Radio Communication Faliure

91.06.
16
1.
MANDATORY RADIO COMMUNICATIONS
Radio communication failure (RCF) procedures General

(1) When an aircraft fails to establish contact with the aeronautical station on
the designated frequency, it shall attempt to establish contact on another
frequency appropriate to the route. If this attempt fails, the aircraft shall
attempt to establish communication with other aircraft or other
aeronautical stations on frequencies appropriate to the route. In addition,
an aircraft shall monitor the appropriate VHF frequency for calls from
nearby aircraft or aeronautical stations.
(2) If these attempts fail, the aircraft station shall continue to transmit position
reports and its intentions as appropriate on the designated frequency or
frequencies, preceded by the phrase Transmitting Blind.
Such
messages shall be transmitted twice and, if necessary, include the
addressee(s) for which the message is intended.
(3) If no communication is received or other indication that one-way
communications are possible, the aircraft shall set its transponder to
Code 7600 and proceed with the lost communications procedures.
(4) In any case, whereby an aircraft having suffered a communication failure
in flight arrives at an aerodrome, it shall keep a watch for such
instructions as may be issued by visual signals from the aerodrome
control tower or other facility.
2.
RCF procedures VFR

(1) If the communications failure occurs while operating in accordance with
VFR, the aircraft shall continue to fly in visual meteorological conditions
(VMC) and land at the nearest suitable aerodrome using
(a)
the standard RCF arrival procedures prescribed in Appendix 1 to this TS;

or
(b)
if other procedures have been published by the Commissioner for a

specific aerodrome, in accordance with such procedures.
(2) The operator shall report its arrival by the most expeditious means to the
appropriate air traffic services unit (ATSU).
3.
RCF procedures IFR

IFR and VMC are encountered, the aircraft shall
(a)
continue to fly in VMC; land at the nearest suitable aerodrome in

accordance with
(i)
the standard RCF arrival procedures prescribed in Appendix 1 to this

TS; or
(ii)
if other procedures have been published by the Commissioner for a

specific aerodrome, in accordance with such procedures, and
(b)
report its arrival by the most expeditious means to the appropriate ATSU;
or
(c)
if unable to ensure VMC conditions exist to a suitable aerodrome,

complete an IFR flight in accordance with paragraph (2).

IFR while in IMC or, if in VMC but unable to maintain VMC, the aircraft shall
(a) in airspace where an ATS surveillance system is not used in the

provision of air traffic control, maintain the last assigned speed and level,
or minimum flight altitude if higher, for a period of 20 minutes following
the aircrafts failure to report its position over a compulsory reporting point
and thereafter adjust level and speed in accordance with the filed flight
plan;
(b) in airspace where an ATS surveillance system is used in the provision
of air traffic control, maintain the last assigned speed and level, or
minimum flight altitude if higher, for a period of 7 minutes following
(i)
the time the last assigned level or minimum flight altitude was
reached;
(ii)
the time the transponder was set to Code 7600; or
(iii) the aircrafts failure to report its position over a compulsory

reporting point;
whichever is later, and thereafter adjust level and speed in accordance
with the filed flight plan;
(c) when being radar vectored or having been directed by ATC to proceed
offset using area navigation (RNAV) without a specified limit, rejoin the
current flight plan route no later than the next significant point, taking
into consideration the applicable minimum flight altitude;
(d) proceed according to the current flight plan route to the appropriate
designated navigation aid or fix serving the destination aerodrome and,
when required to ensure compliance with subparagraph (e), hold over

this aid or fix until commencement of descent;
(e) commence descent from the navigation aid or fix specified in
subparagraph (d) at, or as close as possible to, the expected approach
time last received and acknowledged or, if no expected approach time
has been received and acknowledged, at, or as close as possible to, the
estimated time of arrival resulting from the current flight plan;
(f)
complete a normal instrument approach procedure as specified for the

designated navigation aid or fix; and
(g) land, if possible, within 30 minutes after the estimated time of arrival
specified in (e) or the last acknowledged expected approach time,
whichever is later.
Appendix 1
Standard Radio Communications Failure Procedure
VFR Arrivals
1.
Maintain squawk of 7600.
2.
Make a relevant blind broadcast to traffic in the area advising of the

probability of a radio communication failure, position and intentions.
3.
Select landing lights on.
4.
Approaching the aerodrome, make a relevant blind broadcast to traffic

on the controlled airfields frequency to indicate the probability of a
radio communication failure, position and intentions.
5.
Join overhead the aerodrome at a height of 1000 feet above circuit

altitude to ascertain which is the active runway in use.
6.
Conform to the circuit pattern while joining, preferably on the downwind

leg.
7.
Continue to make blind broadcasts on the controlled airfields frequency

to indicate the position in the circuit pattern.
8.
Land and vacate the runway expeditiously and safely.
9.
Taxi to the nearest parking area and shutdown.
10.
Inform the owner or operator and ATC.
11.
Make the relevant entry in the aircrafts flight folio.
Note This procedure is to be used in the event the aerodrome at which the
landing is to take place does not have specific procedures to be followed as
published in the AIP.

Radio Communication Faliure

Uploaded by

Copyright:

Available Formats

Radio Communication Faliure

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Radio Communication Faliure

Uploaded by

Copyright:

Available Formats

91.06.

MANDATORY RADIO COMMUNICATIONS

Radio communication failure (RCF) procedures General

RCF procedures VFR

the standard RCF arrival procedures prescribed in Appendix 1 to this TS;

if other procedures have been published by the Commissioner for a

RCF procedures IFR

continue to fly in VMC; land at the nearest suitable aerodrome in

the standard RCF arrival procedures prescribed in Appendix 1 to this

if other procedures have been published by the Commissioner for a

if unable to ensure VMC conditions exist to a suitable aerodrome,

(2) If the communications failure occurs while operating in accordance with

(a) in airspace where an ATS surveillance system is not used in the

the time the transponder was set to Code 7600; or

(iii) the aircrafts failure to report its position over a compulsory

when required to ensure compliance with subparagraph (e), hold over

complete a normal instrument approach procedure as specified for the

Maintain squawk of 7600.

Make a relevant blind broadcast to traffic in the area advising of the

Select landing lights on.

Approaching the aerodrome, make a relevant blind broadcast to traffic

Join overhead the aerodrome at a height of 1000 feet above circuit

Conform to the circuit pattern while joining, preferably on the downwind

Continue to make blind broadcasts on the controlled airfields frequency

Land and vacate the runway expeditiously and safely.

Taxi to the nearest parking area and shutdown.

Inform the owner or operator and ATC.

Make the relevant entry in the aircrafts flight folio.

You might also like