Optical OFDM For High-Speed Transmission: FC FC

Optical OFDM for High-Speed Transmission
Itsuro Morita
KDDI R&D Laboratories, 2-1-15 Ohara Fujimino Saitama, 356-8502, Japan
TEL: +81-49-278-7865, Fax: +81-49-278-7821, Email: [email protected]
Abstract
Optical orthogonal frequency division multiplexing for
high-speed, long-haul optical transmission systems is
reviewed. Some important aspects of the systems are
discussed and demonstrations of high-speed transmission
up to 122 Gbit/s are presented.
1. Introduction
Orthogonal frequency division multiplexing (OFDM) is
an attractive modulation format that recently received a
lot of attention in the fiber-optic community [1, 3-9].
The main advantage of optical OFDM is that it can cope
with virtually unlimited amount of inter symbol
interference (ISI). In high-speed optical transmission
systems, ISI is caused for instance by chromatic
dispersion and polarization mode dispersion (PMD),
which are serious issues in long-haul systems whose bit
rate is higher than 40 Gbit/s.
In this paper some of the basics of an optical OFDM
system are discussed. Furthermore, high-speed
transmission experiments up to 122 Gbit/s are presented
2. Optical OFDM systems
The basic concept behind OFDM is the division of a
high bit rate data stream into several low bit rate streams,
which are simultaneously modulated onto orthogonal
subcarriers. In general, the subcarriers are generated in
the digital domain, therefore these systems typically
consist of many subcarriers (typically more than 50). In
these systems, channel estimation is realized by
periodically inserting training symbols [1]. In fiber-optic
transmission systems, the OFDM systems where the
subcarriers are generated in the optical domain are also
proposed. These systems are sometimes referred to as
coherent WDM systems [2]. Coherent WDM systems
typically have few subcarriers and do not use training
symbols, but rely on blind channel estimation instead [3].
3. Optical front end
In optical OFDM systems, the front end of the
transmitter consists of an optical modulator, where the
OFDM signal is unconverted to the frequency of an
optical carrier. The front end at the receiver consists of
either a coherent (CO) or a direct detection (DD) scheme.
DD-OFDM is realized by sending the optical carrier
along with the OFDM band so that direct detection with
a single photodiode can be used at the receiver. In a COOFDM system, the optical carrier is suppressed at the
transmitter and a local oscillator (LO) and optical hybrid
is required such as shown in Fig. 2. The superior
performance of CO-OFDM with respect to optical
signal-to-noise ratio requirements, PMD tolerance and
spectral efficiency makes it an excellent candidate for
long-haul transmission systems, whereas DD-OFDM,
which requires fewer components at the receiver than

CO-OFDM, is more suitable for cost-effective short
reach applications.
fc
fc
Frequency
(a) DD-OFDM
Frequency
(b) CO-OFDM
Fig. 1 Optical spectrum of Optical OFDM.
LO
Optical
PD
Hybrid
OFDM
Receiver
Fig. 2 Receiver configuration for CO-OFDM.

4 Optical OFDM transmission experiments
4.1 100-Gbit/s transmission experiment
Recently, in both CO-OFDM [4] and DD-OFDM [5,6]
systems,100 Gbit/s-class transmission experiments were
demonstrated. In order to increase the bit rate to 100
Gbit/s-class, a polarization-division-multiplexing (PDM)
is indispensable for a reduction of the signal bandwidth
which determines the required bandwidth of components
in the transmitter and receiver. In PDM-OFDM
demonstrations, polarization components are separated
digitally by multiple-input and multiple-output (MIMO)
processing [7]. In order to apply the MIMO processing
in DD-OFDM systems, an optical hybrid at the receiver
[5] or a set of two carriers together with specially
designed training signal patterns [6] were introduced.
Our group reported CO-OFDM transmission of 10 x
122 Gbit/s over 1,000-km SSMF without any dispersion
compensation [4]. In this experiment, the 122-Gb/s
OFDM signal consists of two polarization-multiplexed
signals with four subcarrier-multiplexed OFDM bands
each. Together with a non-rectangular 8 QAM
constellation (Fig.5(a)) used for symbol mapping, the
122-Gb/s OFDM signal can be packed in a 23-GHz
bandwidth as shown in Fig. 3. At the receiver, the signal
is coherently detected with an optical hybrid and an
external cavity laser. A real-time digital storage
oscilloscope is used to sample the outputs of the optical
hybrid and the acquired data is post-processed off-line.
Polarization de-rotation can be realized through MIMO
processing and RF-aided phase noise compensation is
also implemented [8]. After 1,000-km transmission, the
obtained BER values for all channels are well below the
threshold of a concatenated FEC code with 7% overhead.
Along the whole link, the OFDM signal is continuously
detectable demonstrating a dispersion tolerance of more
than 18,500 ps/nm. Such a large dispersion tolerance is
attractive for high speed transmission systems as it
eliminates the necessity of inline dispersion
compensation.
symbol (6.3%), cyclic prefix (1.9%) and FEC overhead

(7%). This results in a net bit rate of 56 Gbit/s and
wavelength-division-multiplexing the 56-Gbit/s signals
with an 8 GHz spacing, a spectral efficiency of 7.0
bit/s/Hz was achieved. The achieved spectral efficiency
is the highest in WDM transmission with channel bit rate
of higher than 40 Gbit/s
22.8 G Hz
(a) 8-QAM
(b) 16-QAM
(c) 32-QAM
Fig. 5 Constellation of subcarrier modulation.
Fig. 3 Optical spectrum of 122-Gbit/s OFDM signal.
Spectral Efficiency (bit/s/Hz)
4.2 Highly spectral efficient transmission experiment

OFDM is also suitable for highly spectral efficient
transmission systems, since it offers distinct advantages
compared to other formats. First of all, OFDM is easily
scalable to higher level modulation formats. Secondly
OFDM has negligible linear crosstalk between channels
because of its well defined spectral shape inherently.
Fig. 4 shows the achieved spectral efficiency in recent
demonstrations of DWDM transmission with a channel
bit rate of higher than 40 Gbit/s. In a wide rage of
distances, the highest spectral efficiency is achieved with
optical OFDM, which clearly indicates the suitability of
OFDM in highly spectral efficient transmission systems.
DPSK
DQPSK
BPSKPol.MUX
QPSKPol.Mux
8PSKPol.Mux
16QAMPol.Mux
OFDMPol.Mux
8.0
6.0
Pol. Mux
4.0
Single Pol.
2.0
0.0
100
500
1000
5000
10000
Distance (km)
Fig. 4 Recent DWDM transmission experiments.

Recently, our group reported CO-OFDM transmission
of 8 x 65 Gbit/s over 240-km SSMF with spectral
efficiency of 7.0 bit/s/Hz. [9]. In this experiment, the
use of higher level modulation format of 32-QAM
(Fig.5(c)) enables to increase the bit rate in a PDMOFDM band to 65 Gbit/s, which includes a training
Re lative po w e r [dB]
10
0
Channel spacing = 8 GHz
-10
-20
-30
-40
-50
1 9 2 .7 2
Bandwidth = 6.7 GHz

1 9 2 .7 4 5
1 9 2 .7 7
1 9 2 .7 9 5
O ptic a l fre qu e n c y [T Hz ]
1 9 2 .8 2
Fig. 6 Optical spectrum in 8 x 65-Gbit/s WDM

transmission experiments
Conclusions
In this paper, some important aspects of OFDM fiberoptic transmission systems have been discussed. With
CO-OFDM, a transmission with high bit rate (122
Gbit/s) and high spectral efficiency (7.0 bit/s/Hz) is
demonstrated without any dispersion compensation.
These demonstrations show the suitability of optical
OFDM in high-speed transmission systems with high
spectral efficiency.
Acknowledgement
The author thanks S. Jansen of Nokia Siemens Networks,
Germany, H. Takahashi and A. Al Amin of KDDI R&D
Laboratories for their intensive work on optical OFDM
transmission experiments. The author also thanks S. Akiba, M.
Suzuki and H. Tanaka for their encouragement. This work was
partly supported by the National Institute of Information and
Communications Technology of Japan.
References
[1] J. Armstrong, J. Lightwave Technol., 27, 189-204, 2009.
[2] A. Ellis, et al., OFC/NFOEC2005, OThR4.
[3] H. Masuda et al., OFC/NFOEC2009, PDPB5.
[4] S. Jansen et. al., J. Lightwave Technol., 27, 177-188, 2009.
[5] B. Schmidt, et al., OFC/NFOEC2009, PDPC3.
[6] D.Qian, et. al., OFC/NFOEC2009, PDPD5.
[7] S. Jansen, et al., J. Optical Networking, 7, pp.173-182 2008.
[8] S. Jansen, et al., J. Lightwave Technol., 26, pp.6-15, 2008.
[9] H. Takahashi, et al., OFC/NFOEC2009, PDPB7.

Optical OFDM For High-Speed Transmission: FC FC

Uploaded by

Copyright:

Available Formats

Optical OFDM For High-Speed Transmission: FC FC

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Optical OFDM For High-Speed Transmission: FC FC

Uploaded by

Copyright:

Available Formats

Optical OFDM for High-Speed Transmission

which requires fewer components at the receiver than

Fig. 1 Optical spectrum of Optical OFDM.

Fig. 2 Receiver configuration for CO-OFDM.

symbol (6.3%), cyclic prefix (1.9%) and FEC overhead

Fig. 5 Constellation of subcarrier modulation.

Fig. 3 Optical spectrum of 122-Gbit/s OFDM signal.

Spectral Efficiency (bit/s/Hz)

4.2 Highly spectral efficient transmission experiment

Fig. 4 Recent DWDM transmission experiments.

Channel spacing = 8 GHz

Bandwidth = 6.7 GHz

Fig. 6 Optical spectrum in 8 x 65-Gbit/s WDM

You might also like