Headlight Switch: The Headlights Can Be Operated Manually or Automatically

2-3.
Operating the lights and wipers
Headlight switch
The headlights can be operated manually or automatically.
For U.S.A.
The headlights and
parking lights turn on
and off automatically.
The side marker, parking, tail, license plate
and instrument panel
lights turn on.
The headlights and all
lights listed above turn
on.
Daytime running light
system is off.
For Canada
The side marker, parking, tail, license plate
and instrument panel
lights turn on.
The headlights and all
lights listed above turn
on.
The headlights and
parking lights turn on
and off automatically.
152
2-3. Operating the lights and wipers
Turning on the high beam headlights

With the headlights on, push
the lever forward to turn on the
high beams.
Pull the lever back to the center
position to turn the high beams
off.
Release the lever to turn them off.

You can flash the high beams
with the headlights on or off.
153
When driving
Pull the lever toward you to

turn on the high beams.
n The headlights can be operated automatically when

Vehicles with smart key system
The ENGINE START STOP switch is in IGNITION ON mode.
Vehicles without smart key system
The engine switch is in ON position.
n Daytime running light system
To make your vehicle more visible to other drivers, the headlights turn on
automatically (at a reduced intensity) whenever the engine is started and the
parking brake is released. Daytime running lights are not designed for use at
night.
For U.S.A.: Daytime running lights can be turned off by operating the switch.
n Headlight control sensor
The sensor may not function properly if
an object is placed on the sensor, or anything that blocks the sensor is affixed to
the windshield.
Doing so interferes with the sensor
detecting the level of ambient light and
may cause the automatic headlight system to malfunction.
154
n Automatic light off system

l When the headlights are on: The headlights and tail lights turn off 30 seconds after all doors are closed with the ENGINE START STOP switch
OFF. (The lights turn off immediately if the
on the key is pressed
after all doors are locked.)
l When only the tail lights are on: The tail lights turn off automatically if the
ENGINE START STOP switch is turned OFF and the drivers door is
opened.

l When the headlights are on: The headlights and tail lights turn off 30 seconds after all doors are closed with the engine switch OFF. (The lights
turn off immediately if the
on the key is pressed after all doors are
locked.)
l When only the tail lights are on: The tail lights turn off automatically if the
engine switch is turned OFF and the drivers door is opened.
To turn the lights on again, turn the engine switch to ON position, or turn
the headlight switch off and then back to the
or
position.
If any of the doors or trunk lid is kept open, the lights automatically turn off
after 20 minutes.
n Customization that can be configured at Toyota dealer
Settings (e.g. Light sensor sensitivity) can be changed. (Customizable features P. 454)
NOTICE
n To prevent battery discharge
Do not leave the lights on longer than necessary when the engine is not running.
155
When driving
To turn the lights on again, turn the ENGINE START STOP switch to IGNITION ON mode, or turn the headlight switch off and then back to the
or
position.
If any of the doors or trunk lid is kept open, the lights automatically turn off
after 20 minutes.
Fog light switch (if equipped)

The fog lights improve visibility in difficult driving conditions, such
as in rain or fog. They can be turned on only when the headlights are
on low beam.
Off
Front fog lights on
156
Windshield wipers and washer

Wiper intervals can be adjusted for intermittent operation (when
INT is selected).
Intermittent
windshield
wiper interval adjustment
(increase)
Intermittent
windshield
wiper interval adjustment
(decrease)
Low speed windshield wiper

operation
High speed windshield
wiper operation
Temporary operation
Wash/wipe operation
Wipers operate automatically.
n The windshield wiper and washers can be operated when

The ENGINE START STOP switch is in IGNITION ON mode.
The engine switch is in ON position.
n If no windshield washer fluid sprays
Check that the washer nozzles are not blocked and if there is washer fluid in
the windshield washer fluid reservoir.
157
When driving
Intermittent
windshield
wiper operation
NOTICE
n When the windshield is dry
Do not use the wipers, as they may damage the windshield.
n When there is no washer fluid spray from the nozzle
Damage to the washer fluid pump may be caused if the lever is pulled
toward you and held continually.
n When a nozzle becomes blocked
Do not try to clear it with a pin or other object. The nozzle will be damaged.
158

Headlight Switch: The Headlights Can Be Operated Manually or Automatically

Uploaded by

Copyright:

Available Formats

Headlight Switch: The Headlights Can Be Operated Manually or Automatically

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Headlight Switch: The Headlights Can Be Operated Manually or Automatically

Uploaded by

Copyright:

Available Formats

2-3.

Operating the lights and wipers

2-3. Operating the lights and wipers

Turning on the high beam headlights

Release the lever to turn them off.

Pull the lever toward you to

2-3. Operating the lights and wipers

n The headlights can be operated automatically when

2-3. Operating the lights and wipers

n Automatic light off system

Vehicles without smart key system

2-3. Operating the lights and wipers

Fog light switch (if equipped)

2-3. Operating the lights and wipers

Windshield wipers and washer

Low speed windshield wiper

n The windshield wiper and washers can be operated when

2-3. Operating the lights and wipers

You might also like