Electric CCC PDF
Electric CCC PDF
Electric CCC PDF
Symbol
Conventions
A ow of positive charges gives the same electric cur- of negative charges in the opposite direction. Since current, and has the same eect in a circuit, as an equal ow rent can be the ow of either positive or negative charges,
1
OCCURRENCES
2.1
Reference direction
Ohms law
Ohms law states that the current through a conductor between two points is directly proportional to the
potential dierence across the two points. Introducing 5 Occurrences
the constant of proportionality, the resistance,[7] one arrives at the usual mathematical equation that describes Natural observable examples of electrical current include
this relationship:[8]
lightning, static electricity, and the solar wind, the source
of the polar auroras.
I=
V
R
8.2
Radio waves
Current measurement
Resistive heating
Q I 2R
When an electric current ows in a suitably shaped conductor at radio frequencies radio waves can be generated.
This relationship is known as Joules First Law. The These travel at the speed of light and can cause electric
SI unit of energy was subsequently named the joule and currents in distant conductors.
given the symbol J. The commonly known unit of power,
the watt, is equivalent to one joule per second.
8
8.1
Electromagnetism
Electromagnet
4
charge carriers owing, conventional current is dened to
be in the same direction as positive charges. So in metals
where the charge carriers (electrons) are negative, conventional current is in the opposite direction as the electrons. In conductors where the charge carriers are positive, conventional current is in the same direction as the
charge carriers.
Q
,
t
where Q is the electric charge transferred through the surface over a time t. If Q and t are measured in coulombs
and seconds respectively, I is in amperes.
I=
When a metal wire is connected across the two terminals of a DC voltage source such as a battery, the source
places an electric eld across the conductor. The moment
contact is made, the free electrons of the conductor are
forced to drift toward the positive terminal under the inuence of this eld. The free electrons are therefore the
charge carrier in a typical solid conductor.
I=
dQ
.
dt
9.2 Electrolytes
Main article: Conductivity (electrolytic)
5
an electric eld than the heavier positive ions, and hence
carry the bulk of the current. The free ions recombine
to create new chemical compounds (for example, breaking atmospheric oxygen into single oxygen [O2 2O],
which then recombine creating ozone [O3 ]).[17]
9.4
Vacuum
9.5
Superconductivity
9.6
Semiconductor
11
DRIFT SPEED
J dA
I=
11 Drift speed
The current density (current per unit area) J in mate- gas. In order for there to be a net ow of charge, the
rials with nite resistance is directly proportional to the particles must also move together with an average drift
in the medium. The proportionality con- rate. Electrons are the charge carriers in metals and they
electric eld E
stant is called the conductivity of the material, whose follow an erratic path, bouncing from atom to atom, but
value depends on the material concerned and, in general, generally drifting in the opposite direction of the electric
eld. The speed at which they drift can be calculated from
is dependent on the temperature of the material:
the equation:
J = E
I = nAvQ ,
The reciprocal of the conductivity of the material is
called the resistivity of the material and the above
where
equation, when written in terms of resistivity becomes:
I is the electric current
E
J =
n is number of charged particles per unit volume (or charge carrier density)
= J
E
Typically, electric charges in solids ow slowly. For example, in a copper wire of cross-section 0.5 mm2 , carrying a current of 5 A, the drift velocity of the electrons is
J = E + Dqn,
on the order of a millimetre per second. To take a difwith q being the elementary charge and n the electron ferent example, in the near-vacuum inside a cathode ray
density. The carriers move in the direction of decreasing tube, the electrons travel in near-straight lines at about a
concentration, so for electrons a positive current results tenth of the speed of light.
for a positive density gradient. If the carriers are holes,
Any accelerating electric charge, and therefore any
replace electron density n by the negative of the hole denchanging electric current, gives rise to an electromagnetic
sity p .
wave that propagates at very high speed outside the surIn linear anisotropic materials, , and D are tensors.
face of the conductor. This speed is usually a signicant
In linear materials such as metals, and under low frequen- fraction of the speed of light, as can be deduced from
cies, the current density across the conductor surface is Maxwells Equations, and is therefore many times faster
uniform. In such conditions, Ohms law states that the than the drift velocity of the electrons. For example,
current is directly proportional to the potential dierence in AC power lines, the waves of electromagnetic energy
between two ends (across) of that metal (ideal) resistor propagate through the space between the wires, moving
from a source to a distant load, even though the electrons
(or other ohmic device):
in the wires only move back and forth over a tiny distance.
The ratio of the speed of the electromagnetic wave to the
speed of light in free space is called the velocity factor,
and depends on the electromagnetic properties of the conwhere I is the current, measured in amperes; V is the ductor and the insulating materials surrounding it, and on
potential dierence, measured in volts; and R is the their shape and size.
I=
V
,
R
7
The magnitudes (but, not the natures) of these three velocities can be illustrated by an analogy with the three
similar velocities associated with gases.
The low drift velocity of charge carriers is analogous
to air motion; in other words, winds.
The high speed of electromagnetic waves is roughly
analogous to the speed of sound in a gas (these waves
move through the medium much faster than any individual particles do)
The random motion of charges is analogous to heat
the thermal velocity of randomly vibrating gas particles.
12
See also
Current 3-vector
Direct current
Electric shock
Electrical measurements
History of electrical engineering
Hydraulic analogy
International System of Quantities
SI electromagnetism units
13
References
[1] Anthony C. Fischer-Cripps (2004). The electronics companion. CRC Press. p. 13. ISBN 978-0-7503-1012-3.
[2] Lakatos, John; Oenoki, Keiji; Judez, Hector; Oenoki,
Kazushi; Hyun Kyu Cho (March 1998). Learn Physics
Today!". Lima, Peru: Colegio Dr. Franklin D. Roosevelt.
Retrieved 2009-03-10.
[3] T. L. Lowe, John Rounce, Calculations for A-level Physics,
p. 2, Nelson Thornes, 2002 ISBN 0-7487-6748-7.
[4] Howard M. Berlin, Frank C. Getz, Principles of Electronic
Instrumentation and Measurement, p. 37, Merrill Pub.
Co., 1988 ISBN 0-675-20449-6.
[5] A-M Ampre, Recuil d'Observations lectro-dynamiques,
p. 56, Paris: Chez Crochard Libraire 1822 (in French).
[6] Electric Power, vol. 6, p. 411, 1894.
[7] Consoliver, Earl L., and Mitchell, Grover I. (1920).
Automotive ignition systems. McGraw-Hill. p. 4.
[8] Robert A. Millikan and E. S. Bishop (1917). Elements of
Electricity. American Technical Society. p. 54.
14 External links
Allaboutcircuits.com, a useful site introducing electricity and electronics
15
15
15.1
15.2
Images
15.3
Content license
File:SI_base_unit.svg Source: http://upload.wikimedia.org/wikipedia/commons/c/c8/SI_base_unit.svg License: CC-BY-SA-3.0 Contributors: I (Dono (talk)) created this work entirely by myself. Base on http://www.newscientist.com/data/images/archive/2622/26221501.jpg
Original artist: Dono (talk)
File:Symbol_book_class2.svg Source: http://upload.wikimedia.org/wikipedia/commons/8/89/Symbol_book_class2.svg License: CCBY-SA-2.5 Contributors: Mad by Lokal_Prol by combining: Original artist: Lokal_Prol
15.3
Content license