Reconfigurable Microstrip Patch Antenna With Switchable Polarization

Progress In Electromagnetics Research, PIER 75, 6368, 2007
RECONFIGURABLE MICROSTRIP PATCH ANTENNA

WITH SWITCHABLE POLARIZATION
W. B. Wei, Q. Z. Liu, Y. Z. Yin, and H. J. Zhou
National Key Laboratory of Antennas and Microwave Technology
Xidian University
Xian 710071, Shaanxi, China
AbstractA new recongurable microstrip patch antenna allowing
switching between two circular polarizations is proposed. It consists
of a square radiating patch and a 3 dB hybrid coupler. Using only a
single-polar-double-throw (SPDT) switch, the polarization switching
can be achieved. This design of the dc-bias network is extremely
simple. From experimental results, the proposed antenna avoids the
frequency oset phenomena which often happened to antennas with
switchable polarization.
1. INTRODUCTION
In wireless communication systems applications, circular polarization
antenna systems play important roles. In satellite communication
systems, they are very suitable because of their insensitivity to
transmitter and receiver orientations [1]. They are also utilized to
realize frequency reuse for doubling the system capability [2]. In
polarization diversity, circular polarizations can be used to avoid the
detrimental fading loss caused by multi-path eects [3]. In microwave
tagging systems, it is used as a modulation scheme such as the
circular polarization modulation [4]. Recently, recongurable antennas
have attracted signicant attention [59]. Especially, recongurable
antennas with switchable polarization have become the focus of
research. To obtain the switching property between left and righthand circular polarization (LHCP/RHCP), in most of the related
designs, varactor diodes or PIN diodes are used to alternatively short
antenna conguration with additional perturbation segments [912].
In these designs, two problems are often encountered. One is that
excessive diodes will lead to a complex dc-bias network. In order to
provide independent bias for each diode, the dierent biases have to
64
Wei et al.
be separated by some special mechanisms, such as using capacitors

[3, 9], adding insulating layers [11], and etching thin slits on the patch
or ground plane [10, 12, 13]. The other problem is frequency oset
caused by polarization switching [1214]. The phenomenon is usually
not accepted for antenna with narrow band operating.
In this paper, a new microstrip patch antenna allowing switching
between LHCP and RHCP is proposed. The LHCP/RHCP radiation
is generated by simultaneously exciting two orthogonal modes with
equal amplitude and a 90 phase dierence. The two modes are fed
by a 3 dB 90 hybrid coupler. By using a SPDT switch to shift the
input port of the coupler, the phase dierence between the two outputs
of the coupler can be switchable between 90 , then the polarization
switching between LHCP and RHCP can be achieved.
In this design, only a SPDT switch is employed, thus the dc-bias
network is very simple (shown in Fig. 1). Because the circular polarized
radiation of the antenna is generated by two orthogonal modes at a
same resonant frequency, the frequency oset phenomenon which often
happened to antennas with switchable polarization can be avoided.
Figure 1. Conguration of the square microstrip patch antenna

with switchable polarization and a coordinate system. l = 180 mm,
w = 120 mm, l1 = 61.34 mm, l2 = 70 mm.
2. ANTENNA CONFIGURATION
The conguration of the proposed antenna is shown in Fig. 1. It is
mainly composed of a radiating patch, a 3 dB 90 hybrid coupler and an
Progress In Electromagnetics Research, PIER 75, 2007
65
FET SPDT switch. The antenna is built on a 0.76 mm thick TaconicTLX substrate with relative permittivity of r = 2.55. The side length
of the square radiating patch is 61.34 mm, and the resonance frequency
related to the length is 1.5175 GHz. In order to match the patch to the
50 lines of the coupler, two narrow 134.2 lines with each length of
14.8 mm have been introduced as impedance transformers. The 3 dB
hybrid coupler is operated at 1.5175 GHz. Its four ports are shown in
Fig. 1 (denoted as Port1, Port2, Port3, and Port4 respectively). The
insert loss of Port3 and Port4 is about 3.17 dB. The phase dierence
of the two ports is 90 approximately at 1.5175 GHz. The isolation
between Port1 and Port2 is below 41.7 dB.
Figure 2. Insert loss and isolation of SPDT switch.

In Fig. 1, an FET SPDT switch is placed between the coupler
and the input port of the antenna (denoted as P0). Its insert loss and
isolation are plotted in Fig. 2. When dc-bias voltages are V2 = 3.5 V
and V1 = 0 V, P0 is connected with Port1. The phase dierence
between Port3 and Port4 of the coupler is +90 . In this case, the
proposed antenna is denoted as antenna 1. Reversely, when dc-bias
voltages are V1 = 3.5 V and V2 = 0 V, P0 is connected with Port2.
The phase dierence between Port3 and Port4 is 90 . In the case,
the antenna is denoted as antenna 2. Therefore, the phase dierence
of two orthogonal modes for circular polarization can be switched
between +90 and 90 , and the proposed antenna has the property
of polarization switching between LHCP and RHCP.
3. EXPERIMENTAL RESULTS
Figure 3 shows the measured return losses of the proposed antenna.
Because antenna 1 and antenna 2 have the same geometry, their
return losses are extremely uniform (shown in Fig. 3). Both resonant
frequencies of them are 1.5175 GHz. It is clear that the proposed
66
Wei et al.
Figure 3. Measured return losses of antenna 1 and antenna 2.
Figure 4. Measured radiation patterns in x-z plane and y-z plane for
antenna 1 at 1.5175 GHz.
antenna could eliminate the frequency oset phenomenon.
For these two antennas, the radiation patterns are measured at the
resonant frequency 1.5175 GHz. Fig. 4 and Fig. 5 show the measured
gain patterns of antenna 1 and antenna 2. The measured gains are
5.12 dB and 5.26 dB respectively. From experimental results, antenna
1 has a RHCP pattern. Its co-polarization and cross polarization
patterns at x-z plane and y-z plane are given in Fig. 4. The cross
polarization levels for antenna 1 remain below 15.9 dB, and the axial
ratio is about 1.38 dB. Compared with antenna 1, antenna 2 exhibits
a LHCP whose radiation pattern is similar to the radiation pattern of
antenna 1. Its measured radiation patterns are plotted in Fig. 5. The
Progress In Electromagnetics Research, PIER 75, 2007
67
Figure 5. Measured radiation patterns in x-z plane and y-z plane for
antenna 2 at 1.5175 GHz.
cross polarization levels for antenna 2 remain below 14.2 dB, and the
axial ratio is about 1.59 dB. Obviously, the proposed antenna is able
to switch between LHCP and RHCP. In addition, the performances
of the proposed antenna in two cases are almost same, such as return
losses and radiation patterns.
4. CONCLUSION
A switchable microstrip patch antenna with high potentiality is
proposed. The idea of this design is very simple. By using only
a SPDT switch, the proposed antenna can be operated in left or
right-hand circular polarization according to dc-bias voltages. The dcbias network is relatively simple. From the experimental results, the
performances of the proposed antenna agree well in the LHCP case
and the RHCP case. It is very suitable for wireless communication
systems applications.
REFERENCES
1. Chang, F.-S., K.-L. Wong, and T.-W. Chiou, Low-cost broadband circularly polarized patch antenna, IEEE Transactions on
Antennas and Propagation, Vol. 51, 30063009, October 2003.
2. Yang, X.-X. and S.-S. Zhong, Analysis of two dual-polarization
square-patch antennas, Microwave and Optical Technology
Letters, Vol. 26, No. 3, 153156, August 2000.
3. Yang, F. and Y. Rahmat-Samii, A recongurable patch antenna
68
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Wei et al.
using switchable slots for circular polarization diversity, IEEE

Microwave and Wireless Components Letters, Vol. 12, 9698,
March 2002.
Kossel, M. A., R. Kung, H. Benedickter, and W. Biichtokd, An
active tagging system using circular-polarization modulation,
IEEE Transactions on Microwave Theory and Techniques, Vol. 47,
No. 12, 22422248, December 1999.
Alkanhal, M. and A. F. Sheta, A novel dual-band recongurable
square-ring microstrip antenna, Progress In Electromagnetics
Research, PIER 70, 337349, 2007.
Shynu, S. V., G. Augustin, C. K. Aanandan, P. Mohanan,
and K. Vasudevan, Design of compact recongurable dual
frequency microstrip antenna using varactor diodes, Progress
In Electromagnetics Research, PIER 60, 197205, 2006.
Wu, W. and Y.-H. Bi, Switched-beam planar fractal antenna,
Journal of Electromagnetic Waves and Applications, Vol. 20,
No. 3, 409415, 2006.
Wu, W., B.-Z. Wang, and S. Sun, Pattern recongurable
microstrip patch antenna, Journal of Electromagnetic Waves and
Applications, Vol. 19, No. 1, 107113, 2005.
Chen, Y. B., T. B. Chen, Y. C. Jiao, and F. S. Zhang, A
Recongurable microstrip antenna with switchable polarization,
Journal of Electromagnetic Waves and Applications, Vol. 20,
No. 10, 2006.
Fries, M. K., M. Grani, and R. Vahldieck, A recongurable
slot antenna with switchable polarization, IEEE Microwave and
Wireless Components Letters, Vol. 13, No. 11, 490492, November
2003.
Haskins, P. M. and J. S. Dahele, Varactor-diode loaded passive
polarisation-agile patch antenna, Electronics Letters, Vol. 30,
10741075, June 1994.
Ho, M. H., M. T. Wu, C. G. Hsu, and J. Y. Sze, An RHCP/LHCP
switchable slotline-fed slot-ring antenna, Microwave and Optical
Technology Letters, Vol. 46, 3033, 2005.
Boti, M., L. Dussopt, and J.-M. Laheurte, Circularly polarised
antenna with switchable polarisation sense, Electronics Letters,
Vol. 36, 15181519, August 2000.
Nanbo, J., Y. Fan, and Y. Rahmat-Samii, A novel recongurable
patch antenna with both frequency and polarization diversities for
wireless communications, 2004 IEEE Antennas and Propagation
Society International Symposium, Vol. 2, 17961799, June 2004.

Reconfigurable Microstrip Patch Antenna With Switchable Polarization

Uploaded by

Copyright:

Available Formats

Reconfigurable Microstrip Patch Antenna With Switchable Polarization

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Reconfigurable Microstrip Patch Antenna With Switchable Polarization

Uploaded by

Copyright:

Available Formats

Progress In Electromagnetics Research, PIER 75, 6368, 2007

RECONFIGURABLE MICROSTRIP PATCH ANTENNA

be separated by some special mechanisms, such as using capacitors

Figure 1. Conguration of the square microstrip patch antenna

Progress In Electromagnetics Research, PIER 75, 2007

Figure 2. Insert loss and isolation of SPDT switch.

Figure 3. Measured return losses of antenna 1 and antenna 2.

Progress In Electromagnetics Research, PIER 75, 2007

using switchable slots for circular polarization diversity, IEEE

You might also like