EIE Format
EIE Format
EIE Format
By
ABCD (0501218)
EFGH (0501218)
ABED (0501218)
This is to certify that the thesis entitled “TITLE” is a bona fide record of
the major project/seminar topic done by ABCD (0501218), EFGH (0501218) and
KLMN (0501218) under my supervision and guidance, in partial fulfillment of the
requirements for the award of Degree of Bachelor of Technology in Applied Electronics
& Instrumentation Engineering from Purushottam Institute of Engineering &
Technology, Rourkela for the year 2008-09
Name of guide
(Guide)
Dept. of AEIE
Name of HOD
Asst. Professor & Head
Dept. of AEIE
Place:
Date:
Department seal
ACKNOWLEDGEMENT
to project guide
Provide correct name & designation
to all others (if any) especially the name of the firm(s) (if any)if you have collected any
data or some thing for the project
ABCD, EFGH,KLHG
List name of all students
ABSTRACT
List of Abbreviations ii
List of Symbols iii
List of Figures iv
List of Tables v
1 INTRODUCTION 1
1.1 Introduction 1
1.2 Problem Definition 2
1.3 Outline 3
2 REVIEW OF MODELS 4
2.1 Significance of Models 5
2.1.1 Art of Modelling 6
6 CONCLUSION 68
6.1 Conclusion 68
6.2 Future Scope of work 69
Appendix only, If required. Computer codes (developed for the project if any, lengthy
derivations, explanations/details of some already existing algorithms, formulations used in the
thesis shall be given in the appendices.
ii
List of Abbreviations
iii
List of Symbols
Vpp – Voltage corresponding to peak power
Io = Output current in A
Vo = Output voltage in V
Iph = Photon current in A
Isat = Dark saturation current = 10-5 to 10-15 A
q = charge of an electron = 1.6 X 10-19 C
A = Diode ideality factor = 1 to 5
K = Boltzmann constant =1.38 X 10-23 J/K
T = absolute temperature in K
Rse = Series resistance in ohms
Rsh = Shunt resistance in okms
iv
List of Figures
Figure No Title Page No.
v
List of Tables
vi
Continues text of thesis starts from here
CHAPTER 1
INTRODUCTION
1.1 Introduction
Use MS Word or equivalent LATEX . Chapter/section headings shall be as per the fonts
size shown below. All chapters to be started on a fresh page.
The preliminary parts are numbered in roman numerals (i, ii, etc). The first page of the
chapter-1 onwards will be numbered in Arabic numerals 1 2 3 etc.
Follow internationally accepted symbols, rules and conventions: use the international
system of units (SI). If other quantities are mentioned, give their equivalent in SI.
List the Greek symbols first English letters next, lower case letters and upper case letters
in this order. Each group should be arranged in alphabetic order.
Number consecutively any equations that have to be displayed separately from the text.
Example first equation in chapter 3 shall be
2x + 3 = 4 (3.1)
Reference to a book:
[21] E. Clarke, Circuit Analysis of AC Power Systems, Vol. I. 2nd ed , New York:
Wiley Publications, 1950, p. 81.