May 1999

CT T ODU CEMEN 7 R P E A 74 T L 7 E OL REP 00-442OBS ENDED 8 1 m s.co MM ions ECO pplicat p@harri R O N ral A centap Cent : Call or email

CA3088E
AM Receiver Subsystem and General-Purpose Amplier Array

[ /Title (CA30 88E) /Subject (AM Receiv er Subsystem and GeneralPurpose Amplier Array) /Autho r () /Keywords () /Creator () /DOCI NFO pdfmark [ /PageMode /UseOutlines /DOCVIEW pdfmark

Features
Excellent Overload Characteristics AGC for IF Amplier Buffered Output Signal for Tuning Meter Internal Zener Diode Provides Voltage Regulation Two IF Amplier Stages Low-Noise Converter and First IF Amplier Low Harmonic Distortion (THD) Delayed AGC for RF Amplier Terminals for Optional Inclusion of Tone Control Operates from Wide Range of Power Supplies: V+ = 6V to 16V Optional AC and/or DC Feedback on Wide-Band Amplier Array of Ampliers for General-Purpose Applications Suitable for Use With Optional External RF Stage, Either MOS or Bipolar Related at: - Refer to AN6022 for Application Note Information

Description
The CA3088E, a monolithic integrated circuit, is an AM subsystem that provides the converter, IF amplier, detector, and audio preamplier stages for an AM receiver. The CA3088E also provides internal AGC for the rst IF amplier stage, delayed AGC for an optional external RF amplier, a buffer stage to drive a tuning meter, and terminals facilitating the optional use of a tone control. Figure 2 is a functional diagram of the CA3088E. The signal from the low-noise converter is applied to the rst IF amplier and is then coupled to the second IF amplier. This IF signal is then detected and externally ltered. The resultant audio signal is applied to an audio preamplier. Optionally, a tone control circuit may be connected at the junction of the detector circuit and the audio preamplier. The gain of the rst IF amplier stage is controlled by an internal AGC circuit. The CA3088E supplies a delayed AGC signal output for use with an external RF amplier. A buffered output signal is also available for driving a tuning meter. A DC voltage, internally regulated by a Zener diode, supplies the second IF amplier, the AGC and tuning meter circuits and may also be used with any other stage. The CA3088E features four independent transistor ampliers, each incorporating internal biasing for temperature tracking. These ampliers are particularly useful in generalpurpose amplier, oscillator, and detector applications in a wide variety of equipment designs.

Part Number Information

Pinout
CA3088E (PDIP) TOP VIEW

CONV. BYPASS 1 CONV. IN 2 CONV. OUT 3 1ST IF IN 4 GND 5 1ST IF OUT 6 2ND IF FB 7 2ND IF IN 8

16 AUDIO V+ 15 AUDIO OUT 14 AUDIO IN 13 RF AGC 12 TUNING METER 11 AGC FILTER 10 2ND IF V+ 9 DET. OUT

CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper IC Handling Procedures. Copyright

Harris Corporation 1999

File Number

560.2

8-23

CA3088E
Absolute Maximum Ratings
TA = 25oC

Thermal Information
Thermal Resistance (Typical, Note 1) JA (oC/W) PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110 Maximum Junction Temperature (Plastic Package) . . . . . . . 150oC Maximum Storage Temperature Range . . . . . . . . . -65oC to 150oC Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300oC

Supply Voltage (Across Term. 5 and Terms. 3, 6, 13, 16, Respectively) . . . . . 16V Output Current Terminals 3, 6, 13, 16, (Respectively). . . . . . . . . . . . . . . . . 10mA Terminal 10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30mA

Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . -40oC to 85oC
CAUTION: Stresses above those listed in Absolute Maximum Ratings may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specication is not implied.

NOTE: 1. JA is measured with the component mounted on an evaluation PC board in free air.

Electrical Specications
PARAMETER DC CHARACTERISTICS Voltage (Figure 1)

TA = 25oC, V+ = 12V SYMBOL TEST CONDITIONS MIN TYP MAX UNITS

V1, V4, V9, V11 V2, V7, V8 V10 V12 V15

Terminals 1, 4, 9, 11 Terminals 2, 7, 8 Terminal 10 Terminal 12 Terminal 15 Terminal 3 Terminal 6 Terminal 10 Terminal 13 Terminal 16

0.7 1.4 5.6 0 3.5 0.35 1.0 20 0 1.2

V V V V V mA mA mA mA mA

Current (Figure 1)

I3 I6 I10 I13 I16

DYNAMIC CHARACTERISTICS Detector Output (Figure 2) Audio Amplifier Gain (Figure 2) Audio Distortion (Figure 2) Sensitivity (fIN = 1MHz, Signal-to-Noise Ratio (S/N) = 20dB)) Total Harmonic Distortion (Figure 2) Input Resistance (No AGC, fIN = 1MHz) Input Capacitance (No AGC, fIN = 1MHz) Feedback Capacitance (No AGC, fIN = 1MHz) THD RIN AAF 30% Modulation f = 1kHz VOUT = 100mV At Converter Stage Input (Figure 2) At RF Stage Input (Figure 2) 30% Modulation At Transistor Q1 At Transistor Q5 CIN At Transistor Q1 At Transistor Q5 CFB At Transistor Q1 At Transistor Q5 75 30 0.2 200 100 1.0 3500 2000 17 12 1.5 1.5 mVRMS dB % V/m V/m % pF pF pF pF

8-24

CA3088E
V+ = 12V

0.1F

0.1F

CA3088E

16 15 14 13 12 11 10 330 5k 2k 5k 1k

FIGURE 1. TEST CIRCUIT FOR DC CHARACTERISTICS

200 0.05F OSC. TUNING 3 GANG 2 0.05 CONVERTER TO RF STAGE OF ANTENNA IF AMPLIFIER 0.05F

100

150 V+ = 9V

130pF 0.039 4 6 7 8 0.05 10

0.02

2000

0.01

10K

9 2ND IF AMPL. AND DET. TO DETECTOR FILTER AND AUDIO (OPTIONAL TONE CONTROL MAY BE SHUNTED FROM TERMINAL 9 TO GROUND) 25

CA3088E METER OUTPUT 1 0.01 AGC TO RF AMPLIFIER 13 RF AGC IF AGC AUDIO PREAMPLIFIER

TO TUNING 12 METER

14

FROM DETECTOR FILTER 5600

AUDIO 15 OUTPUT

25 6800 5 SUBSTRATE 50 11 16 V+ = 9V 10 1500

NOTE: Resistance values are in . Capacitance values in F, except as noted. FIGURE 2. FUNCTIONAL BLOCK DIAGRAM OF THE CA3088E

8-25

CA3088E
CONVERTER INPUT BYPASS CONVERTER 3 1 OUTPUT CONVERTER INPUT 2 Q1 Q5 Q7 Q9 R2 2K R8 4K R13 5K R16 5K R14 5K

1ST IF AMPLIFIER 4 INPUT 6 OUTPUT

2ND IF AMPLIFIER 8 INPUT R15 5K Q10

V+ 10

200

Q12 9 7 DETECTOR OUTPUT SECOND IF FEEDBACK

5.6V R1 6.8K R3 4K Q2 D1 D2 Q6 Z1 R12 4.7K 200 R19 Q14 6.8K R21 5.6K Q4 D3 D4 Q3 R7 1.5K R11 2.2K R6 2K R9 1K R10 220 D5 R17 200 Q8 Q11 Q13 R20 1.2K R18 6K 200

16 V+

AUDIO 15 OUTPUT

R4 700

R5 5.5K

ALL RESISTANCE VALUES ARE IN OHMS

SUBSTRATE

13 AGC OUTPUT 11 FOR OPTIONAL RF STAGE

12

AGC FILTER

TO TUNING METER

14

AUDIO INPUT FROM DETECTOR FILTER

FIGURE 3. SCHEMATIC DIAGRAM OF THE CA3088E

8-26

This datasheet has been downloaded from: www.DatasheetCatalog.com Datasheets for electronic components.