DENACTIVE Brill Red Spe

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

Document No: BUL.MSDS.

66_en

MATERIAL SAFETY DATA SHEET DENACTIVE BRILL RED SPE


1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name
General Use Product Description

Date of issue : 02.05.2012 Revision No: 0

DENACTIVE RED SPE REACTIVE DYESTUFF Reactive Dyestuff CI. Reactive Red 223

Safety Signs

DENGE KMYA & TEKSTL SAN. TC. LTD. T. Factory: erkezky Yolu zeri Akbayr Mevkii Velimee Ky 59850 orlu TURKIYE Phone: +90 (0282) 674 54 00 (pbx) Fax :+90 (0282) 674 50 01 Web: www.dengekimya.com E-mail: [email protected]

Company Identification

2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Denactive Red SPE CAS No:

80019-42-7

3. HAZARDS IDENTIFICATION
Emergency Overview Potential Health Effects Dust can be a nuisance. Based on similar products, material may cause sensitization by inhalation. Eye contact Skin contact Ingestion Non-irritating Non-irritating. Practically non-toxic in normal industrial use. Practically non-toxic in normal industrial use. No known effects Dark red powder that presents little or o immediate hazard. Avoid contact with skin and eyes.

Inhalation

Chronic

4. EMERGENCY AND FIRST AID MEASURES


Ingestion Inhalation If swallowed get medical attention. If exposure to dust causes irritation or distress, remove person to fresh air. Give oxygen or artificial respiration if needed. Get medical attention. Immediately flush skin with soap and plenty of water. Remove clothing Wash clothing before reuse. Get medical attention. Eye Contact Immediately flush eyes with plenty of water for at least 15 minutes and contact a physician.

Skin Contact

1/4

Document No: BUL.MSDS.66_en

MATERIAL SAFETY DATA SHEET DENACTIVE BRILL RED SPE

Date of issue : 02.05.2012 Revision No: 0

5. FlRE-FIGHTING MEASURES AND EXPLOSION HAZARD DATA


Flash Point Not known (Material is a powder)

Flammable limit

Not applicable

Extinguishing media Autoignition temperature Special Fire-Fighting Measures: Explosion Hazards Hazardous decomposition products:

Non-flammable About 300C Not applicable To reduce potential explosion hazard, avoid dispersion of dust in air. May generate SOx, NOx or CO when heated to burning

6. ACCIDENTAL RELEASE MEASURES


General Notify the appropriate authorities immediately. Take all additional action necessary to prevent and remedy the adverse affects of the spill.

Land Spill

Collect in a dustless manner such as a vacuum cleaner or soak up with saw dust, then wash away any remaining traces. Prevent washings from entering waterways.

7. HANDLING AND STORAGE


Avoid breathing dust. Avoid contact with eyes. Avoid prolonged or repeated contact with skin. Use with adequate ventilation. May form explosive dust-air mixtures. Ground and bondcontainers when transfening material. Store at room temperature. Keep containers closed when not in use.

PRECAUTIONS

8. EXPOSURE CONTROLS AND PERSONAL PROTECTION


Ventilation Use local ventilation at places where dust can be released into the workplace air. Keep dust concentrations below recommended TLV. ACGIH TLV for "Particles otherwise not classified"= 10mg/m Personal Protection:
3

Respiratory

Not required for occasional handling if adequate ventilation is available. A dust respirator is recommended for prolonged handling or exposure.

Protective Gloves Eye Protection Other Work/Hygenic Practices

Wear rubber gloves. Wear safety goggles or equivalent eye protection. Wear appropriate protective clothing to prevent skin contact. Always clean protective equipment and workplace.

2/4

Document No: BUL.MSDS.66_en

MATERIAL SAFETY DATA SHEET DENACTIVE BRILL RED SPE


9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance- Odor Melting Point Boiling Point Vapor Density Percent Volatile Vapour Pressure Evaporation rate pH Solubility Specific Gravity Dark Red Powder odorless Not known Not known Not Known Not applicaple Not known Not applicable 4,0 6,0 at 30 g/l water > 100 g/l at 25C >0,45

Date of issue : 02.05.2012 Revision No: 0

10. STABILITY AND REACTIVITY


Stability Conditions to avoid Hazardous Decomposition Products Hazardous Polymerisation Incompatibility Stable at normal condition Avoid exposure to direct sunlight See section 5 Will not ocur Oxidizing materials

11. TOXICOLOGICAL INFORMATION


Acute Inhalation Effects: Eye effects Skin Effects Acute Oral effects Chronic effects/Carcinogenicity No data available but similar products have caused sensitization and irritation. Non-irritant based on rabbits testing according to EEC standards Non-irritant based on rabbits testing according to EEC standards The oral LD50 in rats is > 2000 mg/kg No data available. Not listed by IARC, NTP or OSHA

12. ECOLOGICAL INFORMATION


No data available

13. DISPOSAL CONSIDERATIONS


May be incinerated by adequate methods. Disposal in accordance with federal, state and local regulations. The owner of the material is responsible for proper waste disposal.

14. TRANSPORT INFORMATION

3/4

Document No: BUL.MSDS.66_en

MATERIAL SAFETY DATA SHEET DENACTIVE BRILL RED SPE


Not regulated.

Date of issue : 02.05.2012 Revision No: 0

15. REGULATORY INFORMATION


To the best of our knowledge the substance: is NOT listed on the black list 2455/2001/EG It does NOT require labeling with any R phrases;; R27, 29, 35, 39, 40, 45, 46, 48, 49, 50, 51, 52, 53, 59, 60, 62, 63, 68 R phrases R 22 Harmful if swallowed. R 36/38 Irritate eyes and skin. R 41 Causes dangerous and important irritation at eyes.

16. GENERAL INFORMATION


The information provided in this Material Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text.

4/4

You might also like