R2 D2 Papercraft Star Wars Star Tours Printable 0213
R2 D2 Papercraft Star Wars Star Tours Printable 0213
R2 D2 Papercraft Star Wars Star Tours Printable 0213
Main Body
2
L
5
spoonful.com
Disney/Lucasfilm Ltd
Page 1 of 5
R2-D2 Papercraft
Right Leg
13
10
13
13
9
13
13
13
11
13
7
14
Outside
Inside
15
14
12
15
16
17
16
17
18
18
19
spoonful.com
Disney/Lucasfilm Ltd
Page 2 of 5
R2-D2 Papercraft
Left Leg
13
Outside
13
Inside
13
10
13
13
13
15
11
14
13
7
7
14
15
16
17
18
16
17
18
19
spoonful.com
Disney/Lucasfilm Ltd
Page 3 of 5
R2-D2 Papercraft
24
23
Center Leg
22
21
20
Bottom
25
Disney/Lucasfilm Ltd
21
20
22
23
3
Dome Top
Main Dome
24
spoonful.com
3
3
Disney/Lucasfilm Ltd
Page 4 of 5
R2-D2 Papercraft
1. Print the template on regular paper or cardstock and cut out the pieces. Make all folds along the dashed lines.
2. Using glue or double-sided tape, secure the tabs on the dome top to the inner circle of the main dome. Close the dome with the #1 tab.
3. Secure all #2 tabs at the top of R2-D2s body to their corresponding pieces.
4. Begin attaching the dome to the top of R2-D2s body by securing the #3 tabs. Start with the tab closest to R2-D2s dome projector, and attach it
to the panel adjacent to the #4 tab at the top of R2-D2s body. Continue attaching the dome by following the contour of the body.
5. Close the top of R2-D2s body with the #4 tab. Continue to close the body with the #5 tab, followed by all #6 tabs. Cap the bottom of R2-D2 with
the bottom piece by attaching it to the remaining tabs.
6. Secure tabs numbered 7-12 to their corresponding pieces on the inside of the right leg. Begin attaching the outside of the leg to the inside of
the leg by securing tabs in numerical order, starting with the #13 tabs around the shoulder. Repeat this step with the left leg.
7. Close the center leg by securing tabs in numerical order, starting with the #20 tabs.
8. When the center leg is complete, attach it to the bottom of R2-D2. If done correctly, R2-D2 should lean slightly backwards when standing.
9. Secure the left and right legs by aligning the letter at the inside of each leg with the letters on R2-D2s body. R2-D2 should now stand on his own.
10. If you want extra detail, you can add the three optical holographic projectors provided. These should be placed on each of three matching
markers, one of which is at the top of the dome. To assemble (Fig. 1), fold the piece in half along the dashed line between the gray and black
panels, then secure the two panels with glue or double-sided tape. Wrap the piece around the black circle, and secure with the end tab. Attach
the tab on the circle to the inner wall of the projector. The black circle should be used to attach each projector to R2-D2 where indicated.
Fig. 1
spoonful.com
Disney/Lucasfilm Ltd
Page 5 of 5