Changing Rotors Brake

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

Rotors

http://www.danoland.com/nsxgarage/brakes/rotors/rotors.htm

DIY Home

Rotors

Time, Total Time, Cost, First-Time Cost Number of Persons Difficulty level Tools Special Tools Special Parts Service Manual Pages Service Interval Prerequisite www.nsxprime.com

30min, 1h35min/1h55min, $0-0, $0-0 1 5 Torque wrench, 17mm socket, Ratchet, 8mm screw (optional), emery cloth, impact screwdriver (optional) None Rotors 18-15, 19-5, 19-16, 19-9-10, 19-19-20 jack (20min), front/rear wheels (15min), remove front/rear calipers (30min/50min)

Inspection

1 of 5

08/02/2013 13:42

Rotors

http://www.danoland.com/nsxgarage/brakes/rotors/rotors.htm

Procedure

1. Prepare tools: we will need a torque wrench, a ratchet, 17mm socket, a 8mm screw (use a break hose bracket bolt 12mm socket, see removing front/rear calipers) and some emery cloth. An impact screwdriver may be necessary in case your rotors are attached to the hub with Phillips screws.

2 of 5

08/02/2013 13:42

Rotors

http://www.danoland.com/nsxgarage/brakes/rotors/rotors.htm

2. Jack up the car and remove the appropriate wheels. 3. Remove the front / rear calipers.

4. Remove the two caliper bracket bolts, use the 17mm socket and torque wrench or breaker bar to initially break the screws loose--they're on there tight. Use the ratchet or your fingers to loosen the screws the rest of the way.

3 of 5

08/02/2013 13:42

Rotors

http://www.danoland.com/nsxgarage/brakes/rotors/rotors.htm

5a. If your rotors are held on by two Phillips screws, then these need to be removed first using the impact screwdriver. Just place the tool over the Phillips screw head and strike with a hammer and the screws will easily loosen. 5b. If necessary, use the 8mm screw to break the rotor free. First use one of the 8mm screw holes in the rotor and turn the screw until the rotor breaks free, do the same with the other side of the rotor to completely break it free 6. Remove the rotor

4 of 5

08/02/2013 13:42

Rotors

http://www.danoland.com/nsxgarage/brakes/rotors/rotors.htm

7. Clean off any oxidation from the hub and both sides of the rotor and wheel where the rotor makes contact with the hub and wheel. Use the emery cloth. Here I'm using a die grinder with a Scotchbrite pad to knock off the oxidation buildup. 8. Reinstall the rotor 9. Reinstall the caliper bracket and the two screws--torque them two 80 lb-ft (17mm socket) 10. Reinstall the caliper, don't forget to put the 8mm brake hose bracket screw back on if applicable 11. Reinstall the wheel 12. Lower the car and torque the lug nuts

5 of 5

08/02/2013 13:42

You might also like