Scribd Logo
Upload

Welcome to Scribd!

  • 488 views

    RB 2

    Uploaded by

    MohamedElsawi
    lift emergency product

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    RB 2

    Uploaded by

    MohamedElsawi
    488 views2 pages
    lift emergency product

    Original Title

    rb2

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    lift emergency product

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    488 views2 pages

    RB 2

    Uploaded by

    MohamedElsawi
    lift emergency product

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    POWERVATOR

    RB2

    Emergency Return System

    Original
    Equipment
    Model

    POWERVATOR

    Emergency Return System

    RB2

    Compact size Unit is 7"H x 6.5"W x 8.5"D; total weight is 20 pounds.


    Unit is designed to be installed into the controller at the factory as a single entity or separated into
    sub-assemblies for better controller layout and accessibility.
    Automatic activation unit turns on during power failure to power the entire controller, thereby keeping all safety circuits intact. When required, unit will provide separate voltages for seamless controller,
    valve and door operation. The unit can be triggered by remote reverse phase relay in controller.
    Units are available with 120 VAC, 208 VAC and 240 VAC with or without 260 VDC. CSA approved in
    these voltage combinations.
    Switched 24 VDC which can be used for extra control functions.
    A set of dry contacts are built into the unit which may be used to signal the controller that it is under
    emergency power, aid in power transfer, or pilot other relays.
    Factory wiring eliminates field installation errors, thereby eliminating additional costs.
    Circuit board connection to main disconnect contact will inhibit the unit during maintenance work,
    thereby preventing unexpected power going to the controller or valve.
    Relay and rectifier isolation keep main and emergency power separate.
    Voltage output is automatically regulated to maintain controller stability.
    Unit has replaceable main relay with status indicator.
    ON/OFF and push-to-test switches on circuit board aid in routine diagnostic test and allow safe
    maintenance work.
    Frequency, low battery cutoff, and voltage regulation may be adjusted via adjustable resistors on the
    circuit board.
    Single circuit board design and removable interface connectors allow simpler circuit board exchanges.
    Indicators located on circuit board show low battery, battery charger and inverter activities.
    Batteries, outputs, logic circuitry and battery charger are individually fused for extra protection.
    Maintenance-free, sealed lead-acid batteries are trickle charged to prolong their life. Sealed batteries
    eliminate possibility of dangerous fume build-up in controller.
    CSA approval of unit will assist in maintaining controllers approval and safety rating.

    Up to 500 VA power output


    Regulated output
    Internal current limiting &
    fused protection
    One person installation

    Technical Support
    Dimensions 7"H x 6.5"W x 8.5"D
    Complete unit CSA approved
    1 Year warranty
    Full liability coverage

    Reynolds & Reynolds Electronics, Inc. 649 E. Green Street Allentown, PA 18109
    Tel: 610-691-2224 Fax: 610-691-2869
    www.reynoldselectronics.com E-Mail: [email protected]

    You might also like