Scribd
Upload
3K views1 page

Loop Test Sheet PDF

This document is a loop test sheet used to record the testing of a control loop. It includes sections to document the loop number, alarm settings, instruments needing calibration or replacement, and a sign off statement. Additional sections ensure the loop is installed as designed, performs as intended, and all field devices, labeling, terminations and documentation are properly checked. Sign off from instrument/control and electrical and process teams is required to verify the loop is ready for operation.

Uploaded by

Trí Nguyễn
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3K views1 page

Loop Test Sheet PDF

This document is a loop test sheet used to record the testing of a control loop. It includes sections to document the loop number, alarm settings, instruments needing calibration or replacement, and a sign off statement. Additional sections ensure the loop is installed as designed, performs as intended, and all field devices, labeling, terminations and documentation are properly checked. Sign off from instrument/control and electrical and process teams is required to verify the loop is ready for operation.

Uploaded by

Trí Nguyễn
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

LOOP TEST SHEET

System:
Loop Number
Alarm Settings
Actual alarm values
Alarms needing reset
Post test statement

P&ID:
L=
L=

LL =
LL =

Project:
Description
H=
H=

Signed

The loop is installed as shown on the P&ID and loop


diagram
The loop will perform as designed
Field Labelling
Motor push buttons
Motors
Control/On-Off Valves
Instruments and cabel
Orifice Plates
Junction Box
Marshalling Cabinet
DCS/PLC Panel
Local Panels
General electrical wiring
Other

MCC Room
Starters and push buttons
Lighting suitable
Accessibility of terminations
Fuse/breaker lock box available
Heating adequate
Cooling adequate
Cabinet air fan acceptable?
Labels on cabinet door correct
Wires labeled
Cables labelled
Other

DCS and or I/O Room


DCS/PLC panels labelled
Termination panel access suitable
Termination drawing suitable
Fuse in place

HH =
HH =

YES

NO

YES

NO

OK N/A Instrument
Air Isolation correct
Accessible
Location correct per Loop diagram and P&ID
Input continuity check
Calibration
Range check with Control system
Loop direct/reverse action
Serial number correct
State change OK on control system

Control- On/Off valves


Position
0% =
Position
25% =
Position
50% =
Position
75% =
Position
100% =

mA =
mA =
mA =
mA =
mA =

Valve positioner operates correctly


State change OK on control system
Fail position checked

Interlock tested
Documentation
Interlock data on loop and P&ID correct
All loop diagram data correct
Master copy red lines for final mark up
Control room has copy until as built issued

Motor
Megged/rating
Rotation
State change OK on control system

Signed for Instrument/Control / Electrical


Signed for process

Date
Date

You might also like