User manual

English

WARNING !!!
Ferguson TV receivers support recording on external hard disk drives (HDDs) and flash
memories (pendrives). In all instances, the correct operation of the recording function
depends on the type of connected memory! You must read the following limitations.

REMEMBER:
1. In order to use an external USB memory, the memory must support the USB
2.0 standard. To ensure stable recording and playback, you must use a
memory with a recording speed of 9.0 MB/s or greater. Slower hard disk
drives and flash memories may not function properly, have problems with
recording (image jitter), or not function at all!!!
2. Only disks with one basic NTFS or FAT32 partition (we recommend using the
NTFS format) will function properly. If you do not have such a format, prepare
the disk on your computer before connecting it to the receiver.
3. Highly fragmented or used memories may also not operate smoothly or
correctly.
4. External hard disk drives should be autonomously powered, since the built-in
USB port is unable to provide sufficient power.
5. Only one of the two USB ports can be used at the same time!

CAUTION
1. Under no circumstances should you disconnect the USB device from the
receiver during recording or playback. Disconnecting during operation may
cause damage to the receiver and/or flash memory, and to the recorded data.
2. Do not touch the working device (and in particular the USB connector) with
wet hands. Risk of electric shock and permanent damage to the receiver!

SAFETY MEASURES
We request that you read the instruction manual and recommendations set forward therein.
Also remember to correctly position the TV antenna!
In order to avoid an electric shock, never open the housing. Damage to the
warranty seal shall void the warranty.

Disconnect the device from the mains during thunderstorms or when it is not to
be used for an extended period of time. Please remember that the warranty does
not cover damage to the equipment caused by a lightning strike.
Do not expose the device to direct sunlight. Place it away from sources of heat
and humidity. Do not cover ventilation ducts, in order to ensure the correct
circulation of air.
Place the device horizontally on a flat, even and stable surface.

If you move the device from a room that is warm to one that is cold (or vice
versa), wait at min. 1 hour before connecting it to the mains. Otherwise,
problems may arise.
The device should be placed away from vases, bottles, aquariums and other water
containers in order to avoid damage. Do not touch the mains plug with your bare
hands.
Do not place any objects on the housing of the device. This may cause
overheating and reception problems.

Before commencing maintenance or installation work, disconnect the receiver from the mains.
Do not clean the receiver with alcohol or liquids containing ammonia. If necessary, clean it with
a soft, lint-free cloth wetted with a gentle solution of water and soap.

Do not connect any cables when the mains plug is in the socket.

Check the condition of your cables. Damaged cables may cause a fire.

Please disconnect the receiver from the mains before connecting any cables.

DOWNLOADABLE SOFTWARE
Ferguson has taken every effort to provide users with software updates in order to ensure that
the parameters of the TV television receiver are up to date. Ferguson reserves itself the right to
amend, change or modify the software used in the TV television receiver as it shall choose and
without prior notification. The latest version of the software is available on the website
http://www.ferguson-digital.eu

ABOUT THE INSTRUCTION MANUAL

Ferguson Sp. z o.o. has made every effort to provide the most current information about its
products. Ferguson Sp. z o.o. does not grant any guarantee as to the contents of the present
instruction manual and disclaims any implied guarantees concerning market value or suitability
for specific purposes. The information contained herein is an instruction intended to enable the
correct usage and maintenance of the receiver.
Ferguson Sp. z o.o. reserves itself the right to introduce amendments, changes or translations
of the instruction manual without prior notification thereof. For this reason, we recommend you
regularly visit our website in order to obtain the latest information.
MARKINGS AND SIGNS APPLIED TO THE RECEIVER
Digital signal transmission logo.
This logo informs that the receiver
conforms to the Digital Video
Broadcasting standards.

CE logo.
The logo informs that the receiver
conforms to the terms and conditions of
Directive 2004/108/EC concerning
observance by Member States of provisions
regulating electromagnetic compatibility,
and to the terms and conditions of
Directives 2006/95/EC concerning
observance by Member States of provisions
regulating low voltage electricity and safety
with relation to the handling and operation
of electrical equipment.

Risk of electric shock do not open.

This notice warns the user not to open
the receiver housing. The housing may
be opened solely by authorized service
technicians.

When this crossed-out wheeled bin

symbol is attached to a product it
means that the product is covered by
the European Directive 2002/96/EC.
Please inform yourself about the local
separate collection system for electrical
and electronic products.
Please act according to your local rules
and do not dispose of your old products
with your normal household waste.
Correct disposal of your old product
helps to prevent potential negative
consequences for the environment and
human health.

R&TTE

Hereby Ferguson Sp. z o.o., declares

that the device is in compliance with
the essential requirements and other
relevant provisions of Directive 1999/5/EC.
You can find the Declaration of Conformity
on www.deklaracje.ferguson.pl
This product has been designed, tested and
manufactured according the European
R&TTE directive 1999/5/EC.
Double insulation logo.
This logo informs that the receiver is an
electrically safe device, provided that it is
used in accordance with the
recommendations set forward in the
chapter concerning safety.

Your product contains batteries covered

by the European Directive 2006/66/EC,
which cannot be disposed with normal
household waste. Please inform yourself
about the local rules on separate
collection of batteries because correct
disposal helps to prevent negative
consequences for the environmental
and human health.

Hot surface mark

CAUTION: HOT SURFACE. DO NOT TOUCH.
The top surface over the internal heat sink
may become hot when operating this
product continuously. Do not touch hot
areas, especially around the Hot surface
mark and the top panel.

Your product is designed and

manufactured with high quality
materials and components, which can
be recycled and reused.

When this logo is attached to a product, it

means a financial contribution has been
paid to the associated national recovery
and recycling system.

Identification of Controls
Main Unit

1.SOURCE
2. SETUP
3.ENTER
4.UP
5. DOWN
6.LEFT
7. RIGHT
8.AV OUT
9.AV IN
10. Earphone Socket
11.ON/OFF
12.DC IN 9-12V
13. ANT.
14. HDMI INPUT
15.USB

Identification of Controls
Remote control unit

1.POWER
On/off the power supply
2.VOL Adjust VOLUME.
3.0-9 NUMBER BUTTON
Selects numbered items in a menu.
: Cursor button
4.RED/GREEN
Some specific function
5.REC
Record digital service
6.ENTER
Confirm and Enter
7. SETUP
Main Menu/Return

8.FAV
Open Favorite Programs List Menu
9.TV/RADIAO
Switch between TV and Radio source
10.EXIT
11.DISPLAY
display the information of the current
signal
12.SOURCE
DTV/AV/MEDIA/HDMI INPUT.
13.VOL +
Adjust VOLUME.
14. MUTE
Mute the sound
15. SUBTITLE
Press SUBTITLE repeatedly during
playback to view a different
subtitle languages, if available.
16.AUDIO
Press AUDIO repeatedly during playback
to hear a different audio
language or audio track, if available.
17.STOP
18.PLAY/PAUSE
19.RETURN
20.TTX
21.EPG
show EPG information.
22. BUTTON
Previous option.
23. BUTTON
Next option.
24. BUTTON
Fast forward
25. BUTTON
Fast backward

SETUP MENU
Picture Menu

Section

Picture Menu Items

Value

Default Value

Picture Mode

Standard/ Optimal Soft/

Vivid / User

Standard

Brightness

0~100

50

Contrast

0~100

50

Sharpness

0~10

Colour

0~100

50

Tint

0~100

50

Color Temperature

Standard, Warm, Cool

Standard

Noise Reduction

Off, Low, Middle, High

Middle

Reset

--

--

Notes: The Brightness, Contrast, Sharpness, Colour and Tint can be set only when Picture
Mode is User, otherwise they are be set as relevant default value.

Sound Menu
This section will introduce some properties setting about system Sound.

Section

Sound Menu Items

Value

Default

Sound Mode

Standard, Movie, Music,

Speech, User

Standard

Bass

0~100

50

Treble

0~100

50

EQ

ENTER(EQ setting menu)

ENTER

Balance

-50~50

Surround

Off, On

Off

AVL (Audio Volume Leveler) Off, On

Off

Reset

Cancel

ENTER (OK, Cancel)

Notes: The Bass and Treble can be set only when Sound Mode is User otherwise they
will be set as relevant default value.

TV Channel MENU

Functions in this page

Channel Management: To manage (Delete/Rename/Swap/Lock/ Skip) all channels.
Favorite Management: To set favorite channels.
Country: Set Countrys type, different countries adjust to different search condition.
Auto Search: select auto search.
Digital Manual Search: To search digital channel by entering parameters manually.
LCN On/Off: On or off LCN

Feature Menu
This chapter will describe the function of Feature in Main Menu.

Child Lock: Enter the Child Lock sub page

The Child Lock sub page:
1. Child Lock
On: turn on Child Lock. User need to enter password to watch the channels which are
locked. Also need to enter password when user tries to change settings in items like
reset system/reset database etc.
Off: turn off Child Lock.
2. KeyPad Lock
On: turn on KeyPad Lock. Keypad event will get no response if it is On.
Off: turn off KeyPad Lock.
3. Parental Lock
Off: turn off Parental Lock.
4-18: turn on Parental Lock and set the age levels permitted to watch the program.
4. Change Pin Code
KEY_RIGHT or KEY_ ENTER to enter the pin code changing page.
Language: System language setting includes OSD Language, Preferred Subtitle, Preferred
Audio, Teletext Language.
Clock: It is used to check out the current system time and set time zone/DST.

10

Sleep Timer: When TV is running, start sleep function by setting Sleep Timer in any case. This
function allows the TV power off within a period of time automatically. Supported time period
are: Off, 15 Mins, 30Mins, 45Mins and 60Mins.
Auto Standby: When TV is running, Auto Power Off function can be start by setting Auto Power
off Timer in any case. This function allows user to power off the TV within a period of time.
Supported time period are: Off, 3 Hours, 4 Hours.
Hearing impared: This function offers a subtitle such as a stroke on the door or the bell
starts to ring for the current scene in case that the user is weak in hearing.
Setup Menu
This chapter will describe the function of Setup in Main Menu.

Section

Setup Menu Items

Value

Default

OSD Timer

5, 10, 15, 20, 25, 30

(Seconds), Never

Never

HDMI Mode

(Auto, PC, Video)

Auto

Blue Screen

(Off, On)

Off

Aspect Ratio

(Auto, 4:3, 16:9, Full,

16:9

Zoom1, Zoom2, Panorama)

5

Reset TV Setting

ENTER

--

Software Upgrade

ENTER

--

11

Media Menu
Select media
Press source key
Multimedia Home Page manages all the information of media.
KEY_RIGHT/KEY_LEFT can help to switch the items. KEY_ENTER
will confirm the selected item and enter the detailed menu.
Sub Items:
1. Photo (bmp, jpg, jpeg, gif, png photos playback)
2. Music (mp3, ogg music playback)
3. Movie (Movie playback)
4. PVR (PVR files playback)
5. E-book (ttx, e-book playback)
Menu shows as follows:

Not all files with those extensions are playable - some files may include not supported
codecs and/or settings.
Supported video files containers: AVI, MTS, M2TS, MPG, MKV, MP4, M4V, MOV, M2V, VOB, TS
|
|-> video codec supported in containers: mpeg2, XVID, H.264 (up to 8 RF)
|-> audio codec supported in containers: MP3, OGG, AC3

12

Technical Specifications

Item

Sub Item

Parameter

Tuner

Input Frequency

170~230MHz
470~860MHz

Video

RF Input level

-25~-82dBm

IF Bandwidth

7MHz and 8MHz

Modulation

QPSK,16QAM,64QAM

Decoder Format

MPEG4 AVC/H.264 HP@L4

MPEG2 [email protected]

Audio

Power

Output Port

CVBS

Decoder Format

MPEG-1 (layer1&2&3)

Audio output

Stereo

Voltage

DC 9V (1.5 A)

Working Power

12W

Product Fiche
Commercial Brand: FERGUSON
Model No.

PHT-1008

Energy efficiency class

Visible screen size
(diagonal, approx.) (inch/cm)
On mode average power consumption (Watt)
Annual energy consumption
(kWh/annum)

10,1
cali

25,5
cm
9
13,14

Standby power consumption (Watt)

0,5

Off mode power consumption (Watt)

Display resolution (px)

13

1024600