Passenger Safety Briefing
Passenger Safety Briefing
Passenger Safety Briefing
Seatbelts
This is the item explicitly required
in the regulations, so it is a good place
to start your passenger briefing. The
regulations give the pilot in command
(PIC) two specific tasks with regard to
seat belts and shoulder harnesses.
The first is a duty to brief passengers
on how the seat belts work. You cannot legally take off unless:
the pilot in command of
that aircraft ensures that each
person on board is briefed on
how to fasten and unfasten
that persons seat belt and, if
installed, shoulder harness.
(14 CFR 91.107(a)(1)).
The second statutory requirement
is a duty to notify passengers that seat
belts must be fastened. Specifically,
the rule states that no pilot may take
off, land, or cause (an aircraft) to be
moved on the surface unless:
the pilot in command of
that aircraft ensures that each
person on board has been
In addition to these required topics, it is a good idea to brief your passengers on how to adjust and lock the
seat position. This discussion is especially important for the passenger in
the right front seat. Just imagine how
startling (not to mention dangerous) it
would be for everyone aboard if an
unbriefed and unsecured passenger
reacted to sudden rearward seat travel
by instinctively grabbing the yoke.
Air
You want your passengers to be
comfortable during the flight, so the
second major item to include in your
briefing is environmental controls.
Show your passengers where the air
vents are located, and tell them how
to open and close overhead and/or
floor-level vents in their seating area.
Many GA airplanes have other environmental controls (e.g., cabin heat)
Fire Extinguisher
Fires can, and do, occur in GA airplanes, especially with engine starts.
You obviously dont want to scare
your passengers, but the extra pair of
hands could be very useful if you find
yourself fighting flames during any part
of the flight. If you have a fire extinguisher on boardyou do, right?
show your passengers where it is located, how to unlatch it from its
mount, and how to use it in the unlikely event of a fire.
traffic any time you are in visual meteorological conditions (VMC). It never
hurts to have extra eyes scanning for
traffic, so brief your passengers to let
you know whenever they spot other
aircraft. In addition, tell them what you
want them to tell you. A simple airplane on the right will suffice, but
since everyone can visualize a clock,
you might ask them to given you traffic
information in terms of the oclock
positions used by ATC. The added
advantage of this option is that passengers listening to ATC communications will have a better idea of where to
look when you get a traffic call.
Expectations for communications
talkingare another good topic to
include in your passenger briefing.
Passengers may not readily understand the term sterile cockpit, but
they will certainly understand that
there are times when you need to
focus fully on your flying. Let your
passengers know that they should not
attempt to talk to you (except for traffic point-outs) during the busy takeoff/climb and approach/landing
phases of the flight. If your intercom
does not permit you to isolate the
crew, let passengers know if you expect them to minimize their own conversation during these times.
Your Questions?
Even if you are operating under instrument flight rules (IFR), you still have
a responsibility to see and avoid other
Susan Parson is a special assistant in Flight Standards General Aviation and Commercial Division.
JANUARY/FEBRUARY 2007