Scribd
Upload
1K views1 page

AS/NZS 3017:2007 Sets Out Some of The Common Test Methods Required To Test That A Low Voltage Electrical Installation Complies With AS/NZS 3000:2007

This document provides the results of mandatory testing carried out on a low voltage electrical installation in accordance with Australian standards. It records measurements of insulation resistance, earth continuity, polarity, circuit connections and overcurrent protective devices for the main switchboard, submains, and final subcircuits. Any issues identified during testing are noted. The test equipment used is also documented along with identification information for the electrical worker and installation.

Uploaded by

Dhirendra Singh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
1K views1 page

AS/NZS 3017:2007 Sets Out Some of The Common Test Methods Required To Test That A Low Voltage Electrical Installation Complies With AS/NZS 3000:2007

This document provides the results of mandatory testing carried out on a low voltage electrical installation in accordance with Australian standards. It records measurements of insulation resistance, earth continuity, polarity, circuit connections and overcurrent protective devices for the main switchboard, submains, and final subcircuits. Any issues identified during testing are noted. The test equipment used is also documented along with identification information for the electrical worker and installation.

Uploaded by

Dhirendra Singh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 1

Date:

SCHEDULE OF TEST RESULTS Mandatory testing shall be carried out in accordance with AS/NZS 3000:2007 clause 8.3. AS/NZS 3017:2007 sets out some of the common test methods required to test that a low voltage electrical installation complies with AS/NZS 3000:2007.
ECC No: Address / location: Signature: PSC at Main Switch: A, W
Serial No. Serial No.
b

OTR Reference No: Registered Electrical Workers name: Switchboard / distribution board No: Incoming current (if supply avail.): R
Test Equipment: Type: Type:

Registration no. PGE All live parts screened from touch without use of tool: Yes / No

kA A.
Calibration date: Calibration date: Type: Type:

A,

Serial No. Serial No.

Calibration date: Calibration date:

MAIN SWITCHBOARD, CONSUMERS MAINS & MAIN EARTH


M.E.N. Connection & Main Switchboard earthing compliant :- Y / N Main Switch / Load Limiter Conductor Earth Continuity - ohms Insulation Resistance - Megohms Polarity

Type

Current rating A

PSCb rating

C.C.C
c

Size mm

Main earth conductor

EQ bonding conductorsd

A-E

A-N

N-E

Phase Phased

R/ S

Correct circuit connections

Comments:

Circuit ID & no. of Phases Over Current Protective Device Conductor

SUBMAINS
Insulation Resistance - Megohms Polarity Correct Earth fault RCD test results circuit loop Push button Current trip Supply not connections impedance test test - ms avail.

Earth Continuity - ohms

Type

Current rating A

PSCb rating

C.C.C
c

Size mm

Submain earths

EQ bonding conductorsd

A-E

A-N

N-E

Phase Phased

R/ S

No RCD


Circuit ID & no. of Phases Over Current Protective Device Conductor


FINAL SUB CIRCUITS
Insulation Resistance - Megohms Polarity


Correct Earth fault RCD test results circuit loop Push button Current trip Supply not connections impedance test test - ms avail.

Earth Continuity - ohms

Typea

Current rating A

PSCb rating

C.C.C
c

Size mm

Protective earths

EQ bonding conductorsd

A - Ed

A - Nd

N-E

Phase Phased

R/ S

No RCD


NOTES:
a b c

Protective device types : Rewirable fuse = rf, HRC fuse = hrc, Circuit breaker = c/b B,C or D, MCB/RCD combo = rcd, Isolator = isol. PSC = Prospective Short-circuit current in kA. Ref: AS/NZS 3000:2007 clause 2.5. C.C.C = Current Carrying Capacity of the conductor after derating in A. Ref: AS/NZS 3000:2007 clause 3.4. d Where multiple results are obtained due to multiphase, multiple EQ bonds etc. record the lowest insulation resistance & highest earth resistance readings obtained.

You might also like