Chrysler PT Cruiser 2001: Remote Start / Security / GPS
Chrysler PT Cruiser 2001: Remote Start / Security / GPS
COM
Chrysler PT Cruiser 2001
Installation type: Remote start / security / GPS
Wire/Function
PASSIVE ANTI-THEFT 12 VOLTS IGNITION ACCESSORY STARTER TACH LOCK UNLOCK DOORPIN TRUNK PIN FACTORY ARM FACTORY DISARM BRAKESWITCH PARKLIGHTS HAND BRAKE HORN CLUTCH SWITCH DRIVER WINDOW UP DRIVER WINDOW DOWN PASSENGER WINDOW UP PASSENGER WINDOW DOWN LEFT REAR WINDOW UP LEFT REAR WINDOW DOWN RIGHT REAR WINDOW UP RIGHT REAR WINDOW DOWN
Colour
YES Pink/black Blue Black/orange Yellow Black/gray White/green** White/green** See notes**** Tan/black White/green** White/green** White/tan*** Black/yellow Gray/black Black/red Yellow/red White Lt.blue Brown/lt.blue Violet/white Red/white Dk.blue/white Dk.green Gray
Location / Description
TRANSPONDER - SENTRY KEY Ignition switch harness Ignition switch harness Ignition switch harness Ignition switch harness At PCM under hood* Above driver's kickpanel** Above driver's kickpanel** White connector in driver's kickpanel White connector in driver's kickpanel Above driver's kickpanel** Above driver's kickpanel** In driver's kickpanel*** At steering column Front right side of shifter At steering column At switch above clutch pedal At window switch in center dash At window switch in center dash At window switch in center dash At window switch in center dash At switch in rear center console At switch in rear center console At switch in rear center console At switch in rear center console
Polarity
SEE NOTES + + + + AC + + TYPE 1 REV POL REV POL REV POL REV POL REV POL REV POL REV POL REV POL
Vehicle note:
PLEASE NOTE: A SENTRY-KEY immobilizer system may be present in the limited edition. This system is present when the vehicles ignition key is GRAY. Refer to the ALARM diagram before any remote start installation. * The PCM is located on the driver's side firewall under the hood. The BLACK/GRAY is found in the gray connector. ** This vehicle uses multiplexing where a single wire performs all lock and security functions, resistors are required. See the DOORLOCKS diagram for wiring details. *** It is recommended that you use the wire found in the driver's kickpanel and not the one at the brakeswitch itself. **** TAN (driver's door), BLUE/ORANGE or BLUE (all other doors). Both wires are found in a WHITE connector in the driver's kickpanel. door pin switch yellow/ at passenger kick panel this works for all doors.including rear door.......J>G>CS>
Installer note:
Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in any other way. The information supplied is a guide only. Copyright 1998-2001 Wiremagic.com Corporation. All rights reserved.
Page 1 of 1