Scribd
Upload
157 views2 pages

Electronic Production Design

This document outlines the parts and questions for an examination on electronic product design. Part A contains 8 short answer questions covering definitions of technology and engineering, product life cycles, differences between industrial and engineering design, bills of materials, heat sinks, heat transfer schemes, EMI standards, and heat pipes. Part B contains 4 longer answer questions about product conceptualization, differences between ideal and real problem solving, near and far fields and their significance, nulls and polarization, and explanations of rectangular aperture, circular aperture, and horn antennas.

Uploaded by

arunan55
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
157 views2 pages

Electronic Production Design

This document outlines the parts and questions for an examination on electronic product design. Part A contains 8 short answer questions covering definitions of technology and engineering, product life cycles, differences between industrial and engineering design, bills of materials, heat sinks, heat transfer schemes, EMI standards, and heat pipes. Part B contains 4 longer answer questions about product conceptualization, differences between ideal and real problem solving, near and far fields and their significance, nulls and polarization, and explanations of rectangular aperture, circular aperture, and horn antennas.

Uploaded by

arunan55
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

B. Tech.

Degree VII Semester Examination

EC 704 ELECTRONIC PRODUCT DESIGN

(2006 Scheme)
Time: 3 Hours Maximum Marks: 100

PART – A
(Answer ALL questions)

( 8 × 5= 40 )
I.
a) Write the definitions of Technology and Engineering.
b) Define Product life cycle.
c) How is industrial design different from engineering design
d) What is meant by BOM explain.
e) Writes short notes on Heat sinks.
f) Explain different heat transfer schemes.
g) Write notes on EMI standards.
h) Explain heat pipes.

PART – B
(4×15=60)

II.
(a) What is product conceptualization? `
(b) With appropriate examples discuss the differences between ideal problem
solving and real life problem solving

OR

III.
(a)Explain the near and far fields for a Radiator/ Antenna and describe its
significance.
(b) Write a short note on
(i) Nulls.
(ii) Polarization.

I. Explain the following microwave antennas


(a) Rectangular aperture
(b) Circular aperture
(c) Horn antenna
OR
II. Draw the radiation pattern of an array of two isotropic point sources of same
amplitude and phase. Explain with necessary equations.

III. Write a short note on


(a) Skip distance
(b) MUF
(c) Fading

OR
IV.
(a) Discuss the effect of earth’s magnetic field on ionospheric radio wave
communication.
(b) Describe the nature of ionosphere behavior during day and night.

V.
(a) Briefly explain how the Doppler effect is put to use in finding the velocity
of a moving target.
(b) Write a short note Electronic Counting Measure.
OR
VI.
(a) Derive the RADAR Range equation.
(b) What are the applications of Radar.

You might also like