Pole Base DRM Design Charts

Download as pdf or txt
Download as pdf or txt
You are on page 1of 9
At a glance
Powered by AI
The document discusses design guidelines for pole bases including minimum embedment depths for round and square poles based on various soil and loading conditions.

The design guide provides preliminary estimates for conceptual planning purposes only and is not intended for actual construction. A licensed engineer must perform final designs using actual site conditions.

A basic wind speed of 90 mph was assumed along with exposure and height factors. Gust effect and drag coefficients were also specified for different pole and fixture types.

DESIGN CHARTS

SECTION 4: DESIGN CHARTS


Notice
Pole Base Foundation Design Guide
Minimum Embedment Guide - Round
Minimum Embedment Guide - Square
Example Calculation

THE HARD PART IS ALREADY DONE


2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary or Redi-Rock International.
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.1
4.2
4.3
4.4
4.5-8

Important Notice
The design specifications for Pole BaseTM units suggest earth embedment depths with
certain assumed conditions. The earth embedments were calculated using the assumed
material properties and loading conditions described in the Design Resource Manual.
These will vary from location to location depending upon the soil properties and terrain.
Since soil conditions and topography vary greatly from site to site, a detailed engineering
analysis must be performed for each Pole BaseTM installation.
Because Pole BaseTM does not manufacture nor install these units, it does not assume
any responsibility regarding structural suitability of its products for any particular project.
In addition, Pole BaseTM assumes no responsibility in connection with any injury, death,
or property damage claim whatsoever whether asserted against a Leasee, Leasor,
Purchaser or others, arising out of or attributable to the operation of or produced with
Pole BaseTM equipment.

2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary or Redi-Rock International.

4.1

Revised: 3 September 2014

2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

Pole BaseTM Foundation Design Guide


Analysis Methods:

This Guide was prepared for preliminary estimating and conceptual purposes only. All
information is believed to be true and accurate; however, Pole BaseTM assumes no
responsibility for the use of this design guide for actual construction. Determination of the
suitability of each chart is the sole responsibility of the user. Final designs for construction
purposes must be performed by a licensed Professional Engineer, using the actual conditions of
the site.
The foundation design guide for embedment of the round concrete poles is based upon the
provisions described in the American Association of State Highway and Transportation Officials
(AASHTO) publication: Standard Specifications for Structural Supports for Highway Signs,
Luminaries, and Traffic Signals, 6th Edition, 2013 (LTS-6), Washington, DC.

Wind Loading Assumptions:

The wind loading on the fixtures, poles, and bases is based upon Section 3.8 Wind Load
The Basic Wind Speed Section 3.8.2. Assumed wind speed 90 mph (40 m/s).
The following factors and assumptions were used in the creation of the guide. These factors will
need to be analyzed and verified by the Licensed Professional Engineer of the project:
Wind Importance Factor, Ir = 1.00 (Section 3.8.3)
Velocity Conversion Factor, Cv = 1.00 (Table 3.8.3-3)
Height and Exposure Factor, Pole & Fixture Kz = 1.00; Base Kz = 0.86 (Section 3.8.4)
Gust Effect Factor, G=1.14 (Section 3.8.5)
Drad Coefficients, Cd: (Table 3.8.6-1)
Light Fixture, Cd=1.2
Light Pole, 6 square, Cd=1.875; 6 round, Cd= 0.915
Pole Base (40 tall), 24 square, Cd=1.75; 24 round, Cd= 0.45

Foundation Design Assumptions:

The formulas for the earth embedment depth are based upon Section 13: Foundation Design.
The following factors and assumptions were used in the creation of the guide. These factors will
need to be analyzed and verified by the Licensed Professional Engineer of the project:
Dense backfill around the base: 2000 psi concrete, Well compacted clean sand, or
(CLSM).
Minimum earth embedment of Pole BaseTM units is at least: the calculated value, 3-0
(0.9 m), or the depth of local frost penetration.
Overload Factor = 2.5; Undercapacity Factor = 0.7 (Section C13.6.1.1)
Embedment Length in Granular Soil, Equation (C13.6.1.1-3)
Embedment Length in Cohesive Soil, Equation (C13.6.1.1-7)

2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary or Redi-Rock International.

4.2

Revised: 3 September 2014

2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.3Base is a wholly owned subsidiary or Redi-Rock International.


2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.4
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole
Base is a wholly owned subsidiary or Redi-Rock International.
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.5Base is a wholly owned subsidiary or Redi-Rock International.


2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.6
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole
Base is a wholly owned subsidiary or Redi-Rock International.
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.7Base is a wholly owned subsidiary or Redi-Rock International.


2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

4.8
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole
Base is a wholly owned subsidiary or Redi-Rock International.
2014 Redi-Rock International, L.L.C. All Rights Reserved. Pole Base is a wholly owned subsidiary of Redi-Rock International.

You might also like