Scribd Logo
Upload

Welcome to Scribd!

  • 375 views

    3.3.1.2 Packet Tracer - Skills Integration Challenge Instructions

    Uploaded by

    c1190222
    CCNA 3.3.1.2 Skills Integration Challenge Instructions 2016

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    3.3.1.2 Packet Tracer - Skills Integration Challenge Instructions

    Uploaded by

    c1190222
    375 views4 pages
    CCNA 3.3.1.2 Skills Integration Challenge Instructions 2016

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    CCNA 3.3.1.2 Skills Integration Challenge Instructions 2016

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    375 views4 pages

    3.3.1.2 Packet Tracer - Skills Integration Challenge Instructions

    Uploaded by

    c1190222
    CCNA 3.3.1.2 Skills Integration Challenge Instructions 2016

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 4
    At a glance
    Powered by AI
    The document describes how to configure a network topology with multiple VLANs and inter-VLAN routing using routers and switches. Inter-VLAN communication is enabled through subinterface configuration on routers and trunk port configuration on switches.

    On routers R1 and R2, subinterfaces are configured with dot1Q encapsulation and VLAN 99 as the native VLAN. IP addresses are assigned to each subinterface according to the addressing table. OSPF is configured to route between the VLANs.

    VLANs 10, 20 and 99 are created on all switches. Static access ports are assigned to VLANs 10 and 20 on switches S1-S4. Trunk ports are configured as native trunks for VLAN 99.

    Packet Tracer Skills Integration Challenge

    Topology

    2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.

    Page 1 of 4

    Packet Tracer Skills Integration Challenge

    Addressing Table
    Device

    Interface

    IP Address

    Subnet Mask

    Default Gateway

    VLAN Association

    G0/0.1

    192.168.99.1

    255.255.255.0

    N/A

    VLAN 99

    G0/0.10

    192.168.10.1

    255.255.255.0

    N/A

    VLAN 10

    G0/0.20

    192.168.20.1

    255.255.255.0

    N/A

    VLAN 20

    S0/0/0

    209.165.22.222

    255.255.255.224

    N/A

    N/A

    S0/0/1

    192.168.1.1

    255.255.255.0

    N/A

    N/A

    G0/0.1

    192.168.99.2

    255.255.255.0

    N/A

    VLAN 99

    G0/0.10

    192.168.10.2

    255.255.255.0

    N/A

    VLAN 10

    G0/0.20

    192.168.20.2

    255.255.255.0

    N/A

    VLAN 20

    S0/0/0

    192.168.1.2

    255.255.255.0

    N/A

    N/A

    S0/0/1

    209.165.22.190

    255.255.255.224

    N/A

    N/A

    S0/0/0

    209.165.22.193

    255.255.255.224

    N/A

    N/A

    S0/0/1

    209.165.22.161

    255.255.255.224

    N/A

    N/A

    Web

    NIC

    64.104.13.130

    255.255.255.252

    64.104.13.129

    N/A

    PC10A

    NIC

    192.168.10.101

    255.255.255.0

    192.168.10.1

    VLAN 10

    PC10B

    NIC

    192.168.10.102

    255.255.255.0

    192.168.10.1

    VLAN 10

    PC20A

    NIC

    192.168.20.101

    255.255.255.0

    192.168.20.1

    VLAN 20

    PC20B

    NIC

    192.168.20.102

    255.255.255.0

    192.168.20.1

    VLAN 20

    R1

    R2

    ISP

    Scenario
    In this activity, two routers are configured to communicate with each other. You are responsible for
    configuring subinterfaces to communicate with the switches. You will configure VLANs, trunking, and
    EtherChannel with PVST. The Internet devices are all preconfigured.

    Requirements
    You are responsible for configuring routers R1 and R2 and switches S1, S2, S3, and S4.
    Note: Packet Tracer does not allow assigning point values less than 1. Since this activity is checking 154
    items, not all configurations are assigned a point value. Click Check Results > Assessment Items to verify
    you correctly configured all 154 items.
    Inter-VLAN Routing
    On R1 and R2, enable and configure the subinterfaces with the following requirement:
    - Configure the appropriate dot1Q encapsulation.
    -

    Configure VLAN 99 as the native VLAN.

    Configure the IP address for the subinterface according to the Addressing Table.

    2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.

    Page 2 of 4

    Packet Tracer Skills Integration Challenge


    Routing
    Configure OSPFv2 using the following requirements:
    - User process ID 1.
    -

    Advertise the network for each subinterface.

    Disable OSPF updates for each subinterface.

    VLANs

    For all switches, create VLAN 10, 20, and 99.

    Configure the following static ports for S1 and S2:

    F0/1 9 as access ports in VLAN 10.

    F0/10 19 as access ports in VLAN 20.

    F0/20 F24 and G0/1 1/2 as the native trunk for VLAN 99.

    Configure the following static ports for S3 and S4:


    -

    F0/1 9 as access ports in VLAN 10.

    F0/10 20 as access ports in VLAN 20.

    F0/21 F24 and G0/1 1/2 as the native trunk for VLAN 99.

    EtherChannels

    All EtherChannels are configured as LACP.

    All EtherChannels are statically configured as the native trunk for VLAN 99.

    Use the following table to configure the appropriate switch ports to form EtherChannels:
    Port Channel

    Device: Ports

    Device: Ports

    S1: G0/1 2

    S3: G0/1 2

    S2: G0/1 2

    S4: G0/1 2

    S1: F0/23 24

    S2: F0/23 24

    S3: F0/23 24

    S4: F0/23 24

    S1: F0/21 22

    S4: F0/21 22

    S2: F0/21 22

    S3: F0/21 - 22

    Spanning Tree

    Configure per-VLAN rapid spanning tree mode for all switches.

    Configure spanning tree priorities according to the table below:


    Device

    VLAN 10 Priority

    VLAN 20 Priority

    S1

    4096

    8192

    S2

    8192

    4096

    S3

    32768

    32768

    S4

    32768

    32768

    2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.

    Page 3 of 4

    Packet Tracer Skills Integration Challenge


    Connectivity

    All PCs should be able to ping the Web and other PCs.

    2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.

    Page 4 of 4

    You might also like