Tapping Into 200 Volts Positive of Free
Tapping Into 200 Volts Positive of Free
Tapping Into 200 Volts Positive of Free
Homemade omnidirectional antenna for long range wifi broadcasting or EM energy harnessing
At full power, long-haul trucker CBs had a transmitting and receiving range of up to 4 miles
A 49? whip attached to the top of a coil increased the range from 7 to 10 miles.
Lightning is absolute proof that free electrical energy is all around us. The average lightning bolt contains a billion
volts at 3,000 amps, or 3 billion kilowatts of power, enough energy to power a major city like Toronto Ontario
Canada, for months.
Physicists, oil and gas companies and your governments all know that six feet (2 meters) above the ground (above
head height) the air is charged with more than 200 volts positive in respect to the ground. Three feet (1 meter)
off the ground the air is charged with 100 volts positive of free electrical energy. In comparison, your electrical
outlets and home appliances are all powered with 120 volts positive and you car battery has a charged of just 12
volts positive. That 200 volts + charged air is a source of free, unlimited, unmetered and carbon-free electrical
energy. The energy is electromagnetic (EM) energy. It can and has already been tapped into by World renowned
scientists such as Nikola Tesla and Henry Moray. Both tapped into this infinite supply of pure, zero emission
electrical energy using a simple antenna.
The CN Tower, the Eiffel Tower, the Washington Monument, all of the Egyptian pyramids and the new One World
Trade Center are all antennas. All are capable of harnessing this free unlimited positively charged electrical energy.
The Egyptian Pyramids were actually built as electrical power generating and wireless transmitting power plants.
The capstone of the pyramids were built and placed atop the pyramids to function as a receiving and transmitting
antenna and the base of the pyramids were built with sandstone (a quartz crystal electrical conductor) to store the
harnessed electrical energy to function as a capacitor.
Over 80 years ago Nikola Tesla utilized a 6-foot vertical antenna rod and tapped into this free and infinite source of
energy and powered a 80-horsepower alternating-current electric motor that he installed in a car. Tesla was so
successful in tapping into this free energy source that the electrical power harnessed was sufficient enough to power
the electric motor and drive a converted (gasoline to electric) Pierce-Arrow at speeds of 90 m.p.h.
In 1932 (81 years ago) Dr Moray also successfully tapped into this free and infinite source of energy using a simple
long wire antenna. A long piece of insulated wire acts as an antenna. The very cheap long wire antenna captures
electromagnetic energy.
An antenna is nothing more than a transducer that converts free electromagnetic (EM) energy into alternating
current (AC electrical power) or vice-versa. There are two basic types: the receiving antenna, which intercepts free
EM energy (RF) and delivers the AC current to electronic equipment (radios, TVs, computers, cell phone chargers,
lights, generator motors, heaters, fans ), and the transmitting antenna, which is fed with AC from electronic
equipment and generates radiant energy.
The simplest antenna is a length of wire, connected at one end to a transmitter or receiver. More often, the
radiating/receiving element is placed at a distance from the transmitter or receiver, and AC is delivered to or from
the antenna by means of a transmission line, also called a feed line or feeder. There is so much free energy in the air
above that the use of longer wire antenna in excess of 500 feet or strung higher than head height can produce lethal
amounts of electrical current.
Ask any electrician and he will no doubt tell you that Earth is always referred to as ground when explaining
electrical circuitry. He or she will also tell you that DC electrical current flows to ground or earth. A lightning
rod, invented by Benjamin Franklin, proves this. If lightning hits a building it will preferentially strike the rod and
be conducted to ground through the wire, instead of passing through the building, where it could start a fire or cause
electrocution. The Earth the ground we stand on, walk on, sleep on , play. run on, drive on and build on is
negative electrically charged and acts as a spherical capacitor. According to Canadas Department of Natural
Resources http://cfs.nrcan.gc.ca/pages/160 The Earth has a net negative charge of between 400,000 and 5000,00
coulombs, while an equal and positive charge resides in the atmosphere.
There is about a 300 000 volt (V) potential difference between the Earths surface and the electrosphere, which
gives an average electric field strength of about 6 V/metre (m) throughout the atmosphere. Near the surface, the
fine-weather electric field strength is about 100 V/m.. Average height of a man is 6 feet or 2 meters so 100 V/m x 2
meters = 200 Volts 6 feet off the ground.
Wikipedia also states that Earths atmosphere is electrically charged. They disclose this with this statement The
measurements of atmospheric electricity can be seen as measurements of difference of potential between a point of
the Earths surface, and a point somewhere in the air above it. The atmosphere in different regions is often found to
be at different local potentials, which differ from that of the earth sometimes even by as much as 3000 Volts within
100 feet (30 m). The electrostatic field and the difference of potential of the earth field according to investigations, is
in summer about 60 to 100 volts and in winter 300 to 500 volts per meter of difference in height, a simple
calculation gives the result that when such a collector is arranged for example on the ground, and a second one is
mounted vertically over it at a distance of 2000 meters and both are connected by a conducting cable, there is a
difference in potential in summer of about 2,000,000 volts and in winter even of 6,000,000 volts and
more.http://en.wikipedia.org/wiki/Atmospheric_electricity
What both Wikipedia and the Canadian government are stating is exactly what Nikola Tesla and Dr. Thomas Henry
Moray stated 80 years ago and tried to educate the World that we are surrounded by a sea of energy. We need only
know how to tap into it to power everything we use. Tesla knew how and powered an electric motor in an
automobile. Moray successfully tapped into this free energy and powered thirty-five 100-watt lamps and a 1200watt iron simultaneously.
Solar panel manufacturers need only to replicate what Tesla and Moray did and their panels will be far more
efficient (harness a lot more free sun energy) than they are now. A simple redesign of the solar panel can tap into
200 volts positive of free, unlimited, unmetered and carbon-free electrical energy. The biggest flaw in all solar
panels is the reflective glass. Solar panels reflect most of that free EM energy. There is more deflecting glass and
dielectric insulating material than energy conducting material in todays solar cells. Very thin strips of conducting
material can of course only harness very little energy. Replace the thin strips with thin sheets and you increase
the inductance of the solar cells. A thin sheet of conducting material has a much greater inductance than very thin
strips.
The law of reflection says that for specular reflection the angle at which the wave is incident on the surface equals
the angle at which it is reflected. Solar panels are mirrors reflecting the sun energy. A mirror provides the most
common model for specular light (mirror-like) reflection, and typically consists of a glass sheet with a metallic
coating where the reflection actually occurs. Reflection is enhanced by the metal of the solar cells by suppression of
wave propagation beyond their skin depths. Reflection also occurs at the surface of transparent media, such as the
glass top of all solar panels. Because all solar panels are stationary in relation to the moving sun energy is
predominately being reflected and the remainder is refracted. Energy is only being absorbed in one incident only
when the sun is exactly perpendicular to the solar panel reflective surface. At all other times sun energy is either
being reflected or refracted.
The solution is to make a electromagnetic (EM) energy receiving antenna that doesnt reflect at all. An antenna m2
(meter square) with a non-reflective matt black surface. Black absorbs the light (EM radiation) and when it does this
it is also absorbing energy throughout the day. It doesnt matter where the sunlight is coming from matt black will
not reflect the free electromagnetic energy. Black absorbs all the visible electromagnetic radiation that falls on it.
The Egyptian Pyramids were actually built as electrical power generating and wireless transmitting power plants
not tombs. They were built to receive, store and transmit electromagnetic energy. The pyramid itself is a very large
capacitor stores electrical energy. They were made of granite (the dielectric or insulator) and sandstone (the quartz
crystal electrical conductor) with a capstone (the antenna) made of granite, basalt, or any other very hard stone
which was plated with Electrum alloy of gold and silver, with trace amounts of copper and other electricity
conducting metals. As stated many times before, electrical current flows to ground or earth from the positively (+)
charged air to the negatively (-) charged ground. The pyramids were built to harness and store this free and
unlimited supply of electrical energy. Pyramids were built as electrical power plants to tap into this free and
unlimited supply of electrical energy.
For centuries we thought they didnt have the technical knowhow (technology) to build and erect very tall metal
framed antenna towers so they built their free energy harnessing antennas using the technology and materials
available during their life time electrum plated capstone (antenna receiver/transmitter), sandstone (quartz crystal
conductor) and granite (insulator).
For centuries we thought the Egyptian ancestors were not as advanced as we are now. Evidence, however reveals
just the opposite that they were far superior than we are now. They had the technology to move and set 300 ton
stones so perfectly close that not even a sheet of paper can fit between the blocks. We, today, do not have that
technical knowhow. They had the technology to harness the infinite zero emission energy from the atmosphere and
from the flux (flow) of water. Today we rely on the finite supply of inefficient and polluting oil, Alberta tar, natural
gas, fake shale gas, coal, and uranium to generate metered electrical power.
Over 4000 years ago man had the technology to build massive electric power plants the pyramids. The sandstone
(arenite) blocks used to build the pyramids were composed of crystal quartz and/or feldspar which are extremely
high electrical conductors and the small amount of metal on the capstone allowed for maximum power generation
and transmission. Also, the Giza Plateau where the pyramids stand was specifically chosen as the construction sites
because the site is full of underground water channels. The pyramids were built above limestone layers that have
spaces between them that are full of flowing (flux) water. These special layers of rock called aquifers transmit
electricity upward as they carry underground water to the surface. The high volume flow (flux) of the River Nile that
passes through these aquifers produces an electric current. This is known as physio-electricity. The pyramids were
built to harness, store (capacitor), and transmit this electricity wirelessly. In 1901 Nikola Tesla began constructing
the Wardenclyffe Tower (Tesla Tower). He understood ancient technology and set out to reeducate the World by
demonstrating what the Egyptians knew and successfully built over 4000 years ago. If the Egyptians were to apply
an insulating casing around the pyramids and reinstalled a capstone antenna (plated with an electricity conducting
and transmitting metal like silver) their pyramids would once again harness, store and transmit wirelessly this free
and unlimited electromagnetic energy. Even though they are thousands of years old they are still able to function
today as electrical power generating power plants. Their main structure is fully intact.
To answer the $ million question What happened to the capstone and the massive shell casing of the Great
Pyramid of Giza? Because the pyramids were massive capacitors, hooking a polarized capacitor backwards would
result in the capacitor exploding forcing the capstone off its peak like a volcano does with its dome when it erupts.
The capstone is still in the Giza Plateau but heavily damaged and covered with sand. Detaching,removing or
breaching a capacitors casing can also cause a capacitor to literally explode, ejecting its contents violently and
shattering the casing off the sides of the pyramid. A catastrophic capacitor failure can result in pressure buildup and
explosion if construction technique does not allow for a discharge of pressure. They built the capacitor but not the
infrastructure to use (discharge) the generated electrical power and as a result the pyramid failed catastrophically.
Warning the flash capacitor of a camera or from any electronic circuit stores a lethal amount of electrical charge.
Now image how lethal and destructive a capacitor the size of a pyramid would be when it fails..