5/09/2008

Asymmetric Digital Subscriber Line -

Help us provide free content to the world by donating today!

Asymmetric Digital Subscriber Line

From Wikipedia, the free encyclopedia

(Redirected from ADSL)

Asymmetric Digital Subscriber Line (ADSL) is a form of DSL, a
data communications technology that enables faster data transmission
over copper telephone lines than a conventional voiceband modem can
provide. It does this by utilizing frequencies that are not used by a voice
telephone call. A splitter - or microfilter - allows a single telephone
connection to be used for both ADSL service and voice calls at the same
time. Because phone lines vary in quality and were not originally
engineered with DSL in mind, it can generally only be used over short
distances, typically less than 4km[1].
At the telephone exchange the line generally terminates at a DSLAM
where another frequency splitter separates the voice band signal for the
conventional phone network. Data carried by the ADSL is typically
routed over the telephone company's data network and eventually
reaches a conventional internet network. In the UK under British
Telecom the data network in question is its ATM network which in turn
sends it to its IP network IP Colossus.

A gateway is commonly used

to make an ADSL connection.
The model pictured is also a
wireless access point, hence
the antenna.

Contents
1 Explanation
2 How ADSL works
2.1 On the wire
2.2 Modulation
3 ADSL standards
4 Installation issues
5 See also
6 Notes
7 References
8 External links

Explanation
The distinguishing characteristic of ADSL over other forms of DSL is that the volume of data flow is greater
in one direction than the other, i.e. it is asymmetric. Providers usually market ADSL as a service for
consumers to connect to the Internet in a relatively passive mode: able to use the higher speed direction for
the "download" from the Internet but not needing to run servers that would require high speed in the other
http://en.wikipedia.org/wiki/ADSL

1/5

5/09/2008

Asymmetric Digital Subscriber Line -

direction.
There are both technical and marketing reasons why ADSL is in many places the most common type offered
to home users. On the technical side, there is likely to be more crosstalk from other circuits at the DSLAM
end (where the wires from many local loops are close to each other) than at the customer premises. Thus the
upload signal is weakest at the noisiest part of the local loop, while the download signal is strongest at the
noisiest part of the local loop. It therefore makes technical sense to have the DSLAM transmit at a higher bit
rate than does the modem on the customer end. Since the typical home user in fact does prefer a higher
download speed, the telephone companies chose to make a virtue out of necessity, hence ADSL. On the
marketing side, limiting upload speeds limits the attractiveness of this service to business customers, often
causing them to purchase higher cost Digital Signal 1 services instead. In this fashion, it segments the digital
communications market between business and home users.

How ADSL works

On the wire
Currently, most ADSL communication is full duplex. Full duplex ADSL communication is usually achieved on
a wire pair by either frequency division duplex (FDD), echo canceling duplex (ECD), or time division
duplexing (TDD). FDM uses two separate frequency bands, referred to as the upstream and downstream
bands. The upstream band is used for communication from the end user to the telephone central office. The
downstream band is used for communicating from the central office to the end user.
With standard ADSL (annex A), the band from 25.875 kHz to 138 kHz
is used for upstream communication, while 138 kHz 1104 kHz is used
for downstream communication. Each of these is further divided into
smaller frequency channels of 4.3125 kHz. During initial training, the
ADSL modem tests which of the available channels have an acceptable
signal-to-noise ratio. The distance from the telephone exchange, noise on
the copper wire, or interference from AM radio stations may introduce
errors on some frequencies. By keeping the channels small, a high error
rate on one frequency thus need not render the line unusable: the channel
will not be used, merely resulting in reduced throughput on an otherwise
functional ADSL connection.

Frequency plan for ADSL.

The red area is the frequency
range used by normal voice
telephony (PSTN), the green
(upstream) and blue
(downstream) areas are used
for ADSL.

Vendors may support usage of higher frequencies as a proprietary

extension to the standard. However, this requires matching vendorsupplied equipment on both ends of the line, and will likely result in crosstalk problems that affect other lines
in the same bundle.
There is a direct relationship between the number of channels available and the throughput capacity of the
ADSL connection. The exact data capacity per channel depends on the modulation method used.

Modulation
ADSL initially existed in two flavours (similar to VDSL), namely CAP and DMT. CAP was the de facto
standard for ADSL deployments up until 1996, deployed in 90 percent of ADSL installs at the time.
However, DMT was chosen for the first ITU-T ADSL standards, G.992.1 and G.992.2 (also called G.dmt
http://en.wikipedia.org/wiki/ADSL

2/5

5/09/2008

Asymmetric Digital Subscriber Line -

and G.lite respectively). Therefore all modern installations of ADSL are based on the DMT modulation
scheme.

ADSL standards
Standard name

Common name

Downstream rate

Upstream rate

ANSI T1.413-1998 Issue 2 ADSL

8 Mbit/s

1.0 Mbit/s

ITU G.992.1

ADSL (G.DMT)

12 Mbit/s

1.3 Mbit/s

ITU G.992.1 Annex A

ADSL over POTS

12 Mbit/s

1.3 MBit/s

ITU G.992.1 Annex B

ADSL over ISDN (IDSL) 12 Mbit/s

1.8 MBit/s

ITU G.992.2

ADSL Lite (G.Lite)

1.5 Mbit/s

0.5 Mbit/s

ITU G.992.3/4

ADSL2

12 Mbit/s

1.0 Mbit/s

ITU G.992.3 Annex J

ADSL2

12 Mbit/s

1.0 Mbit/s

ITU G.992.3 Annex L[2]

RE-ADSL2

5 Mbit/s

0.8 Mbit/s

ITU G.992.5

ADSL2+

24 Mbit/s

1.0 Mbit/s

ITU G.992.5 Annex M

ADSL2+M

24 Mbit/s

3.5 Mbit/s

Annexes J and M shift the upstream/downstream frequency split up to

276 kHz (from 138 kHz used in the commonly deployed annex A) in
order to boost upstream rates. Additionally, the "all-digital-loop" variants
of ADSL2 and ADSL2+ (annexes I and J) support an extra 256 kbit/s of
upstream if the bandwidth normally used for POTS voice calls is
allocated for ADSL usage.
While the ADSL access utilizes the 1.1 MHz band, ADSL2+ utilizes the
2.2 MHz band.

Frequencies spectrum of a
Fritz modem on an ADSL
Belgian line.

The downstream and upstream rates displayed are theoretical maxima.

Note also that because Digital subscriber line access multiplexers and ADSL modems may have been
implemented based on differing or incomplete standards some manufacturers may advertise different speeds.
For example, Ericsson has several devices that support non-standard upstream speeds of up to 2 Mbit/s in
ADSL2 and ADSL2+.

Installation issues
Due to the way it uses the frequency spectrum, ADSL deployment presents some issues. It is necessary to
install appropriate frequency filters at the customer's premises, to avoid interferences with the voice service,
while at the same time taking care to keep a clean signal level for the ADSL connection.
In the early days of DSL, installation required a technician to visit the premises. A splitter was installed near
the demarcation point, from which a dedicated data line was installed. This way, the DSL signal is separated
earlier and is not attenuated inside the customer premises. However, this procedure is costly, and also
caused problems with customers complaining about having to wait for the technician to perform the
http://en.wikipedia.org/wiki/ADSL

3/5

5/09/2008

Asymmetric Digital Subscriber Line -

installation. As a result, many DSL vendors started offering a self-install option, in which they ship equipment
and instructions to the customer. Instead of separating the DSL signal at the demarcation point, the opposite
is done: the DSL signal is "filtered off" at each phone outlet by use of a low pass filter, also known as
microfilter. This method does not require any rewiring inside the customer premises.
A side effect of the move to the self-install model is that the DSL signal can be degraded, especially if more
than 5 voiceband devices are connected to the line. The DSL signal is now present on all telephone wiring in
the building, causing attenuation and echo. A way to circumvent this is to go back to the original model, and
install one filter upstream from all telephone jacks in the building, except for the jack to which the DSL
modem will be connected. Since this requires wiring changes by the customer and may not work on some
household telephone wiring, it is rarely done. It is usually much easier to install filters at each telephone jack
that is in use.

See also
British telephone sockets
Broadband Internet access
Digital Subscriber Line for further details and other varieties
Digital subscriber line access multiplexer
ADSL loop extender can be used to expand the reach and rate of ADSL services.
Filter and splitter.
Symmetric Digital Subscriber Line
Rate-Adaptive Digital Subscriber Line (RADSL)
Flat rate
Attenuation distortion
ADSL max
List of device bandwidths

"otes
1. ^ Data and Computer Communications, William Stallings, ISBN-10: 0132433109, ISBN-13: 978-0132433105
2. ^ ADSL2 Annex L is also known as RE-ADSL2, where 'RE' stands for 'Reach Extended.' With this ADSL standard,
the power of the lower frequencies used for transmitting data is boosted up to increase the reach of this signal up
to 7 kilometers (23,000 ft). The upper frequency limit for RE-ADSL2 is reduced to 552 kHz to keep the total power
roughly the same as annex A. Since RE-ADSL2 is intended for use on long loops there isn't much (any) usable
bandwidth above 552 kHz anyway. Although this standard has been ratified by the ITU, not all local loop network
maintainers allow this protocol to be used on their network, lest the extra power on the lower frequencies cause
problems for existing services due to crosstalk.

References
External links
ADSL Theory (http://whirlpool.net.au/wiki/?tag=ADSL_Theory) Good information about the
background & workings of ADSL, and the factors involved in achieving a good sync between your
modem and the DSLAM.
Free calculator used by telephone companies to compute bandwidth vs. distance
(http://www.strowger.com/Widearea-ADSL-Loop-Extender/37-Loop-Extender-for-ADSL/61http://en.wikipedia.org/wiki/ADSL

4/5

5/09/2008

Asymmetric Digital Subscriber Line -

(http://www.strowger.com/Widearea-ADSL-Loop-Extender/37-Loop-Extender-for-ADSL/61adsl2-bandwidth-estimator.html)
The UNH-IOL DSL Knowledge Base (advanced tutorials) (http://www.iol.unh.edu/training/dsl/)
ADSL, ADSL2 and ADSL2+ Speeds and Reach Compared
(http://www.internode.on.net/adsl2/graph/)
ADSL Research Report (http://www.esatclear.ie/~aodhoh/adsl/report.html)
ADSL Tutorial (http://www2.rad.com/networks/2005/adsl/main.htm)
DSL How-To (http://www.tldp.org/HOWTO/DSL-HOWTO/) Complete guide from scratch; how to
install cabling & service, and configure a Linux-based machine as an advanced/sophisticated router.
Various ADSL Technical Information
(http://www.systemtek.co.uk/TechDocs/Telecom_General/ADSL_Tech_docs.htm)
History of DSL (http://www.thehistoryof.net/history-of-dsl.html)
Retrieved from "http://en.wikipedia.org/wiki/Asymmetric_Digital_Subscriber_Line"
Categories: ITU-T recommendations | Digital Subscriber Line
Hidden categories: Articles lacking sources from June 2008 | All articles lacking sources
This page was last modified on 28 August 2008, at 18:36.
All text is available under the terms of the GNU Free Documentation License. (See Copyrights for
details.)
Wikipedia is a registered trademark of the Wikimedia Foundation, Inc., a U.S. registered 501(c)(3)
tax-deductible nonprofit charity.

http://en.wikipedia.org/wiki/ADSL

5/5