Scribd
Upload
755 views

Projectile Motion Lab Revised

This lab report investigates the relationship between initial height and horizontal displacement (x) of projectiles. The hypothesis is that x will increase with initial height. Balls of two masses were dropped from increasing heights on a ramp. Data showed x increased linearly with height for both balls. The relationship was stronger for the heavier ball. Sources of error included friction on the ramp and unevenness causing shaking. In conclusion, the hypothesis was confirmed as greater initial heights provided more time and distance for the x component of velocity.

Uploaded by

Leznan Day
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
755 views

Projectile Motion Lab Revised

This lab report investigates the relationship between initial height and horizontal displacement (x) of projectiles. The hypothesis is that x will increase with initial height. Balls of two masses were dropped from increasing heights on a ramp. Data showed x increased linearly with height for both balls. The relationship was stronger for the heavier ball. Sources of error included friction on the ramp and unevenness causing shaking. In conclusion, the hypothesis was confirmed as greater initial heights provided more time and distance for the x component of velocity.

Uploaded by

Leznan Day
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

Projectile Motions Lab

Investigating if the initial height would change the x displacement


Terry Tong, Victor Jeung, Cathy Liu, Jason Feng
2011 September 28

1
Projectile Motions Lab

Abstract
This lab for projectile motions will be investigating the properties of the x displacement of a projectile.
The change of the x displacement can be changed dramatically by any type of variable such as initial
angle, initial speed, initial height, and air resistance but it is negligible. Our lab will be focused on
changing the initial height and seeing the changes in the X displacement.

Introduction
Hypothesis
Our hypothesis for the displacement of the ball is that it will increase with the initial height changes.

Variables within the experiment


The variables within our experiment will be the Displacement of Y which we will control as an
independent variable. While all other except the displacement of x and time will be set to one
state and will not change, such as initial velocity and initial angle (set to zero to eliminate this
variable).

Theory
(equation 1)

Uniform motion equation to find X displacement

(equation 2)

Uniform accelerated motion to find fly time(reject

negative value) because the fly time is shared among its x component, we use this time to find
the x displacement after find its velocity.
(equation 3)

Uniform accelerated motion, used for find out the initial


velocity of the projectile from when it begins its free-fall.
Initial velocity is zero from top of ramp

(equation 4)

The final velocity is found, which the initial velocity for the
actual freefalling motion is.

This equation combines all of 2 and 4 in to equation 1 which


results in a direct calculation of the displacement of X

2
Projectile Motions Lab

Linearizing the equation by combining 1,2,and 4.


then substituting equations 2 and 4 in to initial velocity and time we get

log has a coefficient of 1

Taking the log of both sides will show it is a linear relationship which

3
Projectile Motions Lab

Experiment
Apparatus
-2 retort stands
-1 hot wheel tracks
-1 clamp

-Pieces of Carbon Paper and a sheet of line


paper
-Tape, clear tape
-Projectile (Metal Ball Bearings)

Setup of Apparatus
Our set up for this lab was to use two retort stands placed one in front of the other. Then using clamps
to clamp on to the end of a hot wheels race track approximately 28 cm above the base of the retort
stand. Then using clear tape(which minimizes the friction when the ball goes over it) and tape the race
track down on to the first rhetoric stand. The base length of our stand was 51.2 cm. Then Lay down the
Piece of carbon paper to approximately where you think the steel balls would land, we placed a meter
stick from the edge of where the balls are launched so we can quickly get the measurements.

Figure 1: Apparatus setup of our lab.

4
Projectile Motions Lab

Conducting the Lab


Our lab was conducted by letting steel balls go at the top of the ramp, which basically is almost zero
velocity at the top of the ramp. From the ramps top we count down and release, which at the same time
we start counting time and stop at the time when I hear the ball hit the floor. For each trial there would
be 6 runs (3 runs with the heavy ball, 3 runs with light ball). After each trial we raise the entire height of
the apparatus by placing a wooden plank under the two retort stands.

Data
Small Balls:
Big Balls:
Displacement X (cm) Height(cm) Displacement X (cm) Height(cm)
75.4
93.3
74.2
93.3
75.0
93.3
75.3
93.3
74.3
93.3
74.7
93.3
76.5
96
74.5
96
76.5
96
78.2
96
76.5
96
78.5
96
76.8
98.5
80.3
98.5
75.8
98.5
79.5
98.5
75.6
98.5
78.2
98.5
78.9
106
82.1
106
79.3
106
82.2
106
79.1
106
82.5
106
84.5
114
87.2
114
85.0
114
88.5
114
83.1
114
87.6
114

Figure 2: Raw data for small and big ball comparing displacement in x(cm) and height (cm) in tabular
form.
The data we collected seems to take a linear form and that the distance in x is changing linearly
according to the increase in the initial height. From the data we had also concluded that the weight of
the ball also may apply a change in the X displacement also, but there is no evidence to conclude why it
is so.
The graph as you see shows our collected data, the red plots represent the heavier (61 gram) steel balls
while the blue shows the lighter (8 grams) steel balls. And there is a clear difference in how much
difference there is between the heavier ball and the lighter ball.
The correlation ship between the initial height and the distance it yielded is shown quite clearly that it is
a linear relationship. Slope of the graph is H = 0.5956x + 19.746 for big balls and h = 0.4304x + 34.435

5
Projectile Motions Lab

both of which are a linear relationship, and does not show any signs of being an exponential or log
characteristics. This of which proves that our theoretical calculations are correct.

Displacement in x (cm) vs. Initial Height (cm) for


Small and Big Ball Rolling Down Hot Wheels Ramp
90.0
88.0

Displacement in X (cm)

86.0
84.0
82.0

Data For Small Balls

80.0

Data For Big Balls


Linear (Data For Small Balls)

78.0

Linear (Data For Big Balls)

76.0
74.0
72.0
0

20

40

60

80

100

120

Initial Height Distance(cm)

Figure 3: Graph - Displacement in x (cm) vs. Initial Height (cm) for Small and Big Ball Rolling Down Hot
Wheels Ramp

Conclusion
In conclusion, our hypothesis was correct because a direct relationship exists between the initial height
and x displacement. As the initial height increased, x displacement also increased, this was due to the
fact the extended height created more flight time for the ball, which means the velocity at x component
is able to travel further and further. This created a linear relationship as we hypothesized. There were
some random and systematic errors though that caused discrepancies in the data. These were:

The systematic error of not being equal to zero since the ramp was curved and taped down at
the end of the counter. This resulted in the ramp not being straight causing the x displacement
to change.
The systematic error of friction on the ramp, which caused the distance projected to be off by
approximately 10cm.
6

Projectile Motions Lab

The systematic error of the ramp being uneven, due to the use of one retort stand. The random
error caused the ramp to shake and wobble while the ball was in motion resulting in a change of
the x displacement.

If we were to repeat this lab, we would propose the following changes:

Use a ramp that is straight and does not curve with little friction to ensure that
also ensures the ramp does not shake or wobble while the ball is in motion.
Verify the relationship between initial velocity and height.

is zero. This

Acknowledgements
Mr. Murzakus notes and assistance with the projectile motion lab.

7
Projectile Motions Lab

You might also like