Scribd
Upload
1K views1 page

Readme 64bit

This document provides instructions for installing SolidCAM 2013 software and the USB-HASP-Emulator crack in 3 steps: 1. Install SolidCAM 2013 by downloading the ISO file and language localization files, then installing and overwriting files. 2. Install the USB-HASP-Emulator crack by copying files to C:, registering a dump file to add info to the Windows Registry, and using the Add Hardware tool to install uncertified drivers. 3. Upon successful setup, new devices will be visible in the Device Manager including the Virtual USB Bus Enumerator and SafNet HASP key.

Uploaded by

Adrian OnRoad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
1K views1 page

Readme 64bit

This document provides instructions for installing SolidCAM 2013 software and the USB-HASP-Emulator crack in 3 steps: 1. Install SolidCAM 2013 by downloading the ISO file and language localization files, then installing and overwriting files. 2. Install the USB-HASP-Emulator crack by copying files to C:, registering a dump file to add info to the Windows Registry, and using the Add Hardware tool to install uncertified drivers. 3. Upon successful setup, new devices will be visible in the Device Manager including the Virtual USB Bus Enumerator and SafNet HASP key.

Uploaded by

Adrian OnRoad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

1. SolidCAM 2013 64bit Setup 1.1. Download SolidCAM2013_SP0_English_64bit.

iso and one or more archives with l anguage localization needed from folder ..\Win64\Localizations\ 1.2. Install SolidCAM 2013 SP0 English 64bit 1.3. Unpack all folder from your localization archive to <SolidCAM 2013 progdir> (by default C:\Program Files\SolidCAM2013\) and overwrite original ones 2. USB-HASP-Emulator Setup ATTENTION! For SolidCAM 2013 SP0 you need to register new dump (solidcam2011_sp8_hf1_2012.r eg) and restart (for Win32) or reinstall (for Win64) USB-HASP-Emulator To install emulator you need Administrator rights! To install emulator for Win Vista or Win7 you need to boot computer in mofe F8 > Enable Enforcement Unsigned drivers! Moreover you need to use boot mode F8 > Enable Enforcement Unsigned drivers at e very reboot of computer! 2.1. Copy folder ..Win64\Crack\USB-Emul_Win64 to C: 2.2. Register dump (run "solidcam2011_sp8_hf1_2012.reg" and confirm to add info in Windows Registry) 2.3. Run Start -> Control Panel -> Add Hardware (Yes, I have already connected the hardware) -> Add a new hardware device -> Install the hardware that I manual ly select from a list -> Show all Devices -> Have disk -> Browse -> (browse to f older "USB-Emul_Win64") -> OK -> Confirm to install not certificated drivers if Windows ask for.. If setup is succesfull you have to see new devices: Device Manager -> System devices -> Virtual Usb Bus Enumerator Device Manager -> Universal Serial Bus controllers ->SafNet inc. HASP key Device Manager -> Universal Serial Bus controllers ->SafNet inc. USB key That's all Cracked by Team-SolidSQUAD (SSQ)

You might also like