Scribd
Upload
261 views19 pages

Ansys Code For Semimonocoque

This document summarizes an ANSYS analysis of a semi-monocoque structure. It describes creating the shell element model with cutouts, applying loads, and solving for deformation, von Mises stress, and buckling modes. The analysis found the maximum stress occurs at the cutouts and identifies the first three buckling mode shapes.

Uploaded by

srikanth sikhakolli
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
261 views19 pages

Ansys Code For Semimonocoque

This document summarizes an ANSYS analysis of a semi-monocoque structure. It describes creating the shell element model with cutouts, applying loads, and solving for deformation, von Mises stress, and buckling modes. The analysis found the maximum stress occurs at the cutouts and identifies the first three buckling mode shapes.

Uploaded by

srikanth sikhakolli
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 19

]]

ANSYS
Results for Semi-monocoque structure
Preference: Structural

Preprocessor:
 Element type: SHELL99
 Real Constants:
Mat no. theta thk
Set 1: 1.0000 0.0000 3.800
Set 2 : 1.0000 0.0000 40.000
 Section type:

 Material Properties:

Linear  Elastic  Isotropic

Young’s modulus [E] = 70000 Poisson’s ratio [ν] = 0.33


 Modeling:

 Creating key points:


Key point number = 1
X, Y, Z= 0.00000 0.00000 0.00000

Key point number = 2


X, Y, Z= 0.00000 1000.00 0.00000

Key point number = 3


X, Y, Z= 500.000 1000.00 0.00000

Key point number = 4


X, Y, Z= 500.000 0.00000 0.00000
 Creating line:
Line between key points 1 & 2

 Extruding line:
Extrude the line about key points 3 & 4
 Extruded model:

 Creating bulkheads by dividing by work plane:


 Creating cutouts at the centre by dividing the area by cylindrical volume:

 With cutouts:
 Meshing:
Creating T-section stiffeners

Stiffeners:
Mesh attribute for bulkheads:

 Bulkheads & Stiffeners


Meshed object:

 Loads:
Static analysis
Fixed at the bottom
Force Fy on selected nodes.
Fy = -4629.60000

 Static analysis:
 Solution(static)
Solving the problem.
Eigen buckling:
 General Postprocessor:
Plot Results
 Deformed shape
Side view showing the cutouts deformation

 VonMises stress:
 Stress at the cutout showing the maximum value

 Buckling
Mode shape: 1
Mode shape: 2

Mode shape: 3

You might also like