Scribd
Upload
1K views1 page

ANACOM 1 User Manual Modes

This document provides setup instructions for the ANACOM 1 device, including ensuring that switches and presets on the ANACOM 1/1 and ANACOM 1/2 boards are in specific initial positions for audio oscillator amplitude, audio input selection, balance, mode, output amplifier gain, transmitter output selection, audio volume, speaker status, and antenna position.

Uploaded by

zalmay
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
1K views1 page

ANACOM 1 User Manual Modes

This document provides setup instructions for the ANACOM 1 device, including ensuring that switches and presets on the ANACOM 1/1 and ANACOM 1/2 boards are in specific initial positions for audio oscillator amplitude, audio input selection, balance, mode, output amplifier gain, transmitter output selection, audio volume, speaker status, and antenna position.

Uploaded by

zalmay
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

ANACOM 1 User Manual

Ensure that the following initial conditions exist on the ANACOM 1/1 board:

(a)AUDIO OSCILLATOR'S AMPLITUDE preset in fully clockwise position;


(b)AUDIO INPUT SELECT switch in INT position;
(c)BALANCE preset in BALANCED MODULATOR & BANDPASS FILTER
CIRCUIT 1 block, in fully clockwise position;
(d)MODE switch in DSB position;
(e)OUTPUT AMPLIFIER'S GAIN preset in fully counter-clockwise position;
(f)TX OUTPUT SELECT switch in ANT. position;
(g) AUDIO AMPLIFIER'S VOLUME preset in fully counter-clockwise position;
(h) SPEAKER switch in ON position;
(i) On-board antenna in vertical position, and fully extended.

Ensure that the following initial conditions exist on the ANACOM 1/2 board:

(a)RX INPUT SELECT switch in ANT. position;


(b)R.F. AMPLIFIER'S TUNED CIRCUIT SELECT switch in INT position;
(c)R.F. AMPLIFIER'S GAIN preset in fully clockwise position;
(d)AGC switch in IN position;
(e)DETECTOR switch in DIODE position;
(f)AUDIO AMPLIFIER'S VOLUME preset in fully counterclockwise position;
(g)SPEAKER switch in ON position;
(h) BEAT FREQUENCY OSCILLATOR switch in OFF position;
(i) On-board antenna \n vertical position, and fully extended.

You might also like