Scribd
Upload
1K views1 page

4 T 65 e

This document provides installation instructions for a 4T65E universal wiring harness. It instructs the user to note the position of the original wiring harness and connectors on the valve body before removing it. The new harness should then be installed in the same position as the original and the mating connectors plugged in as shown. Unused connectors should be zip tied out of the way and the original factory clips can be reused to hold the new harness in position. Diagrams are provided showing which connectors to use or not use depending on the vehicle year and application.

Uploaded by

kkg4782
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

4 T 65 e

This document provides installation instructions for a 4T65E universal wiring harness. It instructs the user to note the position of the original wiring harness and connectors on the valve body before removing it. The new harness should then be installed in the same position as the original and the mating connectors plugged in as shown. Unused connectors should be zip tied out of the way and the original factory clips can be reused to hold the new harness in position. Diagrams are provided showing which connectors to use or not use depending on the vehicle year and application.

Uploaded by

kkg4782
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

4T65E Universal Wiring Harness

Installation Instructions

Rostra Precision Controls, 2519 Dana Dr., Laurinburg, NC 28352 800-782-3379 www.rostra.com
1. Note position of original wire harness and connectors on valve body, then remove wire harness.
2. Install new harness in same position as the original, plug in mating connectors as shown below.
3. Use zip ties to hold unused connectors out of the way as shown. Unused wires will not cause any
shorting issues. Re-use original factory clips to hold wire harness in position.
Note: 2 pin white connector may be present instead of green connector.

97- 02 (14 PIN) APPLICATIONS


Do Not Use
Lt. Gray 1 Pin
and Green 6 Pin

Re-use
factory
clips

Temperature
Sensor 2 Pin

99- 02 (19 PIN) APPLICATIONS


Do Not Use
Lt. Gray 1 Pin

Shift Solenoid
Green 2 Pin

Pressure Switch
White 4 Pin

Temperature
Sensor 2 Pin

03- UP (16 and 17 PIN) APPLICATIONS


Do Not Use
White 4 Pin

Temperature
Sensor 2 Pin
Form #5044, Rev. E, 12-03-10

Pressure Switch
Lt. Gray 1 Pin

Mode Switch
Green 6 Pin

Pressure Switch
White 4 Pin

ALL 4T65E APPLICATIONS


EPC
Lt. Gray 2 Pin
Blue & Purple

Shift Solenoid
Green 2 Pin
Mode Switch
Green 6 Pin

Shift Solenoid
Green 2 Pin

TCC Solenoid
Blue 2 Pin
Red & Brown

Main
Connector

Shift Solenoid
Green 2 Pin
Red & Green

Speed Sensor
Green 2 Pin
Black & Green

You might also like