Calculate Heat-Cool Time - Batch Reactor
Calculate Heat-Cool Time - Batch Reactor
Calculate Heat-Cool Time - Batch Reactor
Home
The time to heat or cool a fixed mass of liquid inside a batch reactor is calculated.
The primary simplification here is that both the utility and process heat capacity as well as the overall heat transfer coefficient
are assumed constant throughout.
Liquid Jacket Utility: The jacket is a 'one pass' with a fixed flowrate of liquid at inlet temperature T1.
A closed form solution has been developed and is shown at the bottom of the page.
Steam Jacket Utility: With steam at specified inlet pressure (assumed to be saturated) the time to heat is based
on isothermal condensation in the jacket with as much steam passing through the trap as heat transfer will allow.
Simple closed form solution below.
_______________________________________________________________________________________________
INPUT DATA
Input Units (or pick and choose)
Metric
British
Recalculate if change
individual unit
selections
Reactor Contents Process Data
Liquid or Steam as jacket utility Steam
Initial temperature, T0 25
Final temperature, Tf 60
Heat capacity, Cp 1.9
Mass of liquid, m 13500
Jacket and Utility Liquid Data
Overall HX coefficient, U 370
Heat transfer area, A 35
Jacket liquid inlet temperature, T1 70 Liquid Utility
Jacket liquid flowrate, W 982 Liquid Utility
Jacket liquid heat capacity, C 4.186 Liquid Utility
Inlet steam pressure, P0 10.0 Steam Utility
_______________________________________________________________________________________________
RESULTS
Heating / Cooling Time minutes
Calculate Heat/Cool time - Batch reactor http://www.eng-calculations.com/heat time - batch reactor.aspx
1 di 2 24/01/2014 14:52
_______________________________________________________________________________________________
EQUATIONS (Liquid in Jacket)
Heat input to reactor at T = Heat loss by utility liquid with inlet temperature T1 (specified) and outlet temperature T2
(unknown)
Solving for the unknown jacket outlet temperature T2
The rate of temperature change of the liquid inside the vessel is given by
Solving the above two equations to get process temperature as a function of time:
Finally, solving for time t where T = Tf (with T = T0 at t = 0)
EQUATIONS (Steam in Jacket)
Calculate Heat/Cool time - Batch reactor http://www.eng-calculations.com/heat time - batch reactor.aspx
2 di 2 24/01/2014 14:52