Scribd
Upload
147 views4 pages

SOD Assay Kit

This document describes a kit for determining superoxide dismutase (SOD) activity. SOD is an antioxidant enzyme that catalyzes the breakdown of superoxide radicals. The kit utilizes a highly water-soluble tetrazolium salt called WST-1 that produces a water-soluble dye when reduced by superoxide radicals. The rate of dye formation can be measured to calculate SOD activity levels based on the enzyme's ability to inhibit superoxide formation. The kit contains solutions, buffers and instructions to set up a colorimetric assay to quantify SOD concentration through absorbance measurements.

Uploaded by

Wayu Kasuriya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
147 views4 pages

SOD Assay Kit

This document describes a kit for determining superoxide dismutase (SOD) activity. SOD is an antioxidant enzyme that catalyzes the breakdown of superoxide radicals. The kit utilizes a highly water-soluble tetrazolium salt called WST-1 that produces a water-soluble dye when reduced by superoxide radicals. The rate of dye formation can be measured to calculate SOD activity levels based on the enzyme's ability to inhibit superoxide formation. The kit contains solutions, buffers and instructions to set up a colorimetric assay to quantify SOD concentration through absorbance measurements.

Uploaded by

Wayu Kasuriya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

19160 SOD determination kit

Application
Superoxide dismutase (SOD), which catalyzes the dismutation of the superoxide anion (O2.-) into hydrogen peroxide
and molecular oxygen, is one of the most important antioxidative enzymes. In order to determine the SOD activity,
several direct and indirect methods have been developed. Among these methods, an indirect method using nitroblue
tetrazolium (NBT) is commonly used due to its convenience and ease of use. However, there are several
disadvantages to the NBT method, such as poor water solubility of the formazan dye and the interaction with the
reduced form of xanthine oxidase. SOD Assay Kit-WST allows very convenient SOD assaying by utilizing Dojindos
highly water-soluble tetrazolium salt, WST-1 (2-(4-Iodophenyl)- 3-(4-nitrophenyl)-5-(2,4-disulfophenyl)- 2Htetrazolium, monosodium salt) that produces a water-soluble formazan dye upon reduction with a superoxide anion.
The rate of the reduction with O2 are linearly related to the xanthine oxidase (XO) activity, and is inhibited by SOD, as
shown in Figure 1. Therefore, the IC50 (50% inhibition activity of SOD or SOD-like materials) can be determined by a
colorimetric method.
Figure 2 shows the absorption spectrum of WST-1 formazan. Since the absorbance at 440 nm is proportional to the
amount of superoxide anion, the SOD activity as an inhibition activity can be quantified by measuring the decrease in
the color development at 440 nm.

Figure 1: Principle of the SOD Assay Kit

Figure 2. Absorption spectrum of WST-1 formazan.

Kit Content
a) WST Solution 5 ml x 1
b) Enzyme Solution 100 l x 1
c) Buffer Solution 100 ml x 1
d) Dilution Buffer 50 ml x 1
e) Manual
Equipment required
a) Plate reader (450 nm filter)
b) 96-well microplate
c) 10 l & 100-200 l pipettes and a multi-channel pipette
d) Incubator
e) Superoxide dismutase (SOD), if necessary for the preparation of an inhibition curve
Preparation of working solutions
a) WST working solution: Dilute 1 ml of WST Solution with 19 ml of Buffer Solution.
b) Enzyme working solution: Centrifuge the Enzyme Solution tube for 5 sec. Mix by pipeting, and dilute 15 l of
Enzyme Solution with 2.5 ml of Dilution Buffer.
c) SOD Solution (for assay monitoring, if necessary): Dilute SOD with Dilution Buffer to prepare SOD Standard
Solution as follows:
200 U/ml, 100 U/ml, 50 U/ml, 20 U/ml, 10 U/ml, 5 U/ml, 1 U/ml, 0.1 U/ml, 0.05 U/ml, 0.01 U/ml, 0.001 U/ml
Methods
Concentrated protein assay
Refer to Table 1 for the amount of solutions in each well. If you are using a SOD standard, set up wells for
it in the same manner as the sample.
1) Add 20 l of sample solution to each sample and blank 2 well, and add 20 l of ddH2O (double distilled
water) to each blank 1 and blank 3 well.
2) Add 200 l of WST Working Solution to each well, and mix.
3) Add 20 l of Dilution Buffer to each blank 2 and blank 3 well.
4) Add 20 l of Enzyme Working Solution to each sample and blank 1 well, and then mix thoroughly*.

5) Incubate the plate at 37 C for 20 min.


6) Read the absorbance at 450 nm using a microplate reader.
7) Calculate the SOD activity (inhibition rate %) using the following equation:
SOD activity (inhibition rate %) = {[(Ablank 1 - Ablank 3) (Asample - Ablank 2)]/ (Ablank 1 - Ablank 3)} x 100
Sample
Blank 1
Blank2*
Sample solution
20 l
20 l
ddH2O
20 l
WST working solution
200 l
200 l
200 l
Enzyme working
20 l
20 l
solution
Dilution buffer
20 l
Table 1: Amount of each solution for sample, blank 1, 2 and 3
*If Sample Solution has visible color, set up separate blank 2 lane.

Blank 3
20 l
200 l

20 l

Notes
1) For an accurate measurement, the use of multiple wells per sample is recommended (see Fig. 3).
2) Since superoxide will be released immediately after the addition of Enzyme Working Solution to a well, use a
multi-channel pipette to avoid the reaction time lag of each well.
3) Inhibition activity can also be determined by a kinetic method. Please determine an incubation time range that
has a linearity of the slope before the assay. A good linearity should be observed up to 20 min. For the
calculation, use the following equation:
SOD activity (inhibition rate %) = {[(S1 - S3) - (SS - S2)] / (S1 S3)} x 100
S1: slope of blank 1
S2: slope of blank 2
S3: slope of blank 3
SS: slope of sample

Figure 3: Sample and blank arrangement on a 96-well plate including SOD standard solutions.

Interfering agents
Reducing agents, such as ascorbic acids and reduced forms of glutathiones, interfere with the SODassay. The
following are the concentrations of materials that cause 10% increase in the O.D. value. Please note that since the
increase in the O.D. values can be subtracted as the O.D. of blank 2, these materials do not interfere with the actual
SOD assay.
Bovine Serum Albumin: 5% w/v
Ascorbic acid:
0.1 mM
Glutathione, reduced form:
5 mM

Inhibition curve

Figure 4: Inhibition curves prepared by WSZ-1 assay with different incubation time
Storage
Please store at 0-5C. WST Working Solution is stable for 2 months at 4C. Enzyme Working Solution is stable for 3
weeks at 4C. Protect WST Solution and WST Working Solution from light.

Precautions and Disclaimer:


This product is for R&D use only, not for drug, household, or other uses. Please consult the Material Safety Data
Sheet for information regarding hazards and safe handling practices.

2014 Sigma-Aldrich Co. LLC. All rights reserved. SIGMA-ALDRICH is a trademark of Sigma-Aldrich Co. LLC, registered in the US and other
countries. Sigma brand products are sold through Sigma-Aldrich, Inc. Purchaser must determine the suitability of the product(s) for their particular
use. Additional terms and conditions may apply. Please see product information on the Sigma-Aldrich website at www.sigmaaldrich.com and/or on
the reverse side of the invoice or packing slip.

You might also like