Scribd Logo
Upload

Welcome to Scribd!

  • 167 views

    Why An Expansion Joint Works Part 2

    Uploaded by

    Seungmin Paek
    Why an expansion joint works II

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd

    Why An Expansion Joint Works Part 2

    Uploaded by

    Seungmin Paek
    167 views1 page
    Why an expansion joint works II

    Original Title

    Why an Expansion Joint Works Part 2

    Copyright

    © Attribution Non-Commercial (BY-NC)

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Why an expansion joint works II

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    167 views1 page

    Why An Expansion Joint Works Part 2

    Uploaded by

    Seungmin Paek
    Why an expansion joint works II

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    The bellows exposed Theres no mystery as to why a bellows can flex its convoluted for crying out loud.

    . This could be one short article. Except heres the tantalizing part; when the bellows material flexes, the stresses shoot well into the plastic range. At this point the collective mechanical engineering community gasps, women faint, dogs bark throughout the neighborhood. Deflection stresses The engineering schools taught us that if material yielded, it failed. Sure, exceptions were probably noted but it wasnt covered on the test and ergo it didnt exist. Take your typical metal beam. Bend it a little, let go, and it springs back. When it springs completely back its stress levels are said to be elastic. If bent too far it takes a permanent set; its stresses are inelastic or plastic. Static structures such as buildings, bridges, and pressure vessels are designed with stresses in the elastic range. Elastic is good. But inelastic is not necessarily bad, it can be our friend. When does the code say inelastic is OK? Consider our loaded beam again but modify the conditions to include a limit stop. Now when the beam permanently yields the load is not allowed to continue to deflect the beam. The beam can be pulled back and forth; each time the material exceeds its yield strength but does not break. There is a limit to this thumbing-its-nose-at-the-sacred-yieldstrength-rule behavior. After a certain number of cycles the part will develop fatigue cracks now it is considered failed. Equations have been developed to predict when this will happen. And testing, LOTS of testing, testing-until-you-wantto-puke testing has been performed to validate the equations. When expansion joints do finally come to the sunset of their lives it is rarely fatigue that finishes them off, but rather the steady and inevitable plodding of corrosion that makes all metal mortal.

    Sharing good company Metal bellows expansion joints do not stand alone in this special category. Many interested parties overlook that piping systems designed without expansion joints often operate with deflection stresses in the plastic range (more gasping, etc., etc.). Thats why they too, are designed by the code to have a finite cycle life. So most process piping systems have inelastic deflection stresses after all. Redesign the piping system with an expansion joint and the inelastic piping stresses fall into the elastic range. Sometimes its better to have the bellows flex than the piping.

    Next Month The liberating effect of tied universals The Bellows Bottom Line is a publication of Oakridge Bellows For expansion joint information Greg Perkins can be contacted at [email protected] or (830) 626-7773

    You might also like