Mark Scheme (Pre-Standardisation)

Summer 2008

GCE

GCE Physics (6734/01)

Edexcel Limited. Registered in England and Wales No. 4496750

Registered Office: One90 High Holborn, London WC1V 7BH

General Marking Guidance

All candidates must receive the same treatment. Examiners must mark the
first candidate in exactly the same way as they mark the last.

Mark schemes should be applied positively. Candidates must be rewarded for

what they have shown they can do rather than penalised for omissions.

Examiners should mark according to the mark scheme not according to their
perception of where the grade boundaries may lie.

There is no ceiling on achievement. All marks on the mark scheme should be

used appropriately.

All the marks on the mark scheme are designed to be awarded. Examiners
should always award full marks if deserved, i.e. if the answer matches the
mark scheme. Examiners should also be prepared to award zero marks if the
candidates response is not worthy of credit according to the mark scheme.

Where some judgement is required, mark schemes will provide the principles
by which marks will be awarded and exemplification may be limited.

When examiners are in doubt regarding the application of the mark scheme
to a candidates response, the team leader must be consulted.

Crossed out work should be marked UNLESS the candidate has replaced it
with an alternative response.

Mark scheme notes

Underlying principle
The mark scheme will clearly indicate the concept that is being rewarded, backed up by examples.
It is not a set of model answers.
For example:
(iii)

Horizontal force of hinge on table top

66.3 (N) or 66 (N) and correct indication of direction [no ue]
[Some examples of direction: acting from right (to left) / to the left / West /
opposite direction to horizontal. May show direction by arrow. Do not
accept a minus sign in front of number as direction.]

This has a clear statement of the principle for awarding the mark, supported by some examples
illustrating acceptable boundaries.
1. Mark scheme format
1.1 You will not see wtte (words to that effect). Alternative correct wording should be
credited in every answer unless the ms has specified specific words that must be present.
Such words will be indicated by underlining e.g. resonance
1.2 Bold lower case will be used for emphasis.
1.3 Round brackets ( ) indicate words that are not essential e.g. (hence) distance is
increased.
1.4 Square brackets [ ] indicate advice to examiners or examples e.g. [Do not accept gravity]
[ecf].
2. Unit error penalties
2.1 A separate mark is not usually given for a unit but a missing or incorrect unit will normally
cause the final calculation mark to be lost.
2.2 Incorrect use of case e.g. Watt or w will not be penalised.
2.3 There will be no unit penalty applied in show that questions or in any other question
where the units to be used have been given.
2.4 The same missing or incorrect unit will not be penalised more than once within one
question but may be penalised again in another question.
2.5 Occasionally, it may be decided not to penalise a missing or incorrect unit e.g. the
candidate may be calculating the gradient of a graph, resulting in a unit that is not one
that should be known and is complex.
2.6 The mark scheme will indicate if no unit error penalty is to be applied by means of [no ue].
3. Significant figures
3.1 Use of an inappropriate number of significant figures in the theory papers will normally
only be penalised in show that questions where use of too few significant figures has
resulted in the candidate not demonstrating the validity of the given answer.
3.2 Use of an inappropriate number of significant figures will normally be penalised in the
practical examinations or coursework.
3.3 Using g = 10 m s2 will not be penalised.

4. Calculations
4.1 Bald (i.e. no working shown) correct answers score full marks unless in a show that
question.
4.2 If a show that question is worth 2 marks then both marks will be available for a reverse
working; if it is worth 3 marks then only 2 will be available.
4.3 use of the formula means that the candidate demonstrates substitution of physically
correct values, although there may be conversion errors e.g. power of 10 error.
4.4 recall of the correct formula will be awarded when the formula is seen or implied by
substitution.
4.5 The mark scheme will show a correctly worked answer for illustration only.
4.6 Example of mark scheme for a calculation:
Show that calculation of weight
Use of L W H

Substitution into density equation with a volume and density

Correct answer [49.4 (N)] to at least 3 sig fig. [No ue]

[Allow 50.4(N) for answer if 10 N/kg used for g.]
[If 5040 g rounded to 5000 g or 5 kg, do not give 3rd mark; if conversion to
kg is omitted and then answer fudged, do not give 3rd mark]
[Bald answer scores 0, reverse calculation 2/3]

Example of answer:
80 cm 50 cm 1.8 cm = 7200 cm3
7200 cm3 0.70 g cm-3 = 5040 g
5040 10-3 kg 9.81 N/kg
= 49.4 N
5. Quality of Written Communication
5.1 Indicated by QoWC in mark scheme, placed as first mark.
5.2 Usually it is part of a max mark.
5.3 In SHAP marks for this are allocated in coursework only but this does not negate the
need for candidates to express themselves clearly, using appropriate physics terms.
Likewise in the Edexcel A papers.
6. Graphs
6.1 A mark given for axes requires both axes to be labelled with quantities and units, and
drawn the correct way round.
6.2 Sometimes a separate mark will be given for units or for each axis if the units are
complex. This will be indicated on the mark scheme.
6.3 A mark given for choosing a scale requires that the chosen scale allows all points to be
plotted, spreads plotted points over more than half of each axis and is not an awkward
scale e.g. multiples of 3, 7 etc.
6.4 Points should be plotted to within 1 mm.
Check the two points furthest from the best line. If both OK award mark.
If either is 2 mm out do not award mark.
If both are 1 mm out do not award mark.
If either is 1 mm out then check another two and award mark if both of these OK,
otherwise no mark.
6.5 For a line mark there must be a thin continuous line which is the best-fit line for the
candidates results.

Question
Number
1 (a) i

Answer

Mark

Why speed is unchanged

Force is perpendicular to velocity (OR motion OR instantaneous
displacement) (1)
No work is done / No acceleration in the direction of motion (1)

(a) ii

2x1

Why it accelerates
Direction (of motion) is changing (1)
Velocity is changing

(b)

(1)

2x1

Speed of satellite
Use of a = v2/r

(1)

Correct answer [3.9 x 103 m s-1] (1)

e.g. v = (2.7 x 107 m x 0.56 m s-2)
[Allow 1 mark for = 1.4 x 10-4 rad s-1]

2x1
6

Question
Number
2 (a) i

Answer

Mark

Demonstrating the stationary wave

Move microphone between speaker and wall, perpendicular to
wall
(1)
Oscilloscope trace shows sequence of maxima and minima (1)

(a) ii

2x1

How nodes and antinodes are produced

Superposition (or combination or interference) of incident and
reflected wave
(1)
Antinodes: waves always in phase (OR compressions coincide with
compressions, OR rarefactions with rarefactions), hence
constructive interference (OR reinforcement)
(1)
Nodes: waves always exactly out of phase (OR compressions
coincide with rarefactions), hence destructive interference (OR
cancellation)
(1)
3x1
[In the last two marks, only penalise omission of always once]

(a) iii

Measuring the speed of sound

Measure separation of adjacent nodes (or antinodes) and double
this to get
(1)
Frequency known from signal generator, or measured on CRO (OR
digital frequency meter)
(1)
Detail on measurement of frequency OR wavelength, i.e. measure
several node spacings and divide by the number / measure
several periods on CRO and divide by the number
(1)
Use v = f (1)

(b) i

4x1

Application to concert hall

Little or no sound if you sit at a node (1)

(b) ii

Suggestion involving relevant physics e.g. (1)

Reflected wave not as strong as incident wave, so cancellation at
node incomplete/
Reflected waves arrive from elsewhere, so still some sound at
node/

2x1

Node position depends on wavelength (or frequency) so most

notes will be heard
11

Question
Number
3 (a) i

Answer

Mark

Amplitude and frequency

0.17 m (1)
2x1

(a) ii

0.83 Hz (1)
Maximum velocity
Use of vmax = 2fx0

(1)

Correct answer [0.89, 2 sig fig minimum] (1)

e.g. vmax = 2 x 0.83 Hz x 0.17 m
OR
Use of maximum gradient of h versus t graph
2x1
Answer to 2 sig fig minimum, agreeing with 0.9 to 1 sig fig
(a) iii

Velocity-time graph
Sinusoidal graph, period 1.2 s, with scale on velocity axis and
peak value 0.9 m s-1
(1)
[Phase can be wrong for this mark]
Inverted sine graph

(b) i

(1)

2x1

Definition of SHM
Acceleration (OR resultant force) proportional to displacement
from a fixed point /a = (-) constant x x [with a and x defined] (1)
Acceleration (OR resultant force) directed towards the fixed point
(OR in opposite direction to displacement) /a = - positive
constant x x [with a and x defined]
(1)

(b) ii

Verifying SHM
Read off values of h and a at a number of times
(1)
Subtract equilibrium value from h to get displacement
(1)
Plot acceleration against displacement
(1)
Straight line through the origin
(1)
Negative gradient (or observe acceleration and displacement
have opposite signs)
(1)
OR
Use x = acos(2ft) to calculate displacement at a number of
times
(1)
Using values of a and f from part (a)
(1)
Add equilibrium value of h to give h
(1)
If results agree with values of h from graph it is SHM
(1)

2x1

Max 4
12

Question
Number
4

Answer

Mark

Identification of graphs
C (1)
B (1)
E (1)
D (1)

4x1
4

Question
Number
5(a)

Answer

Mark

Line B
Knot T at 2.4 m

(1)

(a) ii
Knots Q, R, S at 0.6, 1.2, 1.8 m [Allow ecf from wrong position of
knot T]
(1)
2x1
(b)

How model represents the Universe

Knots represent galaxies

(1)

Motion of knots represents expansion of Universe (1)

2x1
(c)

How model illustrates Hubbles law

Speed of a knot is proportional to its distance from P

(1)

Illustrate with reference to distances moved by at least two knots

(1)
Hubble: speed of galaxy is proportional to distance from Earth (1)
(d)

3x1

Defects of the model

Any 2 sensible points
e.g.
Galaxies are not evenly spaced/
Universe is 3 dimensional/
Rate of expansion of Universe is not constant/
Initial spacing of knots is not zero /
Relative sizes of knot and spacing are unrealistic
2x1
9

Question
Number
6(a)

Answer

Mark

Meaning of statement
5.89 x 10-19 J (or work function) is the (minimum) energy needed
to remove an electron from the surface
(1)
Minimum energy specified (consequent mark)

(b) i

(1)

2x1

Calculation of time
Use of E = Pt

(1)

Use of P = IA

(1)

Correct answer [210, 2 sig fig minimum] (1)

e.g. t = (5.89 x 10-19 J)/(0.035 W m-2 x 8 x 10-20 m2)
(b) ii

3x1

How wave-particle duality explains immediate photoemission

QOWC
(1)
Energy not spread out uniformly, but concentrated in bundles (OR
quanta OR photons)
(1)
Photon energy is hf (OR depends on frequency OR is independent
of intensity)
(1)
One photon has enough energy to eject an electron

(1)

An electron which absorbs a photon is ejected at once

(1)
Max 4
9

Question
Number
7(a) i

Answer

Mark

Length of pendulum
Use of T = 2(l/g)

(1)

Correct answer [0.994 m, or 1.01 m if 10 m s-2 used for g] (1)

e.g. l = (9.81 m s-2)(2.00 s / 2)2
(a) ii

2x1

Reason for variation in period

l varies with temperature / g varies from place to place (1)

(a) iii

1x1

Mass-spring system
One relevant statement about what affects T, linked with
appropriate conclusion (1)
Examples:
No, because period doesnt depend on g
No, because mass doesnt change
No, because spring constant doesnt change
Maybe, because spring constant might change with temperature

(b) i

1x1

Calculation of wavelength
Calculation giving 32.6 (mm), 3 sig fig minimum (1)
1x1

e.g. = (3.00 x 108 m s-1)/(9.19 x 109 Hz)

(b) ii

Part of spectrum
Microwaves (1)

(b) iii

1x1

Energy level spacing

Use of E = hf

(1)

Conversion to eV

(1)

Correct answer [3.8 x 10-5] (1)

e.g. E = (6.63 x 10-34 J s)(9.19 x 109 Hz)/(1.60 x 10-19 J eV-1)
Total for paper

3x1
9
60