0% found this document useful (0 votes)
862 views2 pages

Moshell

This document lists Node B Moshell commands used for monitoring and troubleshooting purposes. It describes commands to check alarms, sectors and carriers status, VSWR values, configuration values settings, cabinet restarts, temperature readings, and other parameters for performance monitoring and fault detection on the Node B.

Uploaded by

Shahzad Ahmed
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
862 views2 pages

Moshell

This document lists Node B Moshell commands used for monitoring and troubleshooting purposes. It describes commands to check alarms, sectors and carriers status, VSWR values, configuration values settings, cabinet restarts, temperature readings, and other parameters for performance monitoring and fault detection on the Node B.

Uploaded by

Shahzad Ahmed
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Node B Moshell Commands

Ping 172.20.43.1 Ping 172.20.43.5 (Riyadh OSS) Ping 172.20.43.7 (Jeddah OSS) L+ site id(ZNJ150).log Lt all ala get radio no lh asc dbg vswr 0 get -k lh asc asc vswr cv cu cvrm <name> cv rbset <name> cv set <name> cv rbrm <name> cv ls cvms <name> <userid> <comments> st cell get 10 cab st ip Lset proxy# vid .. acc 0 manualrestart enter enter enter 123 Bl deb lt all S+ St ru St plug Pmr

load the 3G Cabinet Check the alarm in Node B Show the Sectors & Carriers up & Down (Working) To Check VSWR for (asc/4) To Check VSWR for (asc/3) Show the current cv working Remove CV Set first in rollback list Set as startable Remove from rollback list Show the total cv Create backup CV Show the status of Sectors (Disable & Enabled) To show the Synchronization mode To Show Sub rack temperature To Show O&M and IUB proxy (line 2(40) & line 3(41)) Proxy 40(IUB) & Proxy 41(O&M) To Change VLAN ID restart cabinet

enter block ru than proxy no on block ru proxy no load all MOs get ru sr. no will get ruw proxy no (on serial) for cab 6201 will get ru proxy no (on serial) cab for 3206 for performance

LTE commons (DUL)


Lga Lge Acc 0 manualrestart enter enter enter ST rru Get . vid St ip St interface=1 St interface=2 Ue print admitted to get log file to get event log file restart DUL

get proxy you get v id you find interface proxy. change vid for traffic change vid for O&M for chaking calls on site

Lh ru fui get vswr

for VSWR on active carriers

You might also like