Scribd
Upload
26 views2 pages

Ho Taylor

The document discusses Taylor series expansions and approximations. It explains that Taylor series can be used to write any function as a polynomial approximation near a point by taking derivatives. Common Taylor series expansions are provided for sin(x), e^x, (1+x)^n, and log(1+x) near x=0. The document also discusses using the first-order Taylor approximation, called linearization, to approximate functions for small values of x near a point. It notes that higher-order terms may be needed to avoid over-approximating and losing important information about a function's behavior.

Uploaded by

lantea1
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
26 views2 pages

Ho Taylor

The document discusses Taylor series expansions and approximations. It explains that Taylor series can be used to write any function as a polynomial approximation near a point by taking derivatives. Common Taylor series expansions are provided for sin(x), e^x, (1+x)^n, and log(1+x) near x=0. The document also discusses using the first-order Taylor approximation, called linearization, to approximate functions for small values of x near a point. It notes that higher-order terms may be needed to avoid over-approximating and losing important information about a function's behavior.

Uploaded by

lantea1
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Taylor Series

The Taylor Series expansion of f (x) for points near x = a can be written: f (x) =
n=0

1 ( n) f (a) (x a)n n!

Expand through the rst few terms and take some derivatives. . . f (x) = f (a) + f (a) (xa) + 1 1 1 f (a) (xa)2 + f (a) (xa)3 + f (4) (a) (xa)4 + . . . 2! 3! 4!

f (x) = f (a) + f (a) (xa) +

1 1 1 f (a) (xa)2 + f (4) (a) (xa)3 + f (5) (a) (xa)4 + . . . 2! 3! 4! 1 (4) 1 1 f (x) = f (a) + f (a) (xa) + f (a) (xa)2 + f (5) (a) (xa)3 + f (6) (a) (xa)4 + . . . 2! 3! 4!

The nth derivative of the Taylor expansion for f (x) near x = a is the Taylor expansion of the nth derivative of f (x)! In the neighborhood of x = a, the Taylor expansion for f (x) reproduces the slope, curvature, and so on of f (x). Ultimately, this means that just about any function may be written as a polynomial using the Taylor Series - the major exceptions being functions that lack dierentiability at some order at x = a.

Common Expansions about x = 0


sin x = x cos x = 1 ex = 1 + x + x3 x5 x7 x9 + + ... 3! 5! 7! 9! x2 x4 x6 x8 + + ... 2! 4! 6! 8!

x2 x3 x4 x5 x6 + + + + + ... 2! 3! 4! 5! 6!

x2 x3 x4 x5 + + ... 2 3 4 5 1 1 (1 + x)n = 1 + nx + n(n 1)x2 + n(n 1)(n 2)x3 + . . . 2! 3! log (1 + x) = x

Approximations
Linearization
One linearizes a function by keeping the Taylor expansion terms up to rst-order in (x a). Because weve truncated the higher-order corrections, we wouldnt expect these approximations to be very good if we wandered too far away from x = a. The linearizations of those common functions near x = 0 ought to look real familiar. Keep in mind that theyre only valid for values of x near 0, which is to say for small values of x. sin x x cos x 1 ex 1 + x log (1 + x) x (1 + x)n 1 + nx

The Art of Approximation


There is a bit of an art to approximation. If the function you are trying to approximate vanishes, you have more-than-likely over-approximated, losing the very information you were seeking. Consider the following function (modeled after a combination you see in the discussion of quadrapoles) for small values of x: f (x) = 2 To rst-order in x, 1 1 f (x) 2 (1 + x) (1 x) 2 2 f (x) 0 Ok. We know f(x) is really, really small for small x. That doesnt tell me much. I can do better. As a general rule, keep enough terms to get a non-zero result. 1 3 1 3 f (x) 2 (1 + x + x2 ) (1 x + x2 ) 2 8 2 8 3 2 f (x) x 4 1 1 + 1x 1+x

You might also like