Upper Thread Catcher-Wiper

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

UPPER THREAD CATCHER SINGLE HEAD

Installation Directions for the Upper Thread Catcher. WIPER Tools Needed
2.5MM T-Handle Allen Wrench 3.0MM T-Handle Allen Wrench.

Loosen the set screw (2.5mm) from the Positioning Collar Bracket.

Remove the set screws (3mm) from the Cap Guide

Remove the Cap Guide.

Revision Date / Version: 3/7/2014 - 2

UPPER THREAD CATCHER SINGLE HEAD

Fig 1

Fig 2

Remove the Wiper (Upper Thread Catcher Set) from Positioning Collar Bracket.

Fig 3

Fig 4

Now Mount the new Wiper back into the Positioning Collar Bracket (Fig 1) and mount the Cap Guide back on, Make sure the Wiper feeds through the opening of the Cap Guide Mount Bracket (Fig 4.).

Revision Date / Version: 3/7/2014 - 2

UPPER THREAD CATCHER SINGLE HEAD

Presser Base Cover Fig 1 Fig 2 Wiper

Make sure to slide the Driving Link up and down a few times before tightening the set crew (2.5mm) from the Positioning Collar Bracket, that way the Wiper Shaft will position itself having a smooth up and down movement, when the up and down movement of the wiper is smooth tighten the set screw (2.5mm) from the Positioning Collar Bracket. Also make sure the tip of the Wiper feeds through the Presser Base Cover Velcro (fig 2.). To make sure that the install was a succes we need to perform a wiper test, if the Wiper moves up and down freely you have succesfully install the Upper Thread Catcher.

Sammy P. Codesi.

Revision Date / Version: 3/7/2014 - 2

You might also like