GSM Mobile Termining Call Flow (GSM Mobile Terminated Call)

Highway Maryland GSM Fixed

Network EventHelix.com/EventStudio 2.5
GSM Mobiles Maryland Location Area Maryland GSM GSM Common PSTN
Equipment Equipment
GSM Other GSM Rockville Bethesda Maryland Maryland HLR GMSC PSTN 31-Aug-04 22:15 (Page 1)
Mobile Mobile Cell Cell BSC MSC VLR

How does a GSM mobile phone receive a call?

We have already seen that GSM mobiles keep the GSM network informed about their current location area. The knowledge of the location area
is not adequate for setting up a terminating call as the location area might spawn several cells.

In this call flow we will look at how a terminating call is handled in GSM. Setting up a terminating call is a two step process. (1) Interrogation
procedure to locate the subscriber (2) Actual call setup after the subscriber has been located.

http://www.EventHelix.com/RealtimeMantra/Telecom/GSM_network_example.htm

Copyright © 2000-2004 EventHelix.com Inc. All Rights Reserved.

Interrogation procedure

ISUP INITIAL ADDRESS MESSAGEA PSTN subscriber calls the

MSISDN mobile phone by dialing the
GSM phone number (MSISDN).
The PSTN will use the MSISDN
to locate the GMSC (Gateway
Mobile Switching Center) for the
service provider. Once the
GMSC has been identified, the
PSTN sends the ISUP Initial
Address Message to the GMSC.
MAP/C SEND ROUTING INFORMATION The GMSC requests routing
MSISDN information for the GSM
subscriber from the HLR (Home
Location Register).
Obtain the SS7 address of The HLR uses the dialed number
the MSC VLR currently to locate the HLR entry for the
serving the specified subscriber. The SS7 address for
MSISDN
the MSC VLR serving the
subscriber is obtained from this
record. (Recall that the SS7
address of the serving MSC VLR
was updated via an inter VLR
location update.)
MAP/D PROVIDE ROAMING NUMBER The HLR has identified that the
IMSI subscriber is currently being
served by the Maryland MSC
VLR. The HLR then asks the
MSC VLR to assign a temporary
roaming phone number to the
subscriber.
allocate The Maryland MSC VLR
MSRN allocates a temporary roaming
phone number (MSRN -Mobile
Station Roaming Number)
MAP/D PROVIDE ROAMING NUMBER RESULT The MSRN is then passed to the
MSRN HLR.

MAP/C SEND ROUTING INFORMATION RESULT HLR passes the MSRN to the
MSRN GMSC.

ISUP INITIAL ADDRESS MESSAGE The GMSC uses the MSRN to

MSRN route the call to the Maryland
MSC VLR.
free The Maryland MSC VLR receives
MSRN the call. At this point, the MSRN
is marked free and may be
reassigned for other calls. (This
GSM Mobile Termining Call Flow (GSM Mobile Terminated Call)
Highway Maryland GSM Fixed
Network EventHelix.com/EventStudio 2.5
GSM Mobiles Maryland Location Area Maryland GSM GSM Common PSTN
Equipment Equipment
GSM Other GSM Rockville Bethesda Maryland Maryland HLR GMSC PSTN 31-Aug-04 22:15 (Page 2)
Mobile Mobile Cell Cell BSC MSC VLR
is implementation dependent.)
BSSMAP PAGING Now the MSC VLR needs to
TMSI locate the subscriber in the
location area. Since the location
area might spawn several cells,
a paging mechanism is used to
locate the subscriber. The MSC
VLR uses a TMSI (Temporary
Mobile Subscriber Identify) to
address the mobile phone. The
TMSI is used so as to protect
the privacy of the called
subscriber. Note that, the
BSSMAP PAGING message will
be sent to all the BSCs that
handle the Maryland Location
Area.
RR PAGING REQUEST TYPE 3 The Maryland BSC receives the
TMSI page message. The BSC will
send the Page message to all
the cells that serve the
subscriber's location area.
RR PAGING REQUEST TYPE 3 All cells in the location area will
TMSI broadcast the Page message on
the Paging Channel (PCH). All
mobile phones listen to this
channel every few seconds. The
mobile is located in the Betheda
cell. It receives this page
message.
RR CHANNEL REQUEST The mobile finds that the TMSI
RACH specified in the page message
matches its own TMSI. The
mobile decides to respond to the
page. An RR connection
establishment is initiated by
sending a channel request to the
network.
RR CHANNEL REQUEST
RACH

RR IMMEDIATE ASSIGNMENT The network assigns a channel

AGCH to the terminal and sends the
assignment and time/frequency
corrections in the immediate
assignment message.
RR IMMEDIATE ASSIGNMENT
AGCH

RR SABM + RR PAGING RESPONSE The mobile tunes to the

assigned channel and transmits
the page response and the
SABM to initiate the RR session.
RR SABM + RR PAGING RESPONSE
SCCP CONNECTION REQUEST + RR PAGING RESPONSE The BSC sends a SCCP
connection request to the MSC
VLR. The page response
message is piggy backed with
the request.
 GSM Mobile Termining Call Flow (GSM Mobile Terminated Call)
Highway Maryland GSM Fixed
Network EventHelix.com/EventStudio 2.5
GSM Mobiles Maryland Location Area Maryland GSM GSM Common PSTN
Equipment Equipment
GSM Other GSM Rockville Bethesda Maryland Maryland HLR GMSC PSTN 31-Aug-04 22:15 (Page 3)
Mobile Mobile Cell Cell BSC MSC VLR
RR UA The BSC acknowledges the
SABM to establish the RR
connection. Note that UA
messages are used in the entire
session for acknowledging
packets. They will be omitted
here for clarity.
RR UA
Enable Ciphering

BSSMAP CIPHER MODE COMMAND The MSC initiates ciphering of

the data being sent on the
channel.
RR CIPHERING MODE COMMAND The BSC sends the CIPHERING
mode = CLEAR MODE COMMAND to the mobile.

RR CIPHERING MODE COMPLETE Ciphering has already been

mode = CIPHERED enabled, so this message is
transmitted with ciphering.
BSSMAP CIPHER MODE COMPLETE BSC replies back to the MSC,
indicating that ciphering has
been successfully enabled.
Call setup

CC SETUP The MSC VLR receives the page

response and sends a call setup
to the mobile.
CC CALL CONFIRMED The mobile acknowledges the
receipt of the setup by sending
the call confirmed message.
Ring Ring the subscriber.
CC ALERTING The mobile notifies the MSC that
the subscriber is being alerted.
ISUP ADDRESS COMPLETE MESSAGE The MSC receives the alert
indication and sends an ISUP
address complete message to
the GMSC.
ISUP ADDRESS COMPLETE MESSAGEThe GMSC sends the address
complete to the PSTN switch.
OK Button The subscriber answers the call
by hitting the "OK" button.
CC CONNECT Notify the MSC that the
subscriber has answered the
call.
ISUP ANSWER
ISUP ANSWER The call has now entered the
conversation phase.
Conversation phase

Call Release

LEG: Mobile initiates call

release
End Button The mobile subscriber hits End
to clear the call.
 GSM Mobile Termining Call Flow (GSM Mobile Terminated Call)
Highway Maryland GSM Fixed
Network EventHelix.com/EventStudio 2.5
GSM Mobiles Maryland Location Area Maryland GSM GSM Common PSTN
Equipment Equipment
GSM Other GSM Rockville Bethesda Maryland Maryland HLR GMSC PSTN 31-Aug-04 22:15 (Page 4)
Mobile Mobile Cell Cell BSC MSC VLR
CC DISCONNECT The mobile sends the
disconnect message to the MSC.
ISUP RELEASE The MSC initiates release on the
SS7 PSTN side.

Disconnect Voice Path The MSC disconnects the voice

path and also releases the voice
circuit between the BSC and the
MSC.
CC RELEASE The MSC informs the mobile
that it has initiated call release
ISUP RELEASED The MSC informs the PSTN that
SS7 the call release has been
completed.
ISUP RELEASE COMPLETE The PSTN informs that call
SS7 release has been completed at
its end.
CC RELEASE COMPLETE Mobile indicates that the call has
been released.
RR Connection Release

BSSMAP CLEAR COMMAND Call release has been completed,

now the RR connection is
released by the MSC.
RR CHANNEL RELEASE The BSC initiates RR release
with the mobile.
BSSMAP CLEAR COMPLETE The BSC informs the MSC that
the RR connection has been
released.
RR DISC The mobile sends a disconnect
message to release the LAPm
connection.
RR UA The BSC replies with an
Unnumbered Acknowledge
message.
Call Released Indication Mobile goes back to the default
display to indicate that call has
been completely released.