esatjournalsModeling and Simulation of Solar Photovoltaic Module Using Matlab Simulink
Uploaded by
esatjournalsIJRET: International Journal of Research in Engineering and Technology
ISSN: 2319-1163
MODELING AND SIMULATION OF SOLAR PHOTOVOLTAIC MODULE
USING MATLAB / SIMULINK
Jay Patel1, Gaurag Sharma2
1
PG Student, 2Assistant professor Electrical department, Birla Vishvakarma Mahavidhyalaya, Gujarat, India,
[email protected], [email protected]
Abstract
The paper presents the modeling ,simulation and implementation of the solar photovoltaic cell using MATLAB/SIMULINK .The I-V ,
P-V & I-V characteristics are obtained for (1) Single solar cell module (2) Solar PV module with variable temp.& fixed radiation (3)
Solar PV module with fixed temp.& variable radiation with M.file and mathematical model using MATLAB/SIMULINK .
Index Terms: photovoltaic module, radiation, temperature, M.file, MATLAB/SIMULINK
-----------------------------------------------------------------------***----------------------------------------------------------------------1. INTRODUCTION
2. PV MODULE
One of the major concerns in the power sector is the day-today increasing power demand but the unavailability of enough
resources to meet the power demand using the conventional
energy sources. Energy is the prime mover of economic
growth and is vital to the sustenance of a modern economy
.Future economic growth crucially depends on the long-term
availability of energy from sources that are affordable ,
accessible and environment. Demand has increased for
renewable sources of energy to be utilized along with
conventional systems to meet the energy demand. Renewable
sources like wind energy and solar energy are the prime
energy sources which are being utilized in this regard. The
continuous use of fossil fuels has caused the fossil fuel deposit
to be reduced and has drastically affected the environment
depleting the biosphere and cumulatively adding to global
warming. Solar energy is abundantly available that has made
it possible to harvest it and utilize it properly. Solar energy can
be a standalone generating unit or can be a grid connected
generating unit depending on the availability of a grid nearby.
Thus it can be used to power rural areas where the availability
of grids is very low. Another advantage of using solar energy
is the portable operation whenever wherever necessary. In
order to tackle the present energy crisis one has to develop an
efficient manner in which power has to be extracted from the
incoming solar radiation. The power conversion mechanisms
have been greatly reduced in size in the past few years. The
development in power electronics and material science has
helped engineers to come up very small but powerful systems
to withstand the high power demand. they can hardly compete
in the competitive markets as a prime power generation
source. The PV module represents the fundamental power
conversion unit of PV generator system. The output
characteristics of PV module depends on the solar radiation
,the cell temperature and output voltage of PV module.
A solar cell is the building block of a solar panel. A
photovoltaic module is formed by connecting many solar cells
in series and parallel. Considering only a single solar cell; it
can be modeled by utilizing a current source, a diode and two
resistors. This model is known as a single diode model of solar
cell. Two diode models are also available but only single
diode model is considered here in fig. 1
Fig. 1 Equivalent circuit model of PV cell
The characteristic equation for a photovoltaic cell is given by
Io =(Np * Iph)- (Np* Irs) * (exp((q/(k*T*A))*(Vo/ Ns))-1)
(1)
Where
Iph=(Iscr+ki*(T-Tr))* ((s)/100);
(2)
Irs= Irr * ((T/Tr)^3) * exp(q*Eg/(k*A) * ((1/Tr)-(1/T))
Tr=(Tr1-32)+273
(3)
(4)
Io& Vo : Cell output current and voltage;
Irs : Cell reverse saturation current;
T : Cell temperature in Celsius;
k : Boltzmann's constant :1.38 * 10-19 J/K;
q : Electron charge: 1.6*10-23 C;
__________________________________________________________________________________________
Volume: 02 Issue: 03 | Mar-2013, Available @ http://www.ijret.org
225
IJRET: International Journal of Research in Engineering and Technology
Ki : Short circuit current temperature coefficient at Iscr;
S : Solar radiation ;
Iscr : Short circuit current at 25 degree Celsius;
Iph : Light-generated current;
Eg : Band gap for silicon;
Tr : Reference temperature;
Rsh : Shunt resistance;
Rs : Series resistance;
A PV array is a group of several PV cells which are
electrically connected in series and parallel circuits to generate
the required current and voltage. The equivalent circuit for the
solar module arrange in Np parallel and Ns series cells is
shown in fig. 2
ISSN: 2319-1163
1
In1
1
Out1
2
In2
Ppv
Product
Ipv
Ppv
PV
To Workspace
3
In3
1e-9*(exp(u/26e-3)-1)
PN-junction characteristic
Id
Id
2 Out2
4
In4
1/1000
ISC
Ipv
Insolation to
ISC current gain
Fig. 4 Subsystem of single photovoltaic cell model
Fig.2 Equivalent circuit of solar array
The shunt resistance Rsh is inversely related with shunt
leakage current to the ground .In general , the PV efficiency is
insensitive to variation in Rsh and the shunt -leakage
resistance can be assumed to approach infinity without
leakage current to ground . on the other hand ,a small variation
in Rs will significantly affect the PV output power .
3. IMPLEMENTATION AND SIMULATION OF
MODEL
1) The proposed model of single solar photovoltaic cell is
implemented and shown in fig. 3 and fig. 4
Fig.5 I-V characteristics of single solar cell
Vpv
SOLAR _ PV _ Singal Cell
PV power
In1
Out1
Vpv
Vpv
Vpv
In2
In3
Out2
1000
I-V characteristic
In4
Insolation
Solar Cell
Fig. 3 Masked single photovoltaic cell model
Fig.6 P-V characteristics of single solar cell
__________________________________________________________________________________________
Volume: 02 Issue: 03 | Mar-2013, Available @ http://www.ijret.org
226
IJRET: International Journal of Research in Engineering and Technology
ISSN: 2319-1163
4000
3500
3000
power in watt
2500
2000
1500
1000
500
0
20
40
60
80
current in amp
100
120
Fig. 10 P-I characteristics of solar cell with variable Temp. &
Fixed Radiation
Fig. 7 MATLAB simulation of PV module
3) Output of Solar PV Array with Fixed Temp. & variable
Radiation using M.file and matlab modeling
2) Output of Solar PV Array with variable Temp. & Fixed
Radiation using M.file and matlab modeling
20
18
16
14
Current in amp
120
Current in amp
100
12
10
8
80
6
4
60
2
40
10
15
20
25
30
Voltage in volt
35
40
45
50
20
10
15
20
25
Voltage in volt
30
35
40
45
Fig. 11 I-V characteristics of solar cell with Fixed Temp. &
variable Radiation
Fig. 8 I-V characteristics of solar cell with variable Temp. &
Fixed Radiation
400
350
4000
300
power in watt
3500
power in watt
3000
2500
2000
1500
250
200
150
100
1000
50
500
0
0
10
15
20
25
Voltage in volt
30
35
40
45
Fig. 9 P-V characteristics of solar cell with variable Temp. &
Fixed Radiation
10
15
20
25
30
Voltage in volt
35
40
45
50
Fig. 12 P-V characteristics of solar cell with Fixed Temp. &
variable Radiation
__________________________________________________________________________________________
Volume: 02 Issue: 03 | Mar-2013, Available @ http://www.ijret.org
227
IJRET: International Journal of Research in Engineering and Technology
[6] I. S. Kim and M. J. Youn, Variable-structure observer for
solar array current estimation in a photovoltaic powergeneration system, IEE Proceedings-Electric Power
Applications, , vol. 152, no. 4, 2005, pp. 953959.
400
350
300
power in watt
ISSN: 2319-1163
250
BIOGRAPHIES:
200
150
100
50
0
8
10
12
current in amp
14
16
18
20
Fig. 13 P-I characteristics of solar cell with Fixed Temp. &
variable Radiation
CONCLUSIONS
The proposed model and using m.file of PV module takes
solar radiation intensity and cell temperature as input and
outputs the I-V and P-V characteristics under various
conditions. we conclude that The insolation change affects the
photon generated current and has very little effect on the open
circuit voltage and we also simulate and modeling of solar cell
and measure the different characteristics. and also measure
the effect of variation in temperature that if the temperature
increases the solar cell efficiency is reduced. As we increase
the solar radiation, higher would be the solar input to the solar
cell and hence power magnitude would increase for the same
voltage value. With increase in the solar radiation the open
circuit voltage increases. This model can be used for the
analysis in the field of solar photovoltaic system and MPPT
technologies .
Jay Patel received the B.E(Electrical
Engineering) degree from Sardar Patel
University
(Birla Vishvakarma
Mahavidhyalaya Engineering College) in
2010. he is currently a M.E (power
system) student (3rd semester) In Birla
Vishvakarma
Mahavidhyalaya
Engineering College from Gujarat
Technological University. His current
research interests include solar enregy and power system
protection
Gaurang K.Sharma is Presently working
in Electrical Engineering Dept .B.V.M
Engineering College .previously worked
with ERDA Baroda having total 12 years
experience in Multinational Industries as
well as Academic Institutions.
ACKNOWLEDGEMENTS
The authors would like to thank Dr.. B.R Parekh and prof.
N.G misra of Birla Vishavakarma Mahavidhyalaya
Engineering College,v.v nagar ,Gujarat,India contribution to
this paper.
REFERENCES:
[1] John A. Duffie & William A. Beckman, Solar
Engineering of Thermal Process, 3rd ed,John Wiley & Sons,
pp. 747-773, (2006).
[2] Nicola M. Pearsall and Robert Hill, Clean electricity from
photovoltaic, 3rd ed., World Scientific, pp. 671-712, (2004)
[3] R. Messenger and J. Ventre, Photovoltaic Systems
Engineering, CRC Press, 2000, pp.41-51.
[4] S. W. Angrist, , Direct Energy Conversion, Allyn and
Bacon, Inc., 4th edition, 1982, pp. 177-227.
[5] O. Wasynczuk, Dynamic behavior of a class of
photovoltaic power systems, IEEE Transactions on Power
Apparatus and Systems, vol. PAS-102, no. 9, 1983, pp. 30313037.
__________________________________________________________________________________________
Volume: 02 Issue: 03 | Mar-2013, Available @ http://www.ijret.org
228
