Scribd
Upload
178 views

Embedded System Design

This document outlines the objectives and content of a course on Embedded System Design-I. The course aims to develop skills in modeling, designing, and implementing next-generation embedded hardware and software systems with optimal performance, high confidence, and reduced time. The course covers topics like embedded hardware and software terminology, system modeling and hardware/software partitioning, hardware/software co-synthesis, microcontroller interfacing, memory interfacing, and real-time operating systems. Evaluation includes short answer questions from the entire syllabus and two out of three questions to be attempted from each of two sections. References for further reading on embedded systems and hardware/software co-design are also provided.

Uploaded by

spvece
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
178 views

Embedded System Design

This document outlines the objectives and content of a course on Embedded System Design-I. The course aims to develop skills in modeling, designing, and implementing next-generation embedded hardware and software systems with optimal performance, high confidence, and reduced time. The course covers topics like embedded hardware and software terminology, system modeling and hardware/software partitioning, hardware/software co-synthesis, microcontroller interfacing, memory interfacing, and real-time operating systems. Evaluation includes short answer questions from the entire syllabus and two out of three questions to be attempted from each of two sections. References for further reading on embedded systems and hardware/software co-design are also provided.

Uploaded by

spvece
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

ANNEXURE VI

ECL- 518-A

EMBEDDED SYSTEM DESIGN-I

L T P
3 0 0

Objective: To develop the next generation of technologies, methods and tools for modeling,
designing and its implementation for operational hardware/software embedded systems with
optimal performance, high confidence, reduced time.
THEORY:
Note: Question No 1 is compulsory and will be of short answer type from entire syllabus. Two
questions are to be attempted out of three questions from each Section A & B.
SECTION A
UNIT 1: Introduction to Embedded Hardware and Software
Terminology Gates Timing diagram Memory Microprocessor buses Direct memory
access Interrupts Built interrupts Interrupts basis Shared data problems Interrupt latency
- Embedded system evolution trends Interrupt routines in an RTOS environment.
UNIT 2: System Modeling With Hardware/Software Partitioning
Embedded systems, Hardware/Software Co-Design, Co-Design for System Specification and
modeling- Single-processor Architectures & Multi-Processor Architectures, comparison of CoDesign Approaches, Models of Computation, Requirements for Embedded System Specification,
Hardware/Software Partitioning Problem, Hardware/Software Cost Estimation, Generation of
Partitioning by Graphical modeling, Formulation of the HW/SW scheduling, Optimization .
UNIT 3: Hardware/Software Co-Synthesis
The Co-Synthesis Problem, State-Transition Graph, Refinement and Controller Generation,
Distributed System Co-Synthesis.
SECTION B
UNIT 4: Pic Micro-Controller and Interfacing
Introduction, CPU architecture, registers, instruction sets addressing modes loop timing, timers
interrupts, interrupts, timing I/o expansion, I 2 C bus operation serial EPROM, analog to digital
converter, UART-Baud Rate-Data Handling-initialization, special features- serial programming
a parallel slave port.
UNIT 5: Memory and Interfacing
Memory, Memory write ability and storage performance Memory types composing memory
Advance RAM interfacing communication basic Microprocessor interfacing I/O addressing
Interrupts Direct memory access Arbitration multilevel bus architecture Serial protocol
Parallel protocols Wireless protocols Digital camera example .

Cr
3

UNIT 6: Real Time Operating Systems


Task and Task States, tasks and data, semaphores and shared Data Operating system servicesmessage questimer function- events - memory management, interrupt routines in an RTOS
environment, basic design using RTOS.
Text Books:
1. David. E. Simon, An Embedded Software Primer, Pearson Education, 2001.
2. Tammy Noer gaard, Embedded System Architecture, A comprehensive Guide for Engineers
and Programmers, Elsevier, 2006.
Reference Books:
1. Raj Kamal, Embedded Systems- Architecture, Programming and Design, Tata McGraw
Hill, 2006.
2. Frank Vahid and Tony Givargis, Embedded Systems Design: A Unified Hardware/Software
Introduction, John & Wiley Publications, 2002.
3. Steve Heath, Embedded System Design, Elsevier, Second Edition, 2004.
4. Ralf Niemann, Hardware/Software Co-Design for Data Flow Dominated Embedded
Systems, Kluwer Academic Pub, 1998.
5. Jorgen Staunstrup, Wayne Wolf, Hardware/Software Co-Design: Principles and Practice,
Kluwer Academic Pub, 1997.
6. Giovanni De Micheli, Rolf Ernst Morgon, Reading in Hardware/Software Co-Design
Kaufmann Publishers, 2001.

You might also like