Bone Ash Estimation of Content of Bone Ash Project Submitted by Prashanth
Bone Ash Estimation of Content of Bone Ash Project Submitted by Prashanth
Bone Ash Estimation of Content of Bone Ash Project Submitted by Prashanth
that the matrix in bone is hard. Woven or lamellar Two types of bone can be identified microscopically according to the pattern of collagen
forming the osteoid (collagenous support tissue of type I collagen embedded in glycosaminoglycan gel 1) woven bone characterised by
haphazard organisation of collagen fibers and is mechanically weak, and 2) lamellar bone which has a regular parallel alignment of collagen
into sheets (lamellae) and is mechanically strong. Woven bone is produced when osteoblasts produce osteoid rapidly which occurs initially in
all fetalbones (but is later replaced by more resilient lamellar bone). In adults woven bone is created afterfractures or in Pagets disease.
Woven bone is weaker, with a smaller number of randomly oriented collagen fibers, but forms quickly; it is for this appearance of the fibrous
matrix that the bone is termedwoven. It is soon replaced by lamellar bone, which is highly organized in concentric sheets with a much lower
proportion of osteocytes to surrounding tissue. Lamellar bone, which makes its first appearance in the fetus during the third trimester,[3] is
stronger and filled with many collagen fibers parallel to other fibers in the same layer (these parallel columns are called osteons). In crosssection, the fibers run in opposite directions in alternating layers, much like in plywood, assisting in the bones ability to resist torsion forces.
After a fracture, woven bone forms initially and is gradually replaced by lamellar bone during a process known as bony substitution. These
terms are histologic, in that a microscope is necessary to differentiate between the two. Types There are five types of bones in the human
body: long, short, flat, irregular and sesamoid. Long bones are characterized by a shaft, the diaphysis, that is much greater in length than
width. They are comprised mostly of compact bone and lesser amounts of marrow, which is located within the medullary cavity, and spongy
bone. Most bones of the limbs, including those of the fingers and toes, are long bones. The exceptions are those of
the wrist, ankleand kneecap. Short bones are roughly cube-shaped, and have only a thin layer of compact bone surrounding a spongy
interior. The bones of the wrist and ankle are short bones, as are thesesamoid bones. Flat bones are thin and generally curved, with two
parallel layers of compact bones sandwiching a layer of spongy bone. Most of the bones of the skull are flat bones, as is thesternum. Irregular
bones do not fit into the above categories. They consist of thin layers of compact bone surrounding a spongy interior. As implied by the name,
their shapes are irregular and complicated. The bones of the spinehips are irregular bones.and Sesamoid bones are bones embedded in
tendons. Since they act to hold the tendon further away from the joint, the angle of the tendon is increased and thus the leverage of the
muscle is increased. Examples of sesamoid bones are the patella and the pisiform.Compared to woven bone , lamellar bone formation takes
place more slowly. The orderly deposition of collagen fibers restricts the formation of osteoid to about 1 to 2 m per day. Lamellar bone
requires a relatively flat surface to lay the collagen fibers in parallel or concentric layers. Formation The formation of bone during the fetal
stage of development occurs by two processes: Intramembranous ossification and endochondral ossification. Intramembranous ossification
Intramembranous ossification mainly occurs during formation of the flat bones of the skull; the bone is formed from mesenchyme tissue. The
steps in intramembranous ossification are: Development of ossification center Calcification Formation of trabeculae Development of
periosteum Endochondral ossification Endochondral ossification, on the other hand, occurs in long bones, such as limbs; the bone is formed
from cartilage. The steps in endochondral ossification are: Development of cartilage model Growth of cartilage model Development of the
primary ossification center Development of the secondary ossification center Formation of articular cartilage and epiphyseal plate
Endochondral ossification begins with points in the cartilage called primary ossification centers. They mostly appear during fetal
development, though a few short bones begin their primary ossification after birth. They are responsible for the formation of the diaphyses of
long bones, short bones and certain parts of irregular bones. Secondary ossification occurs after birth, and forms the epiphyses of long bones
and the extremities of irregular and flat bones. The diaphysis and both epiphyses of a long bone are separated by a growing zone of cartilage
(the epiphyseal plate). When the child reaches skeletal maturity (18 to 25 years of age), all of the cartilage is replaced by bone, fusing the
diaphysis and both epiphyses together (epiphyseal closure). Bone marrow Bone marrow can be found in almost any bone that
holds cancellous tissue. In newborns, all such bones are filled exclusively with red marrow, but as the child ages it is mostly replaced by
yellow, or fatty marrow. In adults, red marrow is mostly found in the marrow bones of the femur, the ribs, the vertebrae and pelvic bones.
Remodeling Remodeling or bone turnover is the process of resorption followed by replacement of bone with little change in shape and occurs
throughout a persons life. Osteoblasts and osteoclasts, coupled together via paracrine cell signalling, are referred to as bone remodeling
units. Purpose The purpose of remodeling is to regulate calcium homeostasis, repair micro-damaged bones (from everyday stress) but also to
shape and sculpture the skeleton during growth. Calcium balance The process of bone resorption by the osteoclasts releases stored calcium
into the systemic circulation and is an important process in regulating calcium balance. As bone formation actively fixes circulating calcium in
its mineral form, removing it from the bloodstream, resorption actively unfixes it thereby increasing circulating calcium levels. These
processes occur in tandem at site-specific locations. Repair Repeated stress, such as weight-bearing exercise or bone healing, results in the
bone thickening at the points of maximum stress (Wolffs law). It has been hypothesized that this is a result of bones piezoelectric properties,
which cause bone to generate small electrical potentials under stress.[4] Paracrine cell signalling The action of osteoblasts and osteoclasts are
controlled by a number of chemical factors which either promote or inhibit the activity of the bone remodelling cells, controlling the rate at
which bone is made, destroyed or changed in shape. The cells also use paracrine signalling to control the activity of each other. Osteoblast
stimulation Osteoblasts can be stimulated to increase bone mass through increased secretion of osteoid and by inhibiting the ability of
osteoclasts to break down osseous tissue. Bone building through increased secretion of osteoid is stimulated by the secretion of growth
hormone by the pituitary, thyroid hormone and the sex hormones (estrogens and androgens). These hormones also promote increased
secretion of osteoprotegerin.[5] Osteoblasts can also be induced to secrete a number of cytokines that promote reabsorbtion of bone by
stimulating osteoclast activity and differentiation from progenitor cells. Vitamin D, parathyroid hormone and stimulation from osteocytes
induce osteoblasts to increase secretion of RANK-ligand and interleukin 6, which cytokines then stimulate increased reabsorbtion of bone by
osteoclasts. These same compounds also increase secretion ofmacrophage colony-stimulating factor by osteoblasts, which promotes the
differentiation of progenitor cells into osteoclasts, and decrease secretion of osteoprotegerin. Osteoclast inhibition The rate at which
osteoclasts resorb bone is inhibited by calcitonin and osteoprotegerin. Calcitonin is produced by parafollicular cells in thethyroid gland, and
can bind to receptors on osteoclasts to directly inhibit osteoclast activity. Osteoprotegerin is secreted by osteoblasts and is able to bind RANKL, inhibiting osteoclast stimulation. Experimental Analysis Materials Required PARTICULARS QUANTITY Rib Bone 2 Pieces Beaker 150 ml Test
Tube 7 nos Evaporating Dish 1 no Ring Stand 1 no Bunsen Burner 1 no Test Tube Holder 2 nos Filter Paper PH Paper Dil. Nitric Acid 200
ml 1% Ammonium Hydroxide 100 ml 1% Silver Nitrate 25 ml 1% Ammonium Chloride 50 ml Acetic Acid 100 ml 1% Potassium Thiocyanate
25 ml Distilled Water As Reqd Report of Project EXPERIMENT OBSERVATION A strip of bone was burnt in evaporating dish Yellowish white
precipitate was obtained 2 gms of bone as was weighed To it dilute nitric acid was added On adding Nitric acid the ash sparingly dissolved It
was diluted with water and the ash was completely dissolved The above solution was filtered and the residue (left on the filter paper) was
discarded Ammonium hydroxide was added to the filtrate (left on the beaker) The pH was made to 8.6 Whitish brown precipitate of
Magnesium ammonium phosphate was obtained The solution was made basic. The basicity was checked with the help of pH paper The
solution was filtered and the residue was isolated The filtrate was separated into two test tubes White precipitate of Silver chloride was
obtained Silver nitrate was added to one of the test tubes White residue of calcium To the other test tube ammonium chloride and ammonium
carbonate was added simultaneously and boiled Carbonate was obtained To the solution left, dilute HCL was added followed by Potassium
thiocyanate Red colour solution marking the presence of Iron was obtained Result Extrapolation from the above observations Constituents of
bone ash identified were: I. Calcium II. Phosphate III. Chloride IV. Magnesium V. Iron Apart from this Calcium and Phosphate which is found
maximum in bone was estimated from the precipitate got. This was done by weighing the precipitate Weight of Calcium carbonate:1.7 g Weight of Mg (NH4) PO4 :1.1 g Weight of Ca in 2g of sample:0.68 g Weight of Phosphorous:0.24 g % of Ca:34% % of Phosphorous:12% Disorders
There are many disorders of the skeleton. One of the more prominent is osteoporosis. Osteoporosis Osteoporosis is a disease of bone, leading
to an increased risk of fracture. In osteoporosis, the bone mineral density (BMD) is reduced, bone microarchitecture is disrupted, and the
amount and variety of non-collagenous proteins in bone is altered. Osteoporosis is defined by the World Health Organization (WHO) in women
as a bone mineral density 2.5 standard deviations below peak bone mass (20-year-old sex-matched healthy person average) as measured
by DXA; the term established osteoporosis includes the presence of a fragility fracture.[6] Osteoporosis is most common in women after
the menopause, when it is called postmenopausal osteoporosis, but may develop in men and premenopausal women in the presence of
particular hormonal disorders and other chronic diseases or as a result of smoking and medications, specifically glucocorticoids, when the
disease is called steroid- or glucocorticoid-induced osteoporosis (SIOP or GIOP). Osteoporosis can be prevented with lifestyle advice and
medication, and preventing falls in people with known or suspected osteoporosis is an established way to prevent fractures. Osteoporosis can
be treated with bisphosphonates and various other medical treatments. Other Other disorders of bone include: Bone fracture Osteomyelitis
Osteosarcoma Osteogenesis imperfecta Osteochondritis Dissecans Bone Metastases Neurofibromatosis type I Osteology The study of bones
and teeth is referred to as osteology. It is frequently used in anthropology, archeology and forensic science for a variety of tasks. This can
include determining the nutritional, health, age or injury status of the individual the bones were taken from. Preparing fleshed bones for these
types of studies can involve maceration boiling fleshed bones to remove large particles, then hand-cleaning. Typically anthropologists and
archeologists study bone tools made by Homo sapiens and Homo neanderthalensis. Bones can serve a number of uses such as projectile
points or artistic pigments, and can be made from endoskeletal or external bones such as antler or tusk. Alternatives to bony endoskeletons
There are several evolutionary alternatives to mammillary bone; though they have some similar functions, they are not completely
functionally analogous to bone. Exoskeletons offer support, protection and levers for movement similar to endoskeletal bone. Different types
of exoskeletons include shells,carapaces (consisting of calcium compounds or silica) and chitinous exoskeletons. A true endoskeleton (that is,
protective tissue derived from mesoderm) is also present in Echinoderms. Poriferaspicules and a spongin fiber network.(sponges) possess
simple endoskeletons that consist of calcareous or siliceous Exposed bone Bone penetrating the skin and being exposed to the outside can be
both a natural process in some animals, and due to injury: A deers antlers are composed of bone. Instead of teeth, the extinct predatory
fish Dunkleosteus had sharp edges of hard exposed bone along its jaws. A compound fracture occurs when the edges of a broken bone
puncture the skin. Though not strictly speaking exposed, a birds beak is primarily bone covered in a layer of keratin over a vascular layer
containing blood vessels and nerve endings. Terminology Several terms are used to refer to features and components of bones throughout
the body: Bone feature Definition articular process A projection that contacts an adjacent bone. articulation The region where adjacent bones
contact each other a joint. canal A long, tunnel-like foramen, usually a passage for notable nerves or blood vessels. condyle A large,
rounded articular process. crest A prominent ridge. eminence A relatively small projection or bump. epicondyle A projection near to a condyle
but not part of the joint. facet A small, flattened articular surface. foramen An opening through a bone. fossa A broad, shallow depressed
area. fovea A small pit on the head of a bone. Labyrinth A cavity within a bone. line A long, thin projection, often with a rough surface. Also
known as a ridge. malleolus One of two specific protuberances of bones in the ankle. meatus A short canal. process A relatively large
projection or prominent bump.(gen.) ramus An arm-like branch off the body of a bone. sinus A cavity within a cranial bone. spine A relatively
long, thin projection or bump. suture Articulation between cranial bones. trochanter One of two specific tuberosities located on the femur.
tubercle A projection or bump with a roughened surface, generally smaller than a tuberosity. tuberosity A projection or bump with a
roughened surface. Bibliography Biology Investigations
Otto, Towle, Crider Concise Inorganic Chemistry
J.D.Lee Wikipedia
NCERT Biology and chemistry Textbook
Read more at: http://projects.icbse.com/chemistry-472