Scribd
Upload
138 views4 pages

Computer Room Rules

1. The document provides rules for computer room equipment and cabling. Users should clearly label all equipment, peripherals, cords and cables with identifying information. 2. Cables should be dressed neatly by running them in approved cable ducts or under raised floors, supported at regular intervals, and only through intended entry areas of enclosures. Temporary or improperly run cables are not allowed. 3. Equipment should be installed in fixed racks when possible, with rack-mount kits if needed. Unused equipment should be removed from racks and nothing should be stored in the computer room. All surfaces must be kept neat and clean.

Uploaded by

motenelindi805
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
138 views4 pages

Computer Room Rules

1. The document provides rules for computer room equipment and cabling. Users should clearly label all equipment, peripherals, cords and cables with identifying information. 2. Cables should be dressed neatly by running them in approved cable ducts or under raised floors, supported at regular intervals, and only through intended entry areas of enclosures. Temporary or improperly run cables are not allowed. 3. Equipment should be installed in fixed racks when possible, with rack-mount kits if needed. Unused equipment should be removed from racks and nothing should be stored in the computer room. All surfaces must be kept neat and clean.

Uploaded by

motenelindi805
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Computer room rules

1. Don't allow anyone else to use


your password
because you might get blamed for
something they do.
2. Only use the Internet with
permission
and remember that your Email
address identifies who you are.
3. Don't touch a computer that is
being used by someone else
and always ask before logging off an
unused computer.
4. Ask before you print
and always put your name on your
work.
5. No food and drink in computer
rules
because it can damage the equipment
6. Sit properly and comfortably
and tell your teacher if you regularly
get headaches after using computers.
7. Treat the equipment with
respect
and always report any damaged
equipment.
8. Transfer data files but not
programs
Large files will be deleted. Do not
attempt to install software on the
network.
Computer Room RULES
Copyright (C) 1996, 2006 JXH Consulting <[email protected]>
Please give proper credit when using this information.
1. Label practically everything.
• Clearly label all equipment with its hostname or other identifier, on both the front and back panels.
• Label all peripherals with the hostname and device name or number (e.g. host:c1t2).
• Label all cords and cables greater than 1 meter long, at both ends, with the name of the host or equipment,
the port number on the equipment if more than one (e.g. host:le0), and the type of cable if ambiguous
(e.g. "RS-232" on RJ-11 cords).
• Label phone cords with their type and group-number (e.g. "Modem 1", "ISDN 3") at both ends, and each
jack with its directory number.
• Label data circuit cords (e.g. RJ-48S), at both ends, with the name of the far end of the circuit (e.g.
"Trumbull"), and each jack with its circuit identifier.
2. Dress all cords and cables neatly.
• Do not run any cables across the floor, or suspended in a catenary.
• Run all cables inside an approved cable duct, even under a raised floor.
• Support all cables greater than 1 meter long at regular intervals along their length, not more than 0.5
meter apart. Tie cables to fixed supports near the ends.
• Run cables between enclosures only through the intended entry areas. Close all doors and panels
afterward.
• Do not run "temporary" cords or cables in violation of these rules, even for an instant. GET A LONGER
CABLE. Where electrical specifications limit cable length (e.g. SCSI), relocate the equipment.
3. Install all equipment in fixed racks, if possible.
• Obtain rack-mount kits, if not supplied.
• Pay attention to unit boundaries (1.75"); the holes are not evenly spaced.
4. Remove all unused equipment from the racks.
5. Do not store equipment or materials in the computer room.
6. Keep all surfaces neat and clean at all times.

You might also like