The Gsm/Gprs Modem USER'S Guide ME - TC35i/MC35i Terminal: 1.1 Scope of This Manual
The Gsm/Gprs Modem USER'S Guide ME - TC35i/MC35i Terminal: 1.1 Scope of This Manual
USERS Guide
ME_TC35i\MC35i Terminal
Contents
1 Introduction
1.1 Scope of this manual
1.2 Electrical characteristics
1.3 Mechanical characteristics
1.4 Features
1.4.1 Telephony
1.4.2 Short Message Service
1.4.3 Data
1.4.4 GSM Supplementary Service
1.4.5 Others
1.5 Interfaces
2 Hardware Description
2.1 Overview
2.2 The connector
2.3 Signal descriptions
2.3.1 Power supply
2.3.2 Serial link
2.4 Overview
2.5 Functional description
1 Introduction
The ME_TC35i\MC35i Terminal is designed to provide a quick and easy solution to systems that
need to access GSM/GPRS network/functionality. The modem is full type approved and ready to use.
It employs the proven GSM technology from SIEMENS.
1.1 Scope of this manual
Page 1 2005-2-16
This document describes the hardware interface and the technical specification of the
ME_TC35I\MC35I TERMINAL. For information about controlling the modem via the AT commands,
refer to the AT command manual.
1.2 Electrical characteristics
Dual band GSM modem E-GSM 900/1800 or E-GSM 900/1900
Class 4: 2W for GSM 900
Class 1: 1W for GSM 1800/1900
Voice, SMS, Fax and data
Tricodec: Full Rate, Enhanced Full Rate and Half Rate
3V SIM interface
Power supply: 5V @ 2A
300mA average current consumption
9mA in idle mode
Operating temperature: -20C to + 50C
Storage temperature: -35C to +85C
1.3 Mechanical characteristics
Small size: 100mm(L) x 53mm(W) x 25mm(H)
Mounting: 2 screw holes
1.4 Features
1.4.1 Telephony
Telephony (TCH/FS) and Emergency calls
Full Rate, Enhanced Full Rate and Half Rate
DTMF functions
1.4.2 Short Message Service
Point to Point MT and MO
SMS Cell Broadcast
1.4.3 Data
Data circuit asynchronous, transparent and non-transparent up to 14.4kbps
Automatic fax group 3 (Class 1 and 2)
Alternate speech and fax
MNP2, V.42bis
GPRS packet data features
GPRS class 8 / Class B
Coding schemes CS1 to CS4
Compliant with SMG31bis
1.4.4 GSM Supplementary Service
Call Forwarding
Call Barring
Multi Party
Call Waiting and Call Hold
Calling Line Identity
Advice of Charge
USSD
Page 2 2005-2-16
Closed User Group
Explicit Call Transfer
1.4.5 Others
ME + SIM phone book management
Fixed Dialling Number
SIM Toolkit Class 2
SIM, network and service provider locks
Real Time Clock
Alarm management
UCS2 character set management
1.5 I nterfaces
Single Antenna Interface
3V only internal SIM interface
RS232 Interface
2 Hardware Description
2.1 Overview
The ME_TC35I\MC35I TERMINAL includes a SIEMENS TC35i or MC35i module, a SIM card
holder , a DB15-pin header and a RF connector.
2.2 The connector
Signal description
2.2.1 Power supply:
Power supply design is an important factor. The GSM modem transmits in burst sequences, therefore
the power supply must be able to deliver high current peaks in short period of time.
Supply voltage = 5V ~12VDC the center pin is positive.
Supply current = 2 amperes.
2.2.2 Serial link
Type Type Type
1 DCD 6 RX 11 CTS
2 TX 7 DSR 12 RTS
3 NC 8 DTR 13 RI
4 MICROPHONE+ 9 GND 14 RESET
5 MICROPHONE- 10 SPEAKER+ 15 SPEAKER-
Page 3 2005-2-16