07 OS86077EN41GLN1 KPI Browser Exercise
07 OS86077EN41GLN1 KPI Browser Exercise
07 OS86077EN41GLN1 KPI Browser Exercise
OS86077EN41GLN1
Issue 2.0
1 (9)
Legal notice
Intellectual Property Rights
All copyrights and intellectual property rights for Nokia training documentation, product
documentation and slide presentation material, all of which are forthwith known as Nokia
Siemens Networks training material, are the exclusive property of Nokia Siemens Networks.
Nokia Siemens Networks owns the rights to copying, modification, translation, adaptation or
derivatives including any improvements or developments. Nokia Siemens Networks has the
sole right to copy, distribute, amend, modify, develop, license, sublicense, sell, transfer and
assign the Nokia training material. Individuals can use the Nokia Siemens Networks training
material for their own personal self-development only, those same individuals cannot
subsequently pass on that same Intellectual Property to others without the prior written
agreement of Nokia Siemens Networks. The Nokia Siemens Networks training material
cannot be used outside of an agreed Nokia Siemens Networks training session for
development of groups without the prior written agreement of Nokia Siemens Networks.
Indemnity
The information in this document is subject to change without notice and describes only the
product defined in the introduction of this documentation. This document is intended for the
use of Nokia Siemens Networks' customers only for the purposes of the agreement under
which the document is submitted, and no part of it may be reproduced or transmitted in any
form or means without the prior written permission of Nokia Siemens Networks. The document
has been prepared to be used by professional and properly trained personnel, and the
customer assumes full responsibility when using it. Nokia Siemens Networks welcomes
customer comments as part of the process of continuous development and improvement of
the documentation.
The information or statements given in this document concerning the suitability, capacity, or
performance of the mentioned hardware or software products cannot be considered binding
but shall be defined in the agreement made between Nokia Siemens Networks and the
customer. However, Nokia Siemens Networks has made all reasonable efforts to ensure that
the instructions contained in the document are adequate and free of material errors and
omissions. Nokia Siemens Networks will, if necessary, explain issues which may not be
covered by the document.
Nokia Siemens Networks' liability for any errors in the document is limited to the documentary
correction of errors. Nokia Siemens Networks WILL NOT BE RESPONSIBLE IN ANY EVENT
FOR ERRORS IN THIS DOCUMENT OR FOR ANY DAMAGES, INCIDENTAL OR
CONSEQUENTIAL (INCLUDING MONETARY LOSSES), that might arise from the use of this
document or the information in it.
This document and the product it describes are considered protected by copyright according
to the applicable laws.
NOKIA Siemens Networks logo is a registered trademark of Nokia Siemens Networks
Corporation.
Other product names mentioned in this document may be trademarks of their respective
companies, and they are mentioned for identification purposes only.
Copyright Nokia Siemens Networks 2008. All rights reserved.
2 (9)
OS86077EN41GLN1
Issue 2.0
Contents
1
1.1
1.2
1.3
1.4
1.5
1.6
1.7
1.8
Further Reading......................................................................................9
OS86077EN41GLN1
Issue 2.0
3 (9)
1.1
1.2
How can you select all KPI/PIs of the Availability Performance folder in
one step? Note: The limit is 50 counters.
Solution
4 (9)
OS86077EN41GLN1
Issue 2.0
Deselect all KPI/PIs in one step. Which tabs are now shown in the
navigation tree?
Solution
Result
Select two KPIs/PIs of your own choice from the MGW Availability
Performance Measurement, counter_1 and counter_2. The condition
is, that the measurements values of these counters have to be unequal
to zero. Which counters do you choose for the further proceeding?
Solution
Counter_1
Counter_2
1.3
1.4
OS86077EN41GLN1
Issue 2.0
5 (9)
1.5
1.6
In the Time tab select now Hour for the Summary Level and view this
KPI/PI report. How many ORACLE database requests have to be done
for the reports on hourly summary level and on daily summary level?
Solution
Hourly level
Daily level
How many rows and cells are displayed in the tabular part of the
Availability Performance view?
Solution
Result
How can view the Availability Performance not displayed in the tabular
KPI report?
Solution
6 (9)
OS86077EN41GLN1
Issue 2.0
Change the sorting order of the table so that you see the last time value
in the top of the Availability Performance table.
Solution
Sort now your Availability Performance table so that you see the highest
value of the counter_1 at the top of the table. How does the sorting
influence the graphical KPI/PI report?
Solution
Result
1.7
2.
In a first step only the values of counter_1 are to be displayed in the KPI
report.
Drill operations
Result
Now filter the day with the highest value for counter_1.
Drill operations
Result
Zoom in that day so that you see hourly results for the whole day.
Drill operations
Result
OS86077EN41GLN1
Issue 2.0
7 (9)
Now we want to find out which unit contributes mostly to the maximum
values of counter_1. How can you do this with the drilling buttons?
Drill operation 1
Result
Drill operation 3
Result
Show the same graph for the day before (or after).
Drill operation 1
Drill operation 2
Drill operation 3
Result
1.8
Bookmarking
Create a bookmark for your PI/KPI query. Verify the result.
Solution
Result
8 (9)
OS86077EN41GLN1
Issue 2.0
Further Reading
KPI Browser Help (Online Document)
OS86077EN41GLN1
Issue 2.0
9 (9)